Transition Networks C/F-SM-MM-04(LH) Manuel utilisateur

COMPLIANCE INFORMATION

UL Listed

C-UL Listed (Canada)

CISPR/EN55022 Class A

FCC Regulations

This equipment has been tested and found to comply with the limits for a class A digital device, pursuant

to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference, in which case the user will be

required to correct the interference at the user’s own expense.

Canadian Regulations

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on

the radio interference regulations of the Canadian Department of Communications.

Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables

aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique

édicté par le ministère des Communications du Canada.

European Regulations

Warning

This is a Class A product. In a domestic environment this product may cause radio interference in which

case the user may be required to take adequate measures.

Achtung !

Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses Gerätes

Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende Gegenmaßnahmen

werantwortlich ist.

Attention !

Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des

interférences radioélectriques, il appartiendra alors à l’utilsateur de prende les measures spécifiques

appropriées

Trademark Notice

All registered trademarks and trademarks are the property of their respective owners.

graphic, electronic, or mechanical – without written permission from TRANSITION Networks.

Printed in the U.S.A. 33045.E

TRANSITION Networks C/F-SM-MM-04 series media converters, designed to be

installed in the TRANSITION Networks E-MCC-1600 Media Converter Chassis,

connect 850nm(SX) and 1300nm(LX) fiber in the full-duplex or half-duplex gigabit

(1000Mb/s ) Ethernet™ environment.

NOTE: In conformance with the

IEEE 802.3z standard, the 1300nm

singlemode fiber-optic connector

also can be used with 1300nm

multimode fiber-optic cable.

850nm/1300nm Gigabit Fiber

Slide-In-Module Media Converters

C/F-SM-MM-04, C/F-SM-MM-04(LH), C/F-SM-MM-04(LW)

USER’S GUIDE

Power Modules

Media

Conversion

Center

Power

In Use

Power

In Use

Management

Module

Power

Link

C/F-SM-MM-04

Provides an RX (receive) and TX

(transmit) SC connector to 850 nm

multimode fiber-optic cable and an RX

(receive) and TX (transmit) SC

connector to 1300 nm singlemode or

1300 nm multimode fiber-optic cable

C/F-SM-MM-04(LH) (long haul)

Provides an RX (receive) and TX

(transmit) SC connector to 850 nm

multimode fiber-optic cable and an RX

(receive) and TX (transmit) SC

connector to 1310 nm singlemode

fiber-optic cable

C/F-SM-MM-04(LW) (long wave)

Provides an RX (receive) and TX

(transmit) SC connector to 850 nm

multimode fiber-optic cable and an RX

(receive) and TX (transmit) SC

connector to 1550 nm singlemode

fiber-optic cable

C/F-SM-MM-04 in the Network . . . . .2

Installation . . . . . . . . . . . . . . . . . . . .3

Operation . . . . . . . . . . . . . . . . . . . . .4

Fault Isolation and Correction . . . . .5

Cable Specifications . . . . . . . . . . . . .6

Technical Specifications . . . . . . . . . .7

Compliance Information . . . . . . . . . .8

C/F-SM-MM-04 IN THE NETWORK

NOTE: This product is NOT a repeater. Therefore, maximum distances depend on

specific characteristics of the installation. The full distances of BOTH singlemode

and multimode fiber MAY NOT be supported in the same installation.

TECHNICAL SPECIFICATIONS

Standards IEEE 802.3u

Case Dimensions 4.75" x 3.0" x 1.0" (119mm x 76mm x 25mm)

Shipping Weight 3 pounds (1.4 kilograms)

Environment Temperature: 0-40°C (32° to 104° F )

Humidity 10-90%, non condensing

Altitude 0-10,000 feet

Warranty Lifetime

DECLARATION OF CONFORMITY

Name of Mfg: Transition Networks

6475 City West Parkway, Minneapolis MN 55344 USA

Model: C/F-SM-MM-04 Series Media Converters

Part Number(s): C/F-SM-MM-04,C/F-SM-MM-04(LH), C/F-SM-MM-04(LW)

Regulation: EMC Directive 89/336/EEC

Purpose: To declare that the C/F-SM-MM-04 to which this declaration refers is

in conformity with the following standards.

EMC-CISPR 22: 1985 Class A; EN 55022: 1988 Class A; EN 50082-1:1992;

EN 60950 A4:1997; IEC 801.2, IEC 801.3, and IEC 801.4; IEC 950

I, the undersigned, hereby declare that the equipment specified above conforms to the

above Directive(s) and Standard(s).

