Chapter 2: SAFETY
2.1 Safety
To ensure safe operations this manual must be carefully read and understood before installing and
operating the product. Installation must be made by authorized and educated personnel and
according to the local laws and regulations. Failure to follow these instructions may cause death,
serious injuries and material damages.
User
The following details must be considered for all handling of the system.
lHydra products must not be operated without access to the manual, the technical doc-
umentation and needed safety training. The purchaser of this Hydra has been instructed how
to handle the system safely.
lAllow only licensed or qualified personnel to install the product.
lAllow only qualified personnel to have access to the transmitter and operate the equipment.
lMake sure that the user follows the instructions.
lMake sure that the user satisfies the age requirements in your country for operating the equip-
ment.
lMake sure that the user is not under the influence of drugs, alcohol or medications.
lMake sure that the user does not leave the transmitter unsupervised.
lMake sure that the user always switches the transmitter off when it is not in use.
lMake sure that the user has a clear view of the work area at all times. The work area must be
free from obstacles and the user must be sure of his/her footing.
lThe user may not use broken products.
lThe user may not change any configurations without proper training.
lThe user may not remove any labels from the product.
lThe user may not use the product when the battery is low.
Installing, connecting and mounting
When installing, connecting and mounting the following must be considered at all times.
lWrite down the serial numbers/ID codes of the receivers and transmitters used.
lAllow only licensed or qualified personnel to install the product.
lAlways switch off the power supply to the receiver before connecting the equipment.
lCheck that the power supply is connected to the correct connection terminal.
lTo utilize the safety of the system, use the stop relays in the safety circuitry of the object
that you want to control
5
