TRNDlabs FADER Manuel utilisateur
1
FADER
USER GUIDE
Welcome to the world of
TRNDlabs products!
TRNDlabs products are design focused electronics,
engineered to combine ulmate performance and
aesthecs.
Learn how to y!
TRNDlabs Drone Academy is a video plaorm where
you can get your drone up and running in minutes!
www.trndlabs.academy
www.trndlabs.com
4 5
Table of Contents
6
7
17
20
10
11
8
21
30
14
26
7
17
20
20
18
18
19
11
8
21
31
14
26
28
26
29
27
27
9
32
7
17
16
12
9
32
25
15
22
Parts Idencaon
Funcons
Photo & Video
VR & Preview Mode
Pairing
Pilong
Setup
Tips & Tricks
Safety Precauons
Setup App
Troubleshoong
Drone Funcons
Taking a Photo
Take-O & Land
Charging FADER
Sensivity Control
Addional Safety Precauons
App Installaon
Direcon Trim
Replacing Rotor Blades
Rotaon Trim
FAQ
Calibraon
Rotor Protector Installaon
Controller Funcons
Recording a Video
SD Card
Saving & Deleng
Photos/Videos
Playing Back Videos/
Viewing Photos
Back to Home
Flight Controls
Controller Baery Installaon
Baery Safety Instrucons
Connecng
Mobile Phone Holder Preparaon
FCC Compliance Informaon
(USA only)
Switching Modes
Advanced Flight: Performing
360º Flips
16
App Funcons
Show/Hide Buons
15
Switching VR Mode ON/OFF
720p Preview Mode
76
Parts Idencaon
Drone Funcons
Controller Funcons
Funcons
Drone Body
Rotor Blade
Power Switch
Charging Port
Camera
Rotor Protector
Power Switch
Mode Switch
Not in Use
Unlock/
Land/
Emergency Stop
(ULES Buon)
Direcon
Forward/
Backward/
Sideways
Sideways Trim
Mobile Phone Holder
Power Light Camera Light
Throle/
Rotate
Take Photo/
Record Video
FADER
Rotor Protectors (4x)
Replacement Rotor Blades (4x)
Controller
USB
Charging
Cable
Screwdriver
Forward/
Backward
Trim
Rotaon Trim
8 9
Setup
Charging FADER Controller Baery Installaon
Connect the Micro USB Charging Cable to a USB port 1 and the baery
of the drone. 2 A green LED light on the baery will indicate it is charging.
When the baery is fully charged, the LED light on the baery turns o. It
takes about 30 minutes to recharge a discharged baery.
Slide the baery out of the drone by pulling it gently.
Make sure you only charge the rechargeable baery with the supplied
USB Charging Cable. If you try to charge the rechargeable baery
with a dierent baery charger, this might cause serious damage.
WARNING
Slide the Mobile Phone Holder from
closed posion to open posion. You
can now place a mobile phone.
Mobile Phone Holder Preparaon
2
1 Open the Controller baery cover.
2 Install 4x 1.5V AAA baeries.
3 Slide the Controller baery cover back.
1
2
3
1
10 11
Pairing
Place the drone on a at and level surface.
1 Slide the Power Switch to turn on the Controller. The Red Indicator Light on
the Controller starts ashing slowly.
2 Press the Power Switch to switch the drone ON. The LED lights of the drone
starts ashing fast.
3 Push the Throle/Rotate sck to the full up posion, then to the full down
posion. The Red Indicator Light on the controller turns o and the LED
lights on the drone turn solid.
4 The drone is ready to y.
Pilong
1 Pushing the ULES Buon will cause the rotors of the drone to spin without
taking o.
2 To take o the drone push the Throle/Rotate buon. The drone will hover
at approximately 1.5 meter.
When ying, push the ULES Buon again to land the drone.
In case of an emergency, press and hold the ULES Buon for 3 seconds. This
will stop the rotors and cause the drone to fall out of the sky.
Take-O & Land
Throle Control
To y higher, push the Throle/Rotate sck cauously forward. To y lower, push
the Throle/Rotate sck cauously backward.
3
4
31 2
1
2
12 13
Flight Controls
Direcon Control
To y the drone forward or backward, push the Direcon sck cauously
forward or backward.
To y the drone to the le or the right, push the Direcon sck cauously to
the le or the right.
Rotaon Control
To make the drone circle to the le or the right, push the Throle/Rotate sck
cauously to the le or right.
14 15
Setup App
App Installaon
The App is suitable for mobile phones with iOS or Android. The App can be
downloaded from the App Store or Google Play.
Scan the QR code to download the App: TRNDlabs FADER
For mobile phones with
iOS, search TRNDlabs
FADER in the App
Store.
For mobile phones
with Android, search
TRNDlabs FADER in
Google Play.
Connecng
App Funcons
1Pair the drone and controller, see chapter “Pairing” (page 10)
2 Enter the sengs of your mobile phone and turn on the WiFi.
3 Select “FADER-XXXX” in the list of networks.
4 Go back and select the FADER App.
5 Tap on the FLY buon to enter the Live Video interface.
4
FADER
5
1Back to Home
2Take a Photo
3Record a Video
4 View Photos/Videos
5VR Mode
6 720p preview
7Help
8 Tap on screen to hide/show buons.
123456
8
7
16 17
Back to Home
Tap the back icon to return to the home screen.
Show/Hide Buons
Tap anywhere on the screen to hide the buons. Tap again to bring up the
buons again.
Photo & Video
Taking a Photo
Recording a Video
Tap the photo icon to take a photo. The icon will ash yellow momentarily, to
nofy a picture is taken. You can also take a picture with the Photo Buon on
the controller. Press the Photo Buon once to take a photo.
Tap the video icon to record a video. The icon will turn yellow when it’s
recording. Tap the icon again to stop recording, the icon will turn grey again.
You can also record a video by pressing the Video Buon on the controller for
3 seconds. Press the buon again for 3 seconds to stop recording.
18 19
Playing Back Videos/Viewing Photos
Saving & Deleng Photos/Videos
Tap the gallery icon to view photo and video galleries.
In the photo or video gallery tap the selecon icon 1 to enter selecon
mode.
Now select the le(s) you want to save to your phone’s gallery 2or delete
enrely 3 . Files that are saved show up in your phone’s gallery or camera roll.
The SD card is mounted at the boom
of FADER. You can remove the SD
card and connect it to your computer
via the microSD Card USB Reader.
You will nd the video and photo les
on the SD card. Make sure the drone
is turned o before extracng the SD
card from the drone.
When reinstalling the SD card, make
sure the drone is turned o and the
metal contacts on the SD card are
facing in the right direcon when
inserng the SD card. Now you can
safely turn on FADER and all new
photo and video les will be saved to
the installed SD card.
123
SD Card
Table des matières
Autres manuels TRNDlabs Drone
