Travis Industries ProBuilder 36 Manuel utilisateur

ProBuilder 36/42 Ember-Glo Light Kit (MV / GSB2)

SKU# 94400897

Page 1 of 9 17602033 - Printed 8/28/18 © Travis Industries, Inc.

Compatibility

•ProBuilder 36CF

•ProBuilder 42CF

Packing List

•Light Assembly with Wire Leads & Seal Plate

•Power Harness

•Rheostat Assembly

•(2) 8-32 KEPS nuts (use 11/32” nut driver)

•(4) Halogen Bulbs

•Molex Dummy Plug (used only on MV

appliances without a blower)

•Ember Glass

•(1) can of paint

•(2) 8-32 X 3/8” screws

Tools Required

•11/32” Nut Driver/Wrench

•1/4” Nut Driver/Wrench

ProBuilder 36/42 Ember-Glo Light Kit (MV / GSB2)

SKU# 94400897

Page 2 of 9 17602033 - Printed 8/28/18 © Travis Industries, Inc.

Installation Notes

Install The Blower First

The blower is installed at the back of the fireplace. If using, we recommend installing it first so its installation does not

interfere with the light wiring.

WARNING: Disable power to the fireplace while installing the lights (disable the service breaker). Do not

activate power to the fireplace until the light kit is fully installed and grounded.

Do not connect 110-120 VAC to the gas control valve or wiring system of this appliance.

Installation

1. Disable power to the fireplace (turn the service breaker off).

2. Remove the screen and glass frame (see manual for details).

3. Carefully remove the logs and embers (if applicable).

4. Remove the media tray skirt.

5. Remove the media tray. Remove the two screws that secure the media tray to the front of the grate

assembly. Remove the tray and keep the screws for reinstallation (see below).

ProBuilder 36/42 Ember-Glo Light Kit (MV / GSB2)

SKU# 94400897

Page 3 of 9 17602033 - Printed 8/28/18 © Travis Industries, Inc.

6. Remove the cover plate on the right side of the firebox floor (Discard the cover plate. Keep the screws for

reinstallation). Leave the gasket it place.

7. Pass the light assembly wires through the hole (and gasket) uncovered in the previous step. Secure the

attached seal plate to the firebox floor using the two screws removed in step 7 (see below). Once installed,

remove all excess wiring inside the firebox by pulling the wires from below.

8. Possition the light assembly in front of the grate assembly (see photo below).

Remove Cover – Leave gasket

Seal Plate

ProBuilder 36/42 Ember-Glo Light Kit (MV / GSB2)

SKU# 94400897

Page 4 of 9 17602033 - Printed 8/28/18 © Travis Industries, Inc.

9. Allign the (2) holes in the back of the light assembly with the (2) LOWER holes on the front of the grate

assembly. Secure the assembly to the burner housing using the included screws.

10. Install the (4) bulbs into the sockets by gently inserting the bulbs pins into the holes on the socket.

NOTE: .Take care not to touch the replacement bulbs with your fingers. Residue (oil,etc.) left on the bulb will

reduce the bulb’s life span. Use foam packing or paper towel to hold the bulb when installing.

ProBuilder 36/42 Ember-Glo Light Kit (MV / GSB2)

SKU# 94400897

Page 5 of 9 17602033 - Printed 8/28/18 © Travis Industries, Inc.

11. Reinstall the media tray and skirt.

12. Locate the “Power In” wires connected to the junction box on the right side of the firelace. The wires are

white and have large white Molex connectors at the end.Connect the male Molex connecter, on the

harness included with this kit, to the Molex connector labeled “Lights”.

13. Connect the wires from the light assembly to the wires labeled “lights” on the light assembly wire harness.

ProBuilder 36/42 Ember-Glo Light Kit (MV / GSB2)

SKU# 94400897

Page 6 of 9 17602033 - Printed 8/28/18 © Travis Industries, Inc.

14. Disconnect the dashboard from the fireplace (4 screws hold it in place) and place it face down in front of

the fireplace.

NOTE:The rheostat shown in the picture above operates the blower. If a blower is not being installed on your

fireplace, the blower rheostat will not be present on the dashboard.

15. Place the rheostat assembly onto the studs on the right side of the dashboard and secure using the 2

nuts included with the kit. Use an 11/32” nut driver to tighten the nuts.

NOTE: The bracket on the rheostat must face upwards so the control wheel fits through the slot on the dashboard

(see pictures below).

ProBuilder 36/42 Ember-Glo Light Kit (MV / GSB2)

SKU# 94400897

Page 7 of 9 17602033 - Printed 8/28/18 © Travis Industries, Inc.

16. Connect the two wires from the rheostat to the wires labeled “rheostat” on the wire harness

(polarity does not matter).

17. Reinstall the dashboard onto the fireplace.

18. Install the logs (see installation manual for details).

Ember Glass Installation

•Make sure the media tray skirt is in place. The skirt hooks over the front of the ember platform and slopes

outward toward the glass. The skirt helps keep the glass and ember material from falling off the platform

when the glass is removed.

•Locate the perforations in front of the log grate.

•Place a thick layer of the ember glass over the perforations making sure to cover all of the holes

completely.

ProBuilder 36/42 Ember-Glo Light Kit (MV / GSB2)

SKU# 94400897

Page 8 of 9 17602033 - Printed 8/28/18 © Travis Industries, Inc.

