StarTech.com SAT3520U2ER Manuel utilisateur
SAT3520U2ER
SAT3520U2ERGB
InfoSafe eSATA/USB 2.0 Dual
3.5” SATA Drive Enclosure
with RAID
Instruction Manual
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and receiver.•
Connect the equipment into an outlet on a circuit different from that to which the receiver•
is connected.
Consult the dealer or an experienced radio/TV technician for help.•
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and
do not represent an endorsement of a product or service by StarTech.com, or an en-
dorsement of the product(s) to which this manual applies by the third-party company in
question. Regardless of any direct acknowledgement elsewhere in the body of this doc-
ument, StarTech.com hereby acknowledges that all trademarks, registered trademarks,
service marks, and other protected names and/or symbols contained in this manual and
related documents are the property of their respective holders.
Instruction Manual
i
Instruction Manual
Table of Contents
Introduction .................................................................... 1
Features ......................................................................................1
Package Contents .......................................................................1
Hardware Guide............................................................... 2
Front View....................................................................................2
Rear View ....................................................................................2
Installation....................................................................... 3
Installing Drives in the Enclosure ................................................3
Connecting SAT3520U2ER to the Host Computer......................5
Partitioning Installed Drives.........................................................5
Software Operation Guide.............................................. 8
Software Installation Guide..........................................................8
Using the SteelVine Manager......................................................9
Changing the RAID Mode Using the GUI....................................9
RAID Mode Overview ..................................................................11
Specifications.................................................................. 14
Technical Support........................................................... 15
Warranty Information...................................................... 15
Instruction Manual
1
Introduction
Thank you for purchasing a StarTech.com InfoSafe eSATA/USB 2.0
Dual 3.5” SATA Hard Drive Enclosure with RAID. This versatile storage
solution allows easy installation of two 3.5” SATA I/II hard drives of up to
1.5TB capacity (each), for a total capacity of up to 3Tb, and maximizes
performance capabilities with support for a broad range of RAID applica-
tions including RAID 0, RAID 1, and Concatenated (BIG mode).
Features
Rear panel power and fan on/off switches•
Easy configuration using dip switches or GUI•
Hard drive power and activity LEDs•
Supports data transfer speeds of up to 3Gbps (eSATA) and 480Mbps•
(USB 2.0)
RAID can be used with both eSATA or USB 2.0 connection•
Supports RAID 0(Striping or Fast), RAID 1(Mirroring or Safe),•
BIG(Spanning or Concatenation), SAFE33/55 and JBOD Modes
Built-in 50mm cooling fan•
Package Contents
1 x Aluminum Enclosure•
1 x eSATA Cable•
1 x Instruction Manual•
1 x Software and Drivers Installation CD•
1 x Plastic Stand•
1 x Power Adapter•
1 x Screw Kit•
1 x USB Cable•
Instruction Manual
2
Hardware Guide
Front View
Power LED1.
HDD-1 LED2.
HDD-2 LED3.
Rear View
Fan1.
eSATA Connector2.
Power Switch3.
Power Adapter Socket4.
Fan Switch5.
USB Connector6.
1
2
3
1
2
3
4
5
6
Instruction Manual
3
Installation
Installing Drives in the Enclosure
Remove the screws holding the rear panel1.
in place, then slide the rear panel out from
the enclosure.
Place the first 3.5” SATA hard drive into2.
the tray, then slide it forward until the drive
interface is firmly connected to the SATA
connector on the SAT3520U2ER/
SAT3520U2ERGB. Repeat this step with
the second 3.5” SATA hard drive, using the
remaining tray.
If you are connecting the SAT3520U2ER to a host computer using an
eSATA port, please note that in order to utilize some of the RAID function-
ality offered by the enclosure, the eSATA port to which the drive enclosure
is connected must provide a SATA port multiplier. If the eSATA port
does not offer a port multiplier, only one of the two installed drives will be
accessible.