_January 1, 1997_____

Stephen Anderson, Vice-President of Engineering Date

1300nm Fiber

850nm Fiber

1300nm Fiber

850nm Fiber

CABLE SPECIFICATIONS

The physical characteristics of the media cable must meet or exceed IEEE 802.3 specifications.

Gigabit Fiber Specifications

Bit error rate: ≤10-12

1300 NANOMETER (LX)

Fiber Optic Cable Recommended: 9 µm singlemode fiber

Fiber Optic Cable Recommended: 62.5 / 125 µm multimode fiber

Optional: 50 / 125 µm multimode fiber

C/F-SM-MM-04

Wavelength 1300 nm

Fiber-optic Transmitter Power: min: -13.0 dBm max: -3.0 dBm

Fiber-optic Receiver Sensitivity: min: -20.0 dBm max: -3.0 dBm

(singlemode)

Minimum* Cable Distance: 2 meters

Typical Maximum* Cable Distance: 10 kilometers

(multimode)

Minimum* Cable Distance: 2 meters

Typical Maximum* Cable Distance: 550 meters**

C/F-SM-MM-04(LH) (long haul) (singlemode)

Wavelength 1310 nm

Fiber-optic Transmitter Power: min: -5.0 dBm max: -0.0 dBm

Fiber-optic Receiver Sensitivity: min: -20.0 dBm max: -3.0 dBm

Optical Budget 15.0 dB

Spectral Width 5.9 nm FWHM

Minimum Attenuation 3 dB

Typical Maximum* Cable Distance: 27 kilometers

C/F-SM-MM-04(LW) (long wave) (singlemode)

Wavelength 1550 nm

Fiber-optic Transmitter Power: min: -3.0 dBm max: -2.0 dBm

Fiber-optic Receiver Sensitivity: min: -23.0 dBm max: -3.0 dBm

Optical Budget 20.0 dB

Spectral Width 2.3 nm FWHM

Minimum Attenuation 5 dB

Typical Maximum* Cable Distance: 27 kilometers

850 NANOMETER (SX)

Fiber Optic Cable Recommended: 62.5 / 125 µm multimode fiber

Optional: 50 / 125 µm multimode fiber

Fiber Optic Transmitter Power: min: -19.0 dBm max: -14.0 dBm

Fiber Optic Receiver Sensitivity: min: -32.5 dBm max: -14.0 dBm

Minimum Cable Distance : 2 meters

Typical Maximum* Cable Distance: 220 meters for 160/500MHz•Km

270 meters for 200/500MHz•Km

*Actual distance dependent upon physical characteristics of network installation.

**Patchcord per IEEE 802.3 1998 edition specification may be required for

1300nm multimode cable.

INSTALLATION

Install Slide-In-Module in E-MCC-1600 Chassis

• Remove Media Converter Slide-in-Module protective plate from selected

installation slot by removing two (2) screw that secures plate to front of

E-MCC-1600.

• Carefully slide Media Converter Slide-in-Module into installation slot,

aligning Media Converter Slide-in-Module with installation guides.

NOTE: Ensure that the Media Converter Slide-in-Module is firmly seated

against backplane.

• Secure Slide-in-Module by installing panel fastener screw attached to

Slide-in-Module.

Install Cable

NOTE: Be sure to connect correct speed fiber cable at each connector.

• Locate or build 802.3 compliant fiber cable with male two-stranded TX

to RX connectors appropriate to the media converter installed at both

ends.

• Connect male TX and RX cable connectors at one end of cable to TX

and RX female connectors, respectively, on media converter.

• Connect male TX and RX cable connectors at other end of cable to RX

and TX connectors of 802.3 compliant fiber device.

OPERATION

After installation, the media converter should function without operator

intervention.

Status LEDs

Use the status LEDs to monitor media converter operation in the network.

P(o)w(e)r Illuminated green LED indicates connection to external AC

power.

Link Steady green LED indicates that fiber link is connected

properly.

FAULT ISOLATION and CORRECTION

If the media converter fails, isolate and correct the failure by determining the

answers to the following questions and then taking the indicated action:

1. Is the power LED on the media converter illuminated?

NO • Is the power adapter the proper type of voltage and cycle frequency

for your AC outlet? NOTE: Refer to the “Power Supply

Requirements” on the back page.