•Lightly fog the ember glass with the black touch-up paint provided. Check the appearance with the lights

on and add additional paint, as needed, for a realistic glowing ember appearance.

NOTE: If power is supplied to the fireplace, it can be helpful to turn the lights on while painting so you can

determine an appropriate amount of paint for a realistic ember appearance.

NOTE: We recommend that you use a piece of paper, cardboard as a shield to mask the log grate and burner

from overspray (see below).

Ember Material Installation

•Once the ember glass installation is complete, place a generous amount of ember material on the firebox

floor on either side of the firebox. Completely cover any visible metal on the firebox floor.

NOTE: Make sure no ember material is placed directly on the burner. Apply rockwool as needed for realistic ember

appearance.

HINT: Add a few randomly placed ember chunks over the ember bed glass to produce a more realistic appearance.

Rock Wool Placement

The included rock wool is placed on top of the burner to enhance the glow from the burner. The rock wool works

best when it is applied in a very thin layer. The best method for applying the rock wool is to brush it on to the

burner. Compress a clump of rockwool between your thumb and forefinger. Use a stiff brush to apply a thin layer

of rockwool fibers onto the burner. Do not use the entire bag of rockwool. Use only a small amount and save the

remainder. Over-use of rockwool will diminish the glow and may cause sooting or other adverse conditions.

ProBuilder 36/42 Ember-Glo Light Kit (MV / GSB2)

SKU# 94400897

Page 9 of 9 17602033 - Printed 8/28/18 © Travis Industries, Inc.

Bulb Replacement

•Remove the screen and glass assemblies (see appliance manual for details).

•Remove the media tray skirt (see step 4).

NOTE: Take care not to disturb the ember bed media on the media tray when removing and replacing the media

tray skirt.

•The bulbs are now visible. Grasp the bulb with your thumb and forefinger and gently pull the bulb straight

out of the socket.

•Install the replacement bulbs into the sockets by gently inserting the bulbs pins into the holes on the

socket..

NOTE: .Take care not to touch the replacement bulbs with your fingers. Residue (oil,etc.) left on the bulb will

reduce the bulbs life span. Use foam packing or paper towel to hold the bulb when installing.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Travis Industries Accessoires de cheminée

Travis Industries

Travis Industries Rosario DVS Face Manuel utilisateur

Travis Industries

Travis Industries 99300471 Manuel utilisateur

Travis Industries

Travis Industries Illuminations 4915 Manuel utilisateur

Travis Industries

Travis Industries 228-30035 Manuel utilisateur

Travis Industries

Travis Industries 96100212 Manuel utilisateur

Travis Industries

Travis Industries 95100055 Manuel utilisateur

Travis Industries

Travis Industries DVL EmberGlo GSR2 Insert Manuel utilisateur

Travis Industries

Travis Industries 96400717 Manuel utilisateur

Travis Industries

Travis Industries 98500677 Manuel utilisateur

Travis Industries

Travis Industries Fireplace Xtrordinair 96300770 Manuel utilisateur

Travis Industries

Travis Industries shield 6015 Manuel utilisateur

Travis Industries

Travis Industries Answer Manuel utilisateur

Travis Industries

Travis Industries 95400424 Manuel utilisateur

Travis Industries

Travis Industries shield 6015 Manuel utilisateur

Travis Industries

Travis Industries Illuminations 4915 Manuel utilisateur

Travis Industries

Travis Industries 250-00128 Manuel utilisateur

Travis Industries

Travis Industries Wilmington Face Manuel utilisateur

Travis Industries

Travis Industries 864 40K Manuel utilisateur

Travis Industries

Travis Industries 250-05727 Manuel utilisateur

Travis Industries

Travis Industries Olympic Manuel utilisateur

Travis Industries

Travis Industries 95900388 Manuel utilisateur

Travis Industries

Travis Industries 94700881 Manuel utilisateur

Travis Industries

Travis Industries 91500565 Manuel utilisateur

Travis Industries

Travis Industries 96100794 Manuel utilisateur

Manuels Accessoires de cheminée populaires d'autres marques

Valor

Valor L2 1700K Manuel utilisateur

Exodraft

Exodraft Xzense Manuel utilisateur

Whalen

Whalen Ruso MNFP62BF23-6 Manuel utilisateur

Lopi

Lopi Hearthview 864 Manuel utilisateur

Woodstock Soapstone

Woodstock Soapstone Fireview 201 Manuel utilisateur

EdilKamin

EdilKamin SERBATOIO 250 Guide de démarrage rapide

Bronpi

Bronpi KIT-1 Manuel utilisateur

Town & Country Fireplaces

Town & Country Fireplaces 22150051 Manuel utilisateur

Superior

Superior ASD3628-TI Manuel utilisateur

pleasant hearth

pleasant hearth OFP28WG Manuel utilisateur

IHP

IHP Astria Series Manuel utilisateur

Firegear

Firegear FG-H-2110SS Manuel utilisateur

Nibe

Nibe Contura C i31 Manuel utilisateur

kozy heat

kozy heat KZK-052 Manuel utilisateur

SimpliFire

SimpliFire SF-WM36 Manuel utilisateur

Bluegrass Living

Bluegrass Living BC18NR Guide de démarrage rapide

pleasant hearth

pleasant hearth IRIS SCROLL Manuel utilisateur

Cooke

Cooke Glass Wind Guard Manuel utilisateur