Please see the table on the following page for further details.
Instruction Manual
4
Secure the drives to the Enclosure tray,3.
using the provided screws.
Select the operating mode for your hard drive using the DIP Switches4.
shown below. Once you have set the DIP switches according to the
desired RAID mode, press the Reset Button to save changes.
DIP Switches
Reset Button
DIP Switches
(GUI mode is shown)
DIP Switch No.
RAID Mode 1 2 3 4
GUI** (Requires Software Installation) ON ON ON OFF
JBOD* ON OFF OFF OFF
BIG OFF OFF OFF OFF
RAID 0 (Fast)* OFF ON OFF OFF
RAID 1 (Safe) ON ON OFF OFF
RAID/SAFE33* OFF OFF ON OFF
RAID/SAFE55* ON OFF ON OFF
*denotes Port Multiplier requirement
** Please see pg. 11 for more details on GUI Mode
Instruction Manual
5
Replace the Enclosure tray (with drives5.
attached) into the Enclosure.
Secure the Enclosure tray within the Enclosure, using the screws6.
removed in step 1.
Connecting SAT3520U2ER to the Host Computer
Once the hard drives have been installed within the Enclosure and the
necessary dipswitch settings have been made:
Connect the power adapter (included) to the power adapter socket1.
on the rear panel of SAT3520U2ER. Connect the remaining end of the
power adapter to an available power outlet.
Connect SAT3520U2ER to the host computer using either an eSATA or2.
USB cable (both included).
Partitioning Installed Drives
Once the necessary connection (either eSATA or USB) has been made to
the host computer, from the host computer operating system:
Right-click on the1. My Computer icon and select Manage.
Instruction Manual
6
In the left pane of the Computer Management window, select2. Device
Manager. The installed hard drives will appear as “unallocated”, in the
bottom half of the right pane.
Right-click the Disk you wish to use and select3. Initialize Disk.
Click4. OK to initialize the disk.
Instruction Manual
7
The disk should now be shown as “Online.” Right-click on the5.
unallocated block and select New Partition.
The6. New Partition Wizard will appear. Follow the on-screen
instructions to complete the creation of the new partition. When the
partition has been created, the hard drive should appear as “New
Volume.”
Repeat steps 1-6 to partition the second hard drive.7.
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels StarTech.com Enceinte
StarTech.com
StarTech.com IDE3510U2GB Manuel utilisateur
StarTech.com
StarTech.com S2510U2WF Manuel utilisateur
StarTech.com
StarTech.com S3520WU33ER Manuel du système
StarTech.com
StarTech.com SAT3520UERGB Manuel utilisateur
StarTech.com
StarTech.com S252BU313R Manuel utilisateur
StarTech.com
StarTech.com RK1232WALHM Manuel utilisateur
StarTech.com
StarTech.com M2E1BMU31C Manuel utilisateur
StarTech.com
StarTech.com SAT3540U2E Manuel utilisateur
StarTech.com
StarTech.com S352BU313R Manuel utilisateur
StarTech.com
StarTech.com SAT3520U3SR Manuel du système
StarTech.com
StarTech.com SW-3023 Manuel utilisateur
StarTech.com
StarTech.com RK1820WALHM Manuel utilisateur
StarTech.com
StarTech.com SAT3540U3ER Manuel du système
StarTech.com
StarTech.com 2636CABINET Manuel utilisateur
StarTech.com
StarTech.com SAT3510U2V Manuel utilisateur
StarTech.com
StarTech.com INFOSAFE SAT2510U2 Manuel utilisateur
StarTech.com
StarTech.com S355BU33ERM Manuel utilisateur
StarTech.com
StarTech.com INFOSAFE SAT2510BU2 Manuel utilisateur
StarTech.com
StarTech.com SAT3540ER2 Manuel utilisateur
StarTech.com
StarTech.com SLSODDU33B Manuel utilisateur