• Is the power adapter properly installed in the media converter and

in the outlet?

• Contact Technical Support at (800) 260-1312/ (800) LAN-WANS.

YES • Proceed to step 2.

2. Is the multimode fiber Link LED illuminated?

NO • Check fiber cables for proper connection.

• Verify that TX and RX cables on media converter are connected to

RX and TX ports, respectively, on the other device.

• Power-cycle the media converter.

• Refer to Tech Tips available at: http://www.transition.com

• Contact Technical Support at (800) 260-1312/ (800) LAN-WANS.

YES • Proceed to step 3.

3. Is the singlemode fiber Link LED illuminated?

NO • Check fiber cables for proper connection.

• Verify that TX and RX cables on media converter are connected to

RX and TX ports, respectively, on the other device.

• Power-cycle the media converter.

• Refer to Tech Tips available at: http://www.transition.com

YES • Contact Technical Support at (800) 260-1312/ (800) LAN-WANS.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Transition Networks Convertisseur de média

Transition Networks

Transition Networks S3290 Manuel utilisateur

Transition Networks

Transition Networks SAPTF33 series Manuel utilisateur

Transition Networks

Transition Networks E-100BTX-FX-05 Manuel utilisateur

Transition Networks

Transition Networks E-100BTX-FX-05(LC) Manuel utilisateur

Transition Networks

Transition Networks E-TEL-1200 Manuel utilisateur

Transition Networks

Transition Networks CFMFF1314-280 Manuel utilisateur

Transition Networks

Transition Networks HSTR-CF-01(SC) Manuel utilisateur

Transition Networks

Transition Networks SFMFF4040-100 Manuel utilisateur

Transition Networks

Transition Networks ARCNET C/AR-CF-02(SC) Manuel utilisateur

Transition Networks

Transition Networks CEMTF1011-100 Manuel utilisateur

Transition Networks

Transition Networks SBFTF10 1 Series Manuel utilisateur

Transition Networks

Transition Networks E-CX-FRL-03 Manuel utilisateur

Transition Networks

Transition Networks SRS2F3111-100 Manuel utilisateur

Transition Networks

Transition Networks SISTF1011-110-LR Manuel utilisateur

Transition Networks

Transition Networks E-100BTX-FX-N-02 Manuel utilisateur

Transition Networks

Transition Networks CDFTF1111-100 Manuel utilisateur

Transition Networks

Transition Networks C/E-PSW-FX-03(LH) Manuel utilisateur

Transition Networks

Transition Networks SGPOE10 1 Series Manuel utilisateur

Transition Networks

Transition Networks SPS-1872-CC Manuel utilisateur

Transition Networks

Transition Networks CGFEB1xxx-15x Manuel utilisateur

Transition Networks

Transition Networks CGFEB1013-100 Manuel utilisateur

Transition Networks

Transition Networks SWITCHABLE ETHERNET AND FAST ETHERNET... Manuel utilisateur

Transition Networks

Transition Networks CDFTF 10 Series Manuel utilisateur

Transition Networks

Transition Networks SPOEB10 105 Series Manuel utilisateur

Manuels Convertisseur de média populaires d'autres marques

SoundTraxx

SoundTraxx Blunami BLU-2200 Manuel utilisateur

SPROLINK

SPROLINK VA1 Manuel utilisateur

Acclaim Lighting

Acclaim Lighting DDC-1-AC Manuel utilisateur

Nikon

Nikon AF-S TC-20E III Manuel utilisateur

Axis

Axis AXIS Q7406 Manuel utilisateur

Omega

Omega TAC80B-J Manuel utilisateur

Zoom

Zoom Thunderbolt TAC-2R Manuel utilisateur

OST

OST iConverter 10/100M Manuel utilisateur

Vertiv

Vertiv Netsure Manuel utilisateur

birddog

birddog MINI Manuel utilisateur

Roland

Roland GI-10 Manuel utilisateur

Wallenstein

Wallenstein WX310 Manuel utilisateur

Pace

Pace MSS 200-1 Manuel utilisateur

Solar Converters

Solar Converters EQ 12/24-50 Manuel utilisateur

CYP

CYP EL-7400V Manuel utilisateur

TIE

TIE MIDI 1i1o Manuel utilisateur

DCS

DCS Vivaldi Upsampler Manuel utilisateur

Westermo

Westermo MCW-211 SERIES Manuel utilisateur