TRNDlabs SWIFT Manuel utilisateur
1
SWIFT
USER GUIDE
www.trndlabs.com
Welcome to the world of
TRNDlabs products!
TRNDlabs products are design focused electronics,
engineered to combine ulmate performance and
aesthecs.
www.trndlabs.com
4
Table of Contents
5
6
7
17
10
11
8
14
7
15
11
8
14
9
7
15
12
9
Parts Idencaon
Funcons
Photo & Video
Pairing
Pilong
Setup
Tips & Tricks
Safety Precauons
Setup App
Drone Funcons
Taking a Photo
Take-O & Land
Charging SWIFT
App Installaon
Direcon Trim
Replacing Rotor Blades
Rotaon Trim
FAQ
Calibraon
Rotor Protector Installaon
Controller Funcons
Recording a Video
Flight Controls
Controller Baery Installaon
Mobile Phone Holder Preparaon
5
21
30
26
21
31
26
28
26
29
27
27
32
32
25
22
Tips & Tricks
Safety Precauons
Troubleshoong
Sensivity Control
Addional Safety Precauons
Direcon Trim
Replacing Rotor Blades
Rotaon Trim
FAQ
Calibraon
Rotor Protector Installaon
Baery Safety Instrucons
FCC Compliance Informaon
(USA only)
Switching Modes
Advanced Flight: Performing
360º Flips
6
Parts Idencaon
SWIFT
Rotor Protectors (4x)
Replacement Rotor Blades (4x)
Controller
USB
Charging
Cable
7
Drone Funcons
Controller Funcons
Funcons
Drone Body
Rotor Blade
Camera
Rotor Protector
Take-O /
Land
Buon
Return Home
Buon
Speed/Stunt
Buon
Direcon
Forward/
Backward/
Sideways
Sideways Trim
Buons
Power Buon
Headless Mode
Buon
Throle/
Rotate
Video/Photo
Buon
Forward/Backward
Trim Buons
Power ON/OFF
Buon
8
Setup
Charging SWIFT
Connect the Charging Cable to a USB port 1 and the baery of the drone. 2
A LED light on the connector of the Charging Cable will indicate it is charging.
When the baery is fully charged, the LED light turns o. It takes about 60
minutes to recharge a discharged baery.
Slide the baery out of the drone by pulling it gently.
Make sure you only charge the rechargeable baery with the supplied
USB Charging Cable. If you try to charge the rechargeable baery
with a dierent baery charger, this might cause serious damage.
WARNING
2
2
1
9
Controller Baery Installaon
Slide the Mobile Phone Holder from
closed posion to open posion. You
can now place a mobile phone.
Mobile Phone Holder Preparaon
1 Open the Controller baery cover.
2 Install 2x 1.5V AAA baeries.
3 Slide the Controller baery cover back.
2 3
1
10
Pairing
Place the drone on a at and level surface.
1 Press the Power Buon for 2 seconds to switch the drone ON.
2 Push the Power Buon to turn on the Controller. The Green Indicator Light
on the Controller starts ashing slowly.
3The Drone will automacally connect to the Controller. Aer succesfull
binding the Controller will beep twice.
12
Table des matières
Autres manuels TRNDlabs Drone
