Ubiquiti PowerBeam AC Gen2 Manuel utilisateur

PBE-5AC-Gen2 Quick Start Guide

https://dl.ubnt.com/qsg/PBE-5AC-Gen2/PBE-5AC-Gen2_EN.html[4/17/2020 8:58:22 AM]

Dish Reflector Antenna Feed Rear Housing

Mounting Bracket Hex Bolts with Washers (Qty. 4) Pole Clamp

Carriage Bolts (Qty. 2) Flange Nuts (Qty. 2) Gigabit PoE (24V, 0.5A) with Mounting Bracket

Power Cord

Package Contents

PBE-5AC-Gen2 Quick Start Guide

5 GHz High-Performance airMAX® AC Bridge

Model: PBE-5AC-Gen2

Table of Contents

Package Contents

Installation Requirements

Hardware Overview

Application Examples

Installation

Accessing airOS via Wi-Fi

Installer Compliance Responsibility

Specifications

Safety Notices

Electrical Safety Information

Limited Warranty

Compliance

Declaration of Conformity

Online Resources

PBE-5AC-Gen2 Quick Start Guide

https://dl.ubnt.com/qsg/PBE-5AC-Gen2/PBE-5AC-Gen2_EN.html[4/17/2020 8:58:22 AM]

Installation Requirements

13 mm wrench

Shielded Category 5 (or above) cabling with drain wire should be used for all wired Ethernet connections and should be grounded

through the AC ground of the PoE.

We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial-

grade, shielded Ethernet cable from Ubiquiti. For more details, visit ui.com/toughcable

Surge protection should be used for all outdoor installations. We recommend that you use two Ethernet Surge Protectors, model ETH-

SP, one near the PowerBeam and the other at the entry point to the building. The ETH-SP will absorb power surges and safely

discharge them into the ground.

Hardware Overview

Bottom View

PBE-5AC-Gen2 Quick Start Guide

https://dl.ubnt.com/qsg/PBE-5AC-Gen2/PBE-5AC-Gen2_EN.html[4/17/2020 8:58:22 AM]

Ethernet

Reset Button

Release Button

This Gigabit Ethernet port is used to connect the power and should be connected to the LAN and DHCP server.

To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on. Alternatively,

the device may be reset remotely via a Reset button located on the bottom of the Gigabit PoE Adapter.

After you assemble the PowerBeam, check the Release button; it should be fully engaged in the Release Button Slot of the Rear

Housing. This ensures that the Antenna Feed is locked into place. If you need to remove the Antenna Feed, you must depress the

Release button first.

LEDs

PBE-5AC-Gen2 Quick Start Guide

https://dl.ubnt.com/qsg/PBE-5AC-Gen2/PBE-5AC-Gen2_EN.html[4/17/2020 8:58:22 AM]

Signal

Ethernet

Power

In airOS®, you can modify the threshold value for the wireless signal strength LEDs on the Wireless tab under Signal LED Thresholds.

Each LED will light when the wireless signal strength is equal to or greater than the LED’s threshold value. The default threshold

values for these LEDs are shown below:

The Ethernet LED will light steady blue when an active Ethernet connection is made and flash when there is activity.

The Power LED will light blue when the device is connected to a power source.

Application Examples

The PowerBeam mounted outdoors with the Dish Reflector installed provides directional outdoor coverage (gain is reflector-dependent).

PBE-5AC-Gen2 Quick Start Guide

https://dl.ubnt.com/qsg/PBE-5AC-Gen2/PBE-5AC-Gen2_EN.html[4/17/2020 8:58:22 AM]

The PowerBeam mounted outdoors without the Dish Reflector installed provides outdoor-to-indoor coverage using the 3 dBi Antenna

Feed only.

Installation

PBE-5AC-Gen2 Quick Start Guide

https://dl.ubnt.com/qsg/PBE-5AC-Gen2/PBE-5AC-Gen2_EN.html[4/17/2020 8:58:22 AM]

PBE-5AC-Gen2 Quick Start Guide

https://dl.ubnt.com/qsg/PBE-5AC-Gen2/PBE-5AC-Gen2_EN.html[4/17/2020 8:58:22 AM]

Note: In high-wind environments, you can add support with additional hardware (not included):

PBE-5AC-Gen2 Quick Start Guide

https://dl.ubnt.com/qsg/PBE-5AC-Gen2/PBE-5AC-Gen2_EN.html[4/17/2020 8:58:22 AM]

a. Using the four holes in the Adjustment Bracket as a template, drill four holes into the Dish Reflector with a 4.4 mm or

11/64" drill bit.

b. Secure the Dish Reflector to the Adjustment Bracket using M4 screws, washers, and nuts (not included).

