Travis Industries Wilmington Face Manuel utilisateur

Small Flush Wood Wilmington Face

Installation Instructions 96300207

Page 1 of 4 17601808.docx — 9/23/13 © Travis Industries, Inc.

Compatibility

•Small Flush Wood Insert – Arched

Face Sizing

NOTE: The small flush wood insert may be installed with a face and no surround panel. The face is 30”

wide and 21.5” tall.

Packing List

•Wilmington Face

•Ashlip

•(2) ¼-20 x 1” Bolts

Attaching the Ashlip to the Face

1 Place the face a non-scratching surface (front side upwards). Take care to prevent damage to the

mounting brackets or the wiring from the rheostat. Before installing the ashlip, make sure the center

clip is slightly loose (when tightened, it will secure the center of the ashlip to the face).

2 Place the ashlip in position and secure using the two included bolts (7/16” wrench).

Make sure the center

clip is slightly loose.

Small Flush Wood Wilmington Face

Installation Instructions 96300207

Page 2 of 4 17601808.docx — 9/23/13 © Travis Industries, Inc.

3 Place the face upright. Position the center clip so it is snug against the ashlip. Tighten the two nuts

on back of the face to secure the center of the ashlip to the face (11/32” wrench).

Attaching the Face to the Insert

WARNING: Unplug or disable power to the appliance prior to attaching or removing the face.

1 Pull the air control and bypass out fully.

2 Unscrew the bypass rod from the bypass yoke (make sure to detach the handle and rod as one

piece). Unscrew the air control rod from the air control.

Small Flush Wood Wilmington Face

Installation Instructions 96300207

Page 3 of 4 17601808.docx — 9/23/13 © Travis Industries, Inc.

3 The power cord may be routed behind the surround panel or between the surround panel and face. If

routing between the surround panel and face, remove the knock-out along the bottom edge of the

face (knock-outs are provided on both sides – make sure to use the correct side). An additional

knock-out is provided for the optional GreenStart igniter (typically left side).

4 Place the face near the insert. Attach the two quick-connects from the rheostat to the two leads on

the insert (see illustration on the following page - wire orientation does not matter). When installing

the face, make sure to tuck excess wiring into the area to the side of the insert (behind the surround

panel, if applicable). If routing the power cord between the face and surround panel, make sure it

lines up correctly. All wiring must be kept away from any hot or moving components.

Power cord knock-out

(left or right side).

GreenStart igniter knock-out

(typically left side).

Small Flush Wood Wilmington Face

Installation Instructions 96300207

Page 4 of 4 17601808.docx — 9/23/13 © Travis Industries, Inc.

5 The face uses hooks to hang in place. Lift the face slightly and slide into place. Take care to prevent

damage to the wiring while installing. Re-attach the bypass and air control rod.

Make Sure the Face is Fully Engaged

Because the face hooks are concealed, it may be difficult to determine if the face is

fully engaged. When in place the face will slide behind the cast seal plate. See

the photo below.



Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Travis Industries Accessoires de cheminée

Travis Industries

Travis Industries 94700882 Manuel utilisateur

Travis Industries

Travis Industries 96100593 Manuel utilisateur

Travis Industries

Travis Industries 616 GSR Insert Manuel utilisateur

Travis Industries

Travis Industries 96100150 Manuel utilisateur

Travis Industries

Travis Industries 99300471 Manuel utilisateur

Travis Industries

Travis Industries 228-30035 Manuel utilisateur

Travis Industries

Travis Industries 96100212 Manuel utilisateur

Travis Industries

Travis Industries 95900388 Manuel utilisateur

Travis Industries

Travis Industries 95400424 Manuel utilisateur

Travis Industries

Travis Industries 1750 Manuel utilisateur

Travis Industries

Travis Industries 3615 HO GSR2 Cheat Sheet Manuel utilisateur

Travis Industries

Travis Industries GreenSmart DFC Instructions d'installation et d'utilisation

Travis Industries

Travis Industries DVS EG Firebacks Manuel utilisateur

Travis Industries

Travis Industries SKU 94400111 Manuel utilisateur

Travis Industries

Travis Industries Revolution 36CF Manuel utilisateur

Travis Industries

Travis Industries 98500701 Manuel utilisateur

Travis Industries

Travis Industries 864 ST GS Manuel utilisateur

Travis Industries

Travis Industries shield 6015 Manuel utilisateur

Travis Industries

Travis Industries 94700881 Manuel utilisateur

Travis Industries

Travis Industries PB36CF Manuel utilisateur

Travis Industries

Travis Industries 96100278 Manuel utilisateur

Travis Industries

Travis Industries 250-05727 Manuel utilisateur

Travis Industries

Travis Industries DVL GSR Manuel utilisateur

Travis Industries

Travis Industries 616 DF Manuel utilisateur

Manuels Accessoires de cheminée populaires d'autres marques

Valor

Valor L2 1700K Manuel utilisateur

Exodraft

Exodraft Xzense Manuel utilisateur

Whalen

Whalen Ruso MNFP62BF23-6 Manuel utilisateur

Lopi

Lopi Hearthview 864 Manuel utilisateur

Woodstock Soapstone

Woodstock Soapstone Fireview 201 Manuel utilisateur

EdilKamin

EdilKamin SERBATOIO 250 Guide de démarrage rapide

Bronpi

Bronpi KIT-1 Manuel utilisateur

Town & Country Fireplaces

Town & Country Fireplaces 22150051 Manuel utilisateur

Superior

Superior ASD3628-TI Manuel utilisateur

pleasant hearth

pleasant hearth OFP28WG Manuel utilisateur

IHP

IHP Astria Series Manuel utilisateur

Firegear

Firegear FG-H-2110SS Manuel utilisateur

Nibe

Nibe Contura C i31 Manuel utilisateur

kozy heat

kozy heat KZK-052 Manuel utilisateur

SimpliFire

SimpliFire SF-WM36 Manuel utilisateur

Bluegrass Living

Bluegrass Living BC18NR Guide de démarrage rapide

pleasant hearth

pleasant hearth IRIS SCROLL Manuel utilisateur

Cooke

Cooke Glass Wind Guard Manuel utilisateur