StarTech.com ST4200USBM Manuel utilisateur
ST4200USBM
Mountable USB 2.0 Metal Hub
4 Ports
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and receiver.•
Connect the equipment into an outlet on a circuit different from that to which the receiver•
is connected.
Consult the dealer or an experienced radio/TV technician for help.•
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other protected
names and/or symbols of third-party companies not related in any way to StarTech.com. Where
they occur these references are for illustrative purposes only and do not represent an endorse-
ment of a product or service by StarTech.com, or an endorsement of the product(s) to which
this manual applies by the third-party company in question. Regardless of any direct acknowl-
edgement elsewhere in the body of this document, StarTech.com hereby acknowledges that all
trademarks, registered trademarks, service marks, and other protected names and/or symbols
contained in this manual and related documents are the property of their respective holders.
Instruction Manual
i
Instruction Manual
Table of Contents
Introduction ................................................................................... 1
Features ......................................................................................1
Package Contents .......................................................................1
Connector Layout .......................................................................... 2
Hardware Installation .................................................................... 3
Checking the Hub Installation ...................................................... 4
Environmental Specifications ...................................................... 4
Technical Support ......................................................................... 5
Warranty Information .................................................................... 5
Instruction Manual
1
Introduction
Thank you for purchasing a StarTech.com ST4200USBM High-Speed
4-Port USB2.0 hub. This ruggedly built hub is ideal for industrial environ-
ments and can be wall-mounted or installed onto a DIN rail for convenient
access to the ports. This four port industrial hub can be bus-powered or
self powered, with a three wire terminal block connector (7-24V).
Features
Choice of Bus Power and/or External Terminal Block Power•
Compact space saving and mountable design (mount on a wall or DIN•
rail)
Maximum data transfer rate of up to 480 Mbps and backwards com•
patible with USB 1.1
Includes a 2 meter USB cable for quick and easy installations•
Package Contents
1 x USB 2.0 Hub•
1 x User’s Manual•
1 x 2m USB A-B cable•
Instruction Manual
2
Connector Layout
Activity LEDs for Downstream Ports: These 4 LED indicators will blink
whenever the USB ports are transferring data.
Upstream Port Connector: Type-B USB connector for upstream USB
connection.
Self-Power Input Connectors: 3-Pin terminal block connectors used to
connect the hub to an available power source. The voltage can be in the
range of +7V to 24VDC.
WARNING: Ensure that the polarity of the input power is correctly
matched to that of the terminal block pins. Otherwise, it may damage the
hub.
Power LED
Upstream Port
Connector
Downstream Port
Connectors
Self Power Input
Connectors
Activity LEDs for
Downstream Ports
Instruction Manual
3
Hardware Installation
Use static electricity discharge precautions1.
Eliminate the potential for static discharge from any objects that the hub
may come in contact with before the installation. This can be accom-
plished by touching a bare metal chassis rail after you have turned off the
power.
Apply DC power to the 3-pin Terminal Block Connector2.
The terminal block connector adds power to ensure there is enough to
run the 4 downstream USB ports.
Connect the USB host cable3.
The host cable is a standard A-to-B USB2.0 cable. Connect the type-A
connector to the upstream USB port being used, then connect the type-B
connector to the USB hub. Since the hub is plug and play, it can be con-
nected while the host computer is powered on.
Connect the USB devices to the downstream ports of the hub.4.
Mount the hub on the wall or DIN RAIL if required.5.
Instruction Manual
4
Checking the Hub Installation
To check the USB hub installation in Windows Device Manager, follow
these steps:
Click Start1.
Click Control Panel2.
Click System3.
Click Device Manager4.
Double click Universal Serial Bus Controller5.
Double click Generic USB HUB6.
The message should show that the device is working properly7.
Environmental Specications
Operating temperature: 0 to 55°C (32 to 131°F)
Operating humidity: 5 to 95% RH
Dimensions (LxWxH) 4.50”(L)x2.26”(W)x1.03”(H)
(11.45x5.73x2.63 cm)
Instruction Manual
5
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commit-
ment to provide industry-leading solutions. If you ever need help with your
product, visit www.startech.com/support and access our comprehensive
selection of online tools, documentation, and downloads.
Warranty Information
This product is backed by a one year warranty. In addition, StarTech.
com warrants its products against defects in materials and workman-
ship for the periods noted, following the initial date of purchase. During
this period, the products may be returned for repair, or replacement with
equivalent products at our discretion. The warranty covers parts and labor
costs only. StarTech.com does not warrant its products from defects or
damages arising from misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA
LLP (or their officers, directors, employees or agents) for any damages
(whether direct or indirect, special, punitive, incidental, consequential, or
otherwise), loss of profits, loss of business, or any pecuniary loss, arising
out of or related to the use of the product exceed the actual price paid
for the product. Some states do not allow the exclusion or limitation of
incidental or consequential damages. If such laws apply, the limitations or
exclusions contained in this statement may not apply to you.
StarTech.com has been making “hard-to-find easy” since 1985,
providing high quality solutions to a diverse IT and A/V customer
base that spans many channels, including government, education
and industrial facilities to name just a few. We offer an unmatched
selection of computer parts, cables, A/V products, KVM and Serv-
er Management solutions, serving a worldwide market through our
locations in the United States, Canada, the United Kingdom and
Taiwan.
Visit www.startech.com today for complete information about all
our products and to access exclusive interactive tools such as the
Cable Finder, Parts Finder and the KVM Reference Guide.
Autres manuels pour ST4200USBM
1
Table des matières
Autres manuels StarTech.com Changer
StarTech.com
StarTech.com PCM815SHNA Manuel utilisateur
StarTech.com
StarTech.com USB221SS Manuel utilisateur
StarTech.com
StarTech.com SV231QDVIUA Manuel utilisateur
StarTech.com
StarTech.com STARVIEW SV431DUSB Manuel utilisateur
StarTech.com
StarTech.com SV231DVIUDDM Manuel utilisateur
StarTech.com
StarTech.com ST3300G3UA Manuel utilisateur
StarTech.com
StarTech.com 8 Port StarView CAT5 UTP KVM Manuel utilisateur
StarTech.com
StarTech.com STARVIEW SV1631DUSB Manuel utilisateur
StarTech.com
StarTech.com MSTCDP122HD Manuel utilisateur
StarTech.com
StarTech.com 8STICUSB23216FD Manuel utilisateur
StarTech.com
StarTech.com ST122VGA Manuel utilisateur
StarTech.com
StarTech.com DS252 Manuel du système
StarTech.com
StarTech.com RACKCONS17HD Manuel utilisateur
StarTech.com
StarTech.com U01043-USB-EXTENDER Manuel utilisateur
StarTech.com
StarTech.com SV831HD Manuel
StarTech.com
StarTech.com 8STMSTMDP124DP Manuel utilisateur
StarTech.com
StarTech.com SV231DDVDUA Manuel utilisateur
StarTech.com
StarTech.com SV215MICDVIA Manuel utilisateur
StarTech.com
StarTech.com SV431DD2DUA Manuel utilisateur
StarTech.com
StarTech.com ST4200USB Manuel
