Ricoh FT4480 Guide de démarrage rapide
FT4480
FIELD SERVICE MANUAL
RICOH COMPANY, LTD.
15 MARCH 1987
1.
2.
3.
4.
5.
TABLE OF CONTENTS
INSTALLATION
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
ENVIRONMENT
MACHINE LEVEL
MINIMUM SPACE REQUIREMENT
POWER REQUIREMENT
COPIER INSTALLATION
COLOR DEVELOPMENT UNIT INSTALLATION
KEY COUNTER HOLDER INSTALLATION
A3/11’’x17” COUNTER INSTALLATION
CASSETTE MODIFICATION
MODIFYING MAIN TRANSFER VOLTAGE
PREPARATION FOR TRANSPORTING THE COPIER
SERVICE TABLE
PM TABLE
SERVICE TABLES
SERVICE REMARKS
SPECIAL TOOLS AND LUBRICATIONS
REPLACEMENT AND ADJUSTMENT
1. OPTICS
2. DEVELOPMENT AND TONER SUPPLY
3. CLEANING
4. QUENCHING
5. PAPER FEED
6. FUSING
7. TRANSPORT
8. CORONA
9. OTHERS
10. COPY IMAGE
ELECTRICAL DATA
SCHEMATICS
TIMING CHARTS
DOCUMENT FEEDER
1. UNPACKING AND INSTALLATION
2. REPLACEMENT AND ADJUSTMENT
1- 1
1- 2
1- 2
1- 3
1- 4
1-12
1-15
1-16
1-17
1-18
1-19
2- 1
2- 3
2-14
2-20
3- 1
3-16
3-25
3-33
3-34
3-54
3-64
3-67
3-77
3-80
4- 1
4- 2
5- 1
5- 9
15 MARCH 1987
6. SORTER
1. UNPACKING AND INSTALLATION
2. REPLACEMENT AND ADJUSTMENT
7. LARGE CAPACITY TRAY
1. UNPACKING AND ADJUSTMENT
2. REPLACEMENT AND ADJUSTMENT
8. EDITOR BOARD
1. UNPACKING AND INSTALLATION
9. TROUBLESHOOTING
1. COPY QUALITY
2. SERVICE CALL CONDITIONS
3. DEFECTIVE SENSOR TABLE
6- 1
6- 5
7- 1
7- 7
8- 1
9- 1
9-19
9-30
SECTION 1
INSTALLATION
15 MARCH 1987
CONTENTS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
ENVIRONMENT
MACHINE LEVEL
MINIMUM SPACE REQUIREMENT
POWER REQUIREMENT
COPIER INSTALLATION
ACCESSORY CHECK
INSTALLATION PROCEDURE
COLOR DEVELOPMENT UNIT INSTALLATION
ACCESSORY CHECK
INSTALLATION PROCEDURE
KEY COUNTER HOLDER INSTALLATION
A3/11”X17” COUNTER INSTALLATION
CASSETTE MODIFICATION
MODIFYING MAIN TRANSFORMER VOLTAGE
(220V TO 240V)
PREPARATION FOR TRANSPORTING THE COPIER
SHORT HAUL TRANSPORTATION
LONG HAUL TRANSPORTATION BY VEHICLE
1- 1
1- 2
1- 2
1- 3
1- 4
1- 5
1-12
1-13
1-15
1-16
1-17
1-18
1-19
1-20
15 MARCH 1987
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
1. ENVIRONMENT
Temperature Range:
Humidity Range:
Ambient Illumination:
Ventilation:
Ambient Dust:
Room Size:
10°C to 30°C (50°F to 86°F)
15% to 90% RH
Less than 1,500 Iux (Do not expose to direct
sunlight.)
Room air should turn over at least 3 times/hour.
Less than 0.15 mg/m3 (4 x 10¯³ oz/yd³)
More than 10 m3 (13.4 yd3)
If the installation place is air-conditioned or heated, place the
machine:
a.
Where it will not be subjected to sudden temperature changes.
b. Where it will not be directly exposed to cool air from an air
conditioner in the summer.
c. Where it will not be directly exposed to reflected heat from a
space heater in winter.
Avoid placing the copier in an area filled with corrosive gas.
Avoid any area higher than 2,000 meters (6,500 feet) above sea
level.