PBE-5AC-Gen2 Quick Start Guide

https://dl.ubnt.com/qsg/PBE-5AC-Gen2/PBE-5AC-Gen2_EN.html[4/17/2020 8:58:22 AM]

PBE-5AC-Gen2 Quick Start Guide

https://dl.ubnt.com/qsg/PBE-5AC-Gen2/PBE-5AC-Gen2_EN.html[4/17/2020 8:58:22 AM]

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Ubiquiti Matériel réseau

Ubiquiti

Ubiquiti UBB Manuel utilisateur

Ubiquiti

Ubiquiti UF-Instant Manuel utilisateur

Ubiquiti

Ubiquiti PowerBeam M5 Manuel utilisateur

Ubiquiti

Ubiquiti PowerBeam M PBE-M2-400 Manuel utilisateur

Ubiquiti

Ubiquiti RocketM Series Manuel utilisateur

Ubiquiti

Ubiquiti PBE-5AC-300-ISO Manuel utilisateur

Ubiquiti

Ubiquiti uFiber OLT 4 Manuel utilisateur

Ubiquiti

Ubiquiti NanoBeam airMAX NBE-M5-300 Manuel utilisateur

Ubiquiti

Ubiquiti NanoBeam M Manuel utilisateur

Ubiquiti

Ubiquiti airMAX PowerBridge M10 PBM10 Manuel utilisateur

Ubiquiti

Ubiquiti airMAX NanoStationM2 Manuel utilisateur

Ubiquiti

Ubiquiti UniFi USW-Flex-Mini Manuel utilisateur

Ubiquiti

Ubiquiti PowerBeam airMAX AC Gen2 PBE-5AC-Gen2 Manuel utilisateur

Ubiquiti

Ubiquiti UF-Instant Manuel utilisateur

Ubiquiti

Ubiquiti 0810354025402 Manuel utilisateur

Ubiquiti

Ubiquiti PBE-5AC-GEN2-5-EU Manuel utilisateur

Ubiquiti

Ubiquiti airMAX NanoBridge M NBM3 Manuel utilisateur

Ubiquiti

Ubiquiti ER-4 Manuel utilisateur

Ubiquiti

Ubiquiti UAP-AC-PRO Manuel utilisateur

Ubiquiti

Ubiquiti mPort-S mPort Serial Manuel utilisateur

Ubiquiti

Ubiquiti UF-AE Manuel utilisateur

Ubiquiti

Ubiquiti LiteBeam M5-23 Manuel utilisateur

Ubiquiti

Ubiquiti RD-3G26 Manuel utilisateur

Ubiquiti

Ubiquiti UFiber OLT Manuel utilisateur

Manuels Matériel réseau populaires d'autres marques

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manuel utilisateur

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manuel utilisateur

Yudor

Yudor YDS-16 Manuel utilisateur

D-Link

D-Link ShareCenter DNS-320L Manuel utilisateur

Samsung

Samsung ES1642dc Instructions d'utilisation

Honeywell Home

Honeywell Home LTEM-PV Instructions de montage

evertz

evertz 7700 Series Manuel utilisateur

D-Link

D-Link ShareCenter DNS-343 Manuel utilisateur

Asante

Asante AsanteBridge 1012 Manuel utilisateur

FireBrick

FireBrick FB2700 Manuel utilisateur

Audiovox Electronics

Audiovox Electronics ARWH2T Manuel utilisateur

ADC

ADC DSX-1 Manuel

NetComm

NetComm NF2 Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 5620 Manuel utilisateur

Dell EMC

Dell EMC XC6420 Series Manuel utilisateur

Lanner

Lanner NCA-1020A Manuel utilisateur

Allied Telesis

Allied Telesis AT-TN121-A Manuel utilisateur

Arista

Arista CCA-ETM-Q12 Manuel utilisateur