Recycle
Always return your used electronic products,
batteries, and packaging materials to dedicated
collection points. This way you help prevent
uncontrolled waste disposal and promote the
recycling of materials.
The crossed-out wheeled-bin symbol on
your product, battery, literature, or packaging
reminds you that all electrical and electronic
products and batteries must be taken to separate
collection at the end of their working life. This
requirement applies in the European Union. Do not
dispose of these products as unsorted municipal
waste: take them for recycling. For more information
on your nearest recycling point, please check with
your local waste authority.
Regulatory and Other Notices
ST008 / SportIQ Smart Tag:
FCC ID: 2ACY5ST8
IC: 12258A-ST8
Model: ST008
Made in China
A product that contains the ST008 / SportIQ Smart
Tag will have a permanent label affixed to it that
shows “Contains FCC ID: 2ACY5ST8” and
“Contains IC: 12258A-ST8” according to FCC & IC
labeling requirements.
FCC
Federal Communication Commission Interference
Statement
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment
and receiver.
● Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV
technician for help.
FCC Caution:
Any changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Important Note:
Radiation Exposure Statement
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
portable and mobile exposure host.
This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Important Note:
The modular will only installed into non-metallic, DC
or battery powered product like installed into
basketball or non-metallic, DC or battery powered
sports equipment. Non-metallic, DC or battery
powered sports equipment of the host device which
install this modular with limit modular approval
should perform the test of radiated emission and
spurious emission according to FCC part 15.247
and FCC part 15.209 requirement, only if the test
result comply with FCC part 15.247 and FCC part
15.209 requirement, then the host can be sold
legally.
End Product Labeling
This transmitter module is authorized for use
portable and mobile exposure. The final end product
must be labeled in a visible area with the following:
Contains FCC ID: 2ACY5ST8.
Manual Information to the End User
The OEM integrator has to be aware not to provide
information to the end user regarding how to install
or remove this RF module in the user’s manual of
the end product which integrates this module.
The end user manual shall include all required
regulatory information/warning as show in this
manual.
