Renesas ICS601-21 Manuel utilisateur

ICS601-21 Preliminary 1Revision 010405

Integrated Circuit Systems, Inc. l525 Race Street, San Jose, CA 95126 ltel (408) 297-1201 lwww.icst.com

ICS601-21 Demo Board Instructions

ICS601-21 Demo Board

The ICS601-21 demo board provides a way to quickly evaluate the performance of the ICS601-21 Low

Phase Noise Clock Multiplier.

Power

Connect either 3.3 volts across the VDD and GND header pins.

Frequency Selection

The output frequency can be changed by setting S0, S1 and S2 on SW1 according to the information in the

Multiplier Select Table on page 2 of the datasheet. Alternatively, shunts can be soldered to the appropriate

0604 device landings underneath SW1. Turning on a switch or stuffing a shunt will pull that particular input

low. Opening the switch or removing the shunt will allow the on-chip pull-up resistors to take the input high.

Input Options

The ICS601-21 Demo board supports either a thru hole or an SMT crystal or a single ended clock input.

Crystal Tuning

In order to achieve 0 PPM frequency synthesis, the ICS601-21 supports external tuning capacitors (C1 and

C2). For exact tuning when using a crystal, capacitors should be connected from pins X1 to ground and X2

to ground. The value of these capacitors is given by the following equation, where CLis the specified

crystal load capacitance in pF:

C1 and C2 (pF) = (CL - 5) x 2.

So, for a crystal with 16 pF load capacitance, use two 22 pF caps.

Output Termination

The 50 ohm resistors R3 and R5 as serve as termination resistors to ground. These values match the

PCB’s trace impedance. Component locations R2 and R4 are provided to allow for user experimentation.

This “on-board” termination allows the clock outputs to be measured directly with a high impedance

oscilloscope probe. To use “off-board” termination, remove R3 and R5, connect 50 ohm coax cables

between the clock connectors and the oscilloscope and terminate with 50 ohms in the oscilloscope.

Trace Impedance

The ICS601-21 board has controlled impedance traces of 50 ohms for all clock inputs and outputs.

Component Crystal Input 50 ohm Clock Input

CN1 open SMA connector

R1 open short

C2 open 50 ohm

Y1/Y2 stuff only one open

ICS601-21 Demo Board Instructions

ICS601-21 Preliminary 2Revision 010405

Integrated Circuit Systems, Inc. l525 Race Street, San Jose, CA 95126 ltel (408) 297-1201 lwww.icst.com

Demo Board Schematics

ICS601-21 Demo Board Instructions

ICS601-21 Preliminary 3Revision 010405

PCB Power Plane

PCB Ground Plane

PCB Top

PCB Bottom

Corporate Headquarters

TOYOSU FORESIA, 3-2-24 Toyosu,

Koto-ku, Tokyo 135-0061, Japan

www.renesas.com

Contact Information

For further information on a product, technology, the most

up-to-date version of a document, or your nearest sales

office, please visit:

www.renesas.com/contact/

Trademarks

Renesas and the Renesas logo are trademarks of Renesas

Electronics Corporation. All trademarks and registered

trademarks are the property of their respective owners.

IMPORTANT NOTICE AND DISCLAIMER

RENESAS ELECTRONICS CORPORATION AND ITS SUBSIDIARIES (“RENESAS”) PROVIDES TECHNICAL

SPECIFICATIONS AND RELIABILITY DATA (INCLUDING DATASHEETS), DESIGN RESOURCES (INCLUDING

REFERENCE DESIGNS), APPLICATION OR OTHER DESIGN ADVICE, WEB TOOLS, SAFETY INFORMATION, AND

OTHER RESOURCES “AS IS” AND WITH ALL FAULTS, AND DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED,

INCLUDING, WITHOUT LIMITATION, ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A

PARTICULAR PURPOSE, OR NON-INFRINGEMENT OF THIRD PARTY INTELLECTUAL PROPERTY RIGHTS.

These resources are intended for developers skilled in the art designing with Renesas products. You are solely responsible

for (1) selecting the appropriate products for your application, (2) designing, validating, and testing your application, and (3)

ensuring your application meets applicable standards, and any other safety, security, or other requirements. These

resources are subject to change without notice. Renesas grants you permission to use these resources only for

development of an application that uses Renesas products. Other reproduction or use of these resources is strictly

prohibited. No license is granted to any other Renesas intellectual property or to any third party intellectual property.

Renesas disclaims responsibility for, and you will fully indemnify Renesas and its representatives against, any claims,

damages, costs, losses, or liabilities arising out of your use of these resources. Renesas' products are provided only subject

to Renesas' Terms and Conditions of Sale or other applicable terms agreed to in writing. No use of any Renesas resources

expands or otherwise alters any applicable warranties or warranty disclaimers for these products.

(Rev.1.0 Mar 2020)

Table des matières

Autres manuels Renesas Matériel informatique

Renesas

Renesas RZ/T2M Manuel utilisateur

Renesas

Renesas SKP16C62P Manuel utilisateur

Renesas

Renesas H8/3847R Series Manuel utilisateur

Renesas

Renesas H8SX/1651 Manuel utilisateur

Renesas

Renesas M30290T2-CPE Manuel utilisateur

Renesas

Renesas Converter Board R0E521237CFK00 Manuel utilisateur

Renesas

Renesas TQFP-100G Manuel utilisateur

Renesas

Renesas R8C/25 Manuel utilisateur

Renesas

Renesas IE850A Manuel utilisateur

Renesas

Renesas MCU Board for 4513/4514 Group MCUs... Manuel utilisateur

Renesas

Renesas RL78 Series Manuel utilisateur

Renesas

Renesas SH7709S Manuel utilisateur

Renesas

Renesas IAR KickStart Kit R-IN32M4-CL3 Manuel utilisateur

Renesas

Renesas RX66T Manuel utilisateur

Renesas

Renesas QB-MINI2 Manuel utilisateur

Renesas

Renesas PRQP0064GB-A Manuel utilisateur

Renesas

Renesas R8C series Manuel utilisateur

Renesas

Renesas M30263T-42SSB Manuel utilisateur

Renesas

Renesas H8S/2368 Series Manuel utilisateur

Renesas

Renesas M52757FP Manuel utilisateur

Renesas

Renesas R8C/Tiny Series Instructions de montage

Renesas

Renesas RSKH8S2215R Manuel utilisateur

Renesas

Renesas H8S/2655 Series Manuel utilisateur

Renesas

Renesas H8/3694 Manuel utilisateur

Manuels Matériel informatique populaires d'autres marques

EMC2

EMC2 VNX Series Manuel du propriétaire

Panasonic

Panasonic DV0PM20105 Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuel utilisateur

Raidon

Raidon iT2300 Manuel utilisateur

National Instruments

National Instruments PXI-8186 Manuel utilisateur

Hauppauge

Hauppauge WinTV-HVR-2250 Manuel utilisateur

Kontron

Kontron CP6002 Manuel utilisateur

Manhattan

Manhattan 702843 Manuel utilisateur

Aphex

Aphex 230 Manuel utilisateur

AMD

AMD Phenom II Manuel d'exploitation

Intel

Intel NUC 12 Pro Manuel utilisateur

dbx

dbx Zone Pro 1260 Manuel utilisateur

Galaxy

Galaxy GHDX2-2430S-24F4D Manuel utilisateur

Intel

Intel AXXRMFBU4 Manuel utilisateur

Kontron

Kontron DIMM-PC/MD Manuel utilisateur

ST X-NUCLEO-SAFEA1B Mode d'emploi

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuel utilisateur