page 2
STRESSVEST INC.
1080 Kingsbury Avenue • Winnipeg, Manitoba, Canada R2P 1W5
Toll Free: 1-866-353-5055 • Ph: (204) 336-0011 • Fax: (204) 586-2049 • info@stressvest.com
CONNECTING THE STRESSVEST® TRANSMITTER TO THE PANEL VEST
SHOCK/VIBRATOR PLACEMENT
1. Open up the StressVest® Transmitter storage aps located at the bottom
rear of Panel Vest. Slide the StressVest® Transmitter under the elastic
holding straps and secure with the horizontal bungee cord.
2. Carefully attach the Panel Vest connector to the vest connection input
located on the top, left hand side of the Transmitter.
3. Push down until the connection locks into position. Be sure the pins are
properly lined up prior to pressing it down onto the Transmitter.
1. Press the Select Button on the StressX™ PRO until the
Mode LED Indicator is illuminated. Press the Up & Down
Arrows to move to the desired Mode. The mode number is
displayed in the LED Display.
2. Press the Select Button on the StressX™ PRO until the
Level LED Indicator is illuminated. Press the Up & Down
Arrows to move to the desired Shock Level. The Shock
Level is displayed in the LED Display.
IMPORTANT!
• The StressX™ PRO Belt should be placed directly on the abdomen above the belt.
• The belt MUST be tightened securely to ensure proper contact with the electrodes.
• It is designed to go through one layer of clothing.
• Wearing an under armour type shirt will dramatically reduce the energy delivered by the StressX™
PRO Belt.
IMPORTANT! Please read Section 1.0 Warnings, Cautions and Risks of Manual before using the StressVest®.
SETTING TRAINING MODES & SHOCK LEVEL
There are 12 Advanced Training Modes and 5 Shock Levels (1-Low to 5-High) that the StressX™ PRO can be set to.
They are shown on a card inside the ap
that covers the Transmitter on the back of the StressVest® (shown on right).
CONTACT MAY CAUSE
ELECTRICAL SHOCK
OR BURN.
THIS UNIT TO BE
SERVICED BY TRAINED
PERSONNEL ONLY.
HIGH VOLTAGE
ELECTRIC
SHOCK RISK
StressX™ PRO - Advanced Training Modes
ROLE PLAYER MODES
(Ensure Controller Switch is Set to Vibrate)
1 - Vibrates every hit.
2 - Vibrates after two hits
3 - Vibrates after three hits
MOVE TO COVER MODES
(Pain Penalty Increases with Each
Subsequent Hit)
6 - Vibrates 1st hit, 2nd begins shock
7 - Shocks 1st at Low then increases
8 - Shocks 1st at Med then increases
STRESS EXPOSURE MODES
(Set Appropriate Shock Level for Student)
4 - Shocks every hit.
5 - Vibrates 1st hit, then shocks
INJURED OFFICER MODES
(Shock Continues to Fire Randomly for Set
Time Period After First Hit)
9 - Shocks randomly - 10 seconds
10 - Shocks randomly - 20 seconds
11 - Shocks randomly - 30 seconds
12 - Vibrates randomly - 30 seconds