Place the copier on a strong and level base.
Avoid any area where the copier may be subjected to frequent
strong vibration.
1-1
15 MARCH 1987
1.
2.
1.
2.
3.
4.
2. MACHINE LEVEL
Front to back: Within 5 mm (0.2”) of level
Right to left: Within 5 mm (0.2”) of level
Place the machine on a table and screw the leveling foots [A] up or
down to level the machine.
Use a leveling gauge if necessary.
3. MINIMUM SPACE REQUIREMENT
Front: 70 cm (27.6”)
Back: 10 cm (3.9”)
Right: 80 cm (31.5”)
Left : 10 cm (3.9”)
1-2
15 MARCH 1987
4. POWER REQUIREMENT
1. Input voltage level
110V/60Hz : More than 15A
115V/60Hz : More than 15A
220V/50Hz : More than 8A
220V/60Hz : More than 8A
240V/50Hz : More than 8A
2. Permissible voltage fluctuation: ± 10%
3. Permissible extension cord: At least 300V, 30A capacity and less
than 5 meters (16.4 ft) long.
4. Do not set anything on the power cord.
NOTE: -
Be sure to ground the machine. (Do not connect the grounding wire to a
gas pipe.)
- Make sure the plug is firmly inserted in the outlet.
- Avoid multi-wiring.
1-3
15 MARCH 1987
5. COPIER INSTALLATION
- ACCESSORY CHECK -
Check the quantity and condition of the accessories in the box
according to the following list.
DESCRIPTION
1. Installation Procedure
(115V - English only. 220V/240V - five languages)
2. New Equipment Condition Report
3. Envelope - NECR (115V only)
4. Cassette - Large
America, Europe, Middle East, Philippines
The Rest of Asia,
5. Cassette - Small
America, Europe, Middle East, Philippines, Taiwan
The Rest of Asia
6. Receiving tray
7. Original holder
8. Operating instructions
(115V - English only. 220V/240V - five languages)
9. Operating instruction cards
(115V - English only. 220V/240V - five languages)
10. Multilingual decals (220/240V only)
11. Sort/Stack key top
(attached on the right inner cover)
12. Sort/Stack key cover
(attached on the right inner cover)
13. Editing Sheet
Q’TY
1
1
1
1
2
2
1
1
1
1
1
1
1
1
1
NOTE: Save the Sorter/Stack key top and cover for Sorter installation.
1-4
15 MARCH 1987
- INSTALLATION PROCEDURE -
1.
2.
3.
4.
Remove the shipping tapes [A] from the copier as shown.
Open the copier right [B] and left front door [C], remove the shipping
tape [D] and the wedge [E] between the registration rollers, and cut
the cable tie [F] securing the toner collection bottle as shown.
Pull out the cassette tray [G].
Remove the foam rubber [H].
1-5
Table des matières
Autres manuels Ricoh Photocopieuse
Ricoh
Ricoh 3245e Manuel utilisateur
Ricoh
Ricoh Gim-MF1a Guide de démarrage rapide
Ricoh
Ricoh Aficio MP C3000 Series Manuel de service
Ricoh
Ricoh Aficio 401 Manuel utilisateur
Ricoh
Ricoh D017 Manuel utilisateur
Ricoh
Ricoh SWALLOW 2 Manuel utilisateur
Ricoh
Ricoh FT2012 Manuel utilisateur
Ricoh
Ricoh Aficio 1075 Manuel utilisateur
Ricoh
Ricoh DSc332 Manuel utilisateur
Ricoh
Ricoh A-C4 Manuel utilisateur
Ricoh
Ricoh FT 4015 Manuel utilisateur
Ricoh
Ricoh Cor-C1 Series Guide d'installation
Ricoh
Ricoh M281 Series Manuel utilisateur
Ricoh
Ricoh A219 Manuel utilisateur
Ricoh
Ricoh FT7950 Manuel utilisateur
Ricoh
Ricoh MP 2000LE Manuel utilisateur
Ricoh
Ricoh A163 Manuel utilisateur
Ricoh
Ricoh B125 Manuel utilisateur
Ricoh
Ricoh Aficio SP 5200S Manuel utilisateur
Ricoh
Ricoh D069 Guide de démarrage rapide
