SWELLPRO GC2-S Manuel utilisateur
GC2-S
User Guide
Visit www.swellpro.com to download the latest version of the manual and firmware.
V1.0 –2021.3
2©2021 SwellPro
Thank you
The GC2-S is a waterproof low-light 2-axis gimbal camera designed for SplashDrone 4 to gain visual footage in
a low-light environment. The GC2-S comes with a dimmable LED light that allows use even in complete
darkness. The high-sensitivity sensor of the GC2-S provides full-color images in a low-light environment when
normal cameras cannot return an image.
Using this manual
This document is designed to be printed or viewed on a computer or mobile device.
Tutorial videos
To watch tutorial videos or download the firmware, please visit SwellPro website www.swellpro.com
4©2021 SwellPro
Precaution
●The GC2-S is a piece of precision electronics with corrosion-resistant materials which allow for use in
harsh marine environments. As with any marine equipment, trouble-free and lasting operations depend
on proper attention and maintenance of the equipment.
●When taking off or landing, slowly proceed to avoid damage to the gimbal camera which can cause by
the huge impact when contacting the surface at high speeds. Drop or crash directly into the water from
above will result in significant damage to the drone and the gimbal camera.
●After using in seawater, soak and rinse thoroughly with clean fresh water before the seawater dries out.
●If seawater or other sediments form on the gimbal camera, soak thoroughly with fresh water and clean
all sediments on the camera and motor before use. For more information, check the drone’s
“Maintenance manual”.
Installation
Install the Gimbal
1. Unscrew and take off the gimbal port cover plate using a hex
screwdriver. (equipped with SplashDrone 4)
2. Plug the gimbal connector into the drone’s gimbal port and screw
it in place with a screwdriver.
⚠Make sure the rubber ring is attached to the gimbal connector
before you screw the connector.
3. Aline the holes on the base of the gimbal to the bottom of the
drone, screw in to mount the gimbal. Make sure the camera is
pointing to the front of the drone.
©2021 SwellPro 5
Install SD Card
1. Open the soft rubber seal on the top of the camera, insert the Mirco
SD card in the correct direction, press the Mirco SD card, the "click"
sound indicates that the installation is in place.
2. After installing the Mirco SD card, plug the rubber seal back.
⚠Make sure the rubber seal is tightly plugged in to ensure
waterproofing.
●The GC1-S supports Mirco SD cards with a maximum capacity of 128GB. Since the camera requires fast
reading and writing of high-stream video data, please use Mirco SD cards with Class 10 or UHS-1 or
above to ensure proper functioning.
●Do not insert or unplug the Mirco SD card during aircraft shooting, as data files may be damaged or
lost.
●Once you are done recording, stop recording and save the file. If you turn off the power directly
before saving the files, the recording file will be lost.
After Use Casing
After using the gimbal camera, you can choose not to take off the gimbal camera and put it directly into
the case with the drone. Follow the following steps to make sure the gimbal camera is properly secure
after casing.
1. Remove the double-side-glued pad from the gimbal box and paste
the pad into the drone’s case as showing to the left.
2. After cleaning and drying the gimbal camera and the aircraft, secure
the gimbal camera with the fixing case, then put the aircraft and other
parts into the case. The case is secure and ready to be carried or
transported.
Control
Gimbal Control
Remote controller[1]
Description
6©2021 SwellPro
[2]
Tilt: Toggle the right gimbal control as shown to turn the gimbal up or
down from 0 to -90 degrees.
Dimmable LED light control: Toggle the left gimbal control to adjust
the dimmable LED light. (Dimmable LED light works the best when the
aircraft is 15 meters away from the subject.)
Camera control
Remote controller
Description
Video: press once to start recording, press again to stop recording,
and save files.
Photo: press once to take a picture.
APP Interface
To get into APP’s camera interface: Power on the remote controller, then the aircraft. Connect the phone to
the remote controller’s Wi-Fi hotspot. Then click "Login device".
©2021 SwellPro 7
Login device
Camera Interface
8©2021 SwellPro
Photo Setting Interface
Video Setting Interface
©2021 SwellPro 9
Camera Setting Interface
Playback Interface
Specification
Gimbal
Waterproof rating:
IP67
10 ©2021 SwellPro
Stabilization:
2-axis (tilt, roll).
Controllable range:
Tilt: -90° to 0°
Max control speed:
Tilt: 60 °/s
Weight:
About 145 g
Size:
71*55*65mm
Camera
Sensors:
1/2" 2M CMOS
Lens:
FOV: 92.6°
Photo size:
4:3/16:9 12MP
Burst mode:
3/5/10 shoots
Interval shot:
1/3/5/10 s
Video resolution:
FHD：1920*1080 30/60p | HD：1280*720 120/60p
Max data stream:
64 MBps
Photo format:
JPEG
Video format:
MP4，MOV
Memory card:
Micro SD card: supports up to 128GB of capacity, write speeds ≥ 60
MB/s, and transfer speed rating of Class 10 or above, or with UHS-1
rating.
Working temperature:
-10°C - 40°C
Autres manuels pour GC2-S
1
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels SWELLPRO Drone
SWELLPRO
SWELLPRO spry Manuel utilisateur
SWELLPRO
SWELLPRO SWIFT 2 Manuel utilisateur
SWELLPRO
SWELLPRO Splash Drone 3 Manuel utilisateur
SWELLPRO
SWELLPRO Splash Drone 3 Manuel utilisateur
SWELLPRO
SWELLPRO Fisherman FD3 Manuel utilisateur
SWELLPRO
SWELLPRO SPLASH DRONE Manuel utilisateur
SWELLPRO
SWELLPRO JCMATTHEW D1 Manuel utilisateur
SWELLPRO
SWELLPRO spry Manuel utilisateur
SWELLPRO
SWELLPRO SPLASH DRONE Manuel utilisateur
SWELLPRO
SWELLPRO Splashdrone Fisherman FD1 Manuel utilisateur
SWELLPRO
SWELLPRO Splash Drone Pro Manuel utilisateur
SWELLPRO
SWELLPRO Fisherman Manuel utilisateur
SWELLPRO
SWELLPRO SPLASH DRONE Manuel utilisateur
SWELLPRO
SWELLPRO SplashDrone 4 WQMS Manuel utilisateur
SWELLPRO
SWELLPRO Splash Drone 3 Mode d’emploi
SWELLPRO
SWELLPRO spry Manuel d'utilisation et d'entretien
SWELLPRO
SWELLPRO Splash Drone PR Manuel utilisateur
SWELLPRO
SWELLPRO JCMatthew FD1 Manuel utilisateur
SWELLPRO
SWELLPRO SplashDrone 4 Manuel utilisateur
SWELLPRO
SWELLPRO SplashDrone 4 Manuel utilisateur
