Pyramid CDR45DX Manuel utilisateur

OWNER’S MANUAL

PLL SYNTHESIZER STEREO RADIO WITH

COMPACT DISC PLAYER DIGITAL

INSTALLATION

Notes:

• Choose the mounting location where the unit will not interfere with the normal

driving function of the driver.

• Before finally installing the unit, connect the wiring temporarily and make sure it is

all connected up properly and the unit and the system work properly.

• Use only the parts included with the unit to ensure proper installation. The use of

unauthorized parts can cause malfunctions.

• Consult with your nearest dealer if installation requires the drilling of holes or other

modifications of the vehicle.

• Install the unit where it does not get in the driver’s way and cannot injure the

passenger if there is a sudden stop, like an emergency stop.

• If installation angle exceeds 30˚ from horizontal, the unit might not give its optimum

performance.

• Avoid installing the unit where it would be subject to high temperature, such as from

direct sunlight, or from hot air, from the heater, or where it would be subject to dust,

dirt or excessive vibration.

DIN FRONT/REAR-MOUNT

This unit can be properly installed either from “Front” (conventional DIN Front-mount)

or “Rear” (DIN Rear-mount installation, utilizing threaded screw holes at the sides of

the unit chassis). For details, refer to the following illustrated installation methods.

DIN FRONT-MOUNT (Method A)

Installation the unit

1. Dashboard

2. Holder

After inserting the holder into the

dashboard, select the appropriate tab

according to the thickness of the

dashboard material and bend them

inwards to secure the holder in place.

3. Screw

30˚

182

(Fig. 1)

1. Dashboard

2. Nut (5mm)

3. Spring washer

4. Screw (5 x 25mm)

5. Screw

6. Strap

Be sure to use the strap to secure the

back of the unit in place. The strap can

be bent by hand to the desired angle.

7. Plain washer

Removing the unit

1. Frame

2. Insert fingers into the groove in the front

of frame and pull out to remove the

frame. (When re-attaching the frame,

point the side with a groove downwards

and attach it.)

3. Lever

Insert the levers supplied with the unit

into the grooves at both sides of the unit

as shown in figure until they click.

Pulling the levers makes it possible to

remove the unit from the dashboard.

DIN REAR-MOUNT (Method B)

Installation using the screw holes on the sides of the unit.

Fastening the unit to the factory radio

mounting bracket.

1. Select a position where the screw holes

of the bracket and the screw holes of

the main unit become aligned (are fitted),

and tighten the screws at 2 places on

each side.

Use either truss screws (5 x 6mm) or

flush surface screws (4 x 6mm),

depending on the shape of the screw

holes in the bracket.

2. Screw

3. Factory radio mounting bracket

4. Dashboard or Console

5. Hook (Remove this part)

Note: The mounting box, outer trim ring,

and half-sleeve are not used for method B

installation.

(Fig. 2)

HOW TO REMOVE AND INSTALL THE FRONT PANEL

(OPTIONAL)

1. Press the release button and pull-off the front panel.

Keep front panel into the case.

2. To install the front panel, insert the panel into the housing and make sure the panel

is properly installed, otherwise, abnormalities occurs on the display or some keys

will not function properly.

REMOVING THE FRONT PANEL

INSTALLING THE FRONT PANEL

Release Button

Front Panel

WIRING CONNECTION

1. All connections should be soldered and insulated with electrical tape.

2. Be sure to connect the red power input lead to + 12V power terminal after all the

other leads have been properly connected.

3. Run all ground wires to a common ground.

4. After all the connection is completed, press the “RESET” (19) button.

ANTENNA RELAY WIRE

A yellow wire has been provided for relay controlled antenna. The relay will

automatically activate antenna upward when unit is turned on and retract when unit

is turned off.

CAUTION:

Do not hook up yellow wire to motor wire or damage may occur to the unit.

WIRING CONNECTION FOR 4 X 7W OR 2 X 25W SYSTEM

Note:

1. For 2-speakers system, blue, white, green/black and grey/black wire leads are

unconnected and isolated.

2. For 2-speakers system, keep the fader control at center position to maintain the

existing volume level.

MEMORY

BACK-UP

FRONT

Lch SPK.

GREEN

GREEN/BLACK

MAIN UNIT

Rch RED

(FOR RCA LINE OUT VERSION ONLY)

FRONT RCA CABLE

IGNITION

SWITCH (B+)

POWER

ANTENNA

Lch WHITE

REAR

Lch SPK.

RED

GROUND (B–)

PINK

BLACK

CHOKE BOX

YELLOW

Rch RED

Lch WHITE

REAR RCA CABLE

(GREY)

ANTENNA CONNECTOR

BLUE

BLUE/BLACK

4-SPEAKERS SYSTEM

Lch

SPK.

GREEN

BLUE/BLACK

2-SPEAKERS SYSTEM

GREY

GREY/BLACK

WHITE

WHITE/BLACK

4-SPEAKERS SYSTEM

FRONT

Rch SPK.

REAR

Rch SPK.

Rch

SPK.

GREY

WHITE/BLACK

2-SPEAKERS SYSTEM

WIRING CONNECTION FOR 2 X 7W SYSTEM

ANTENNA CONNECTOR

GROUND (B–)

LEFT

SPEAKER

GREEN

GREEN/BLACK

MAIN UNIT

Rch RED

(FOR RCA LINE OUT VERSION ONLY)

RCA CABLE

RIGHT

SPEAKER

POWER

ANTENNA

Lch WHITE

(GREY)

GREY

GREY/BLACK

BLACK

RED

YELLOW

(FOR POWER ANT. VERSION ONLY)

IGNITION

SWITCH (B+)

PINK

MEMORY

BACK-UP

CHOKE BOX

OPERATION

GENERAL OPERATION

• ON/OFF

Press PWR button (1) to turn on the unit. Press it again to turn it off.

• FACEPLATE RELEASE

Press REL button (2) to detach the removable faceplate.

18 19

113 7 2

891016154

12175

116

• SELECT AUDIO MODE

Press SEL button (3) to change audio mode through volume, bass, treble, balance

and fader modes. Use (4) and (5) buttons to adjust the selected mode.

When mode has not been adjusted for 3 seconds, display returns to normal radio

or CD display.

Volume

Adjust volume level by using (4) and (5) buttons.

Note: The unit is initially set to volume mode.

Bass

Press SEL button (3) one time. Adjust bass level by using (4) and (5) buttons.

Treble

Press SEL button (3) two times. Adjust treble level by using (4) and (5) buttons.

Balance

Press SEL button (3) three times. Adjust sound balance between left and right

speakers by using (4) and (5) buttons.

Fader

Press SEL button (3) four times. Adjust sound balance between front and rear

speakers by using (4) and (5) buttons.

• LOUDNESS

Press and release RND/LOU button (11) immediately to reinforce the bass output.

• TIME SETTING

Press DSP button (6) to change the display to clock display, if no key is activated

in 5 seconds, it will automatically return to previous display.

Press and hold the DSP button (6) for 3 seconds until the clock display flashes.

Press (5) to change minutes or (4) to change hours.

• SELECT MODE

During CD operation, press BND button (7) to switch to radio mode. During radio

operation, when a compact disc is inserted in the disc slot, press CD button (12) to

switch to CD mode and start playing.

• LIQUID CRYSTAL DISPLAY

Exhibit current frequency and activated functions on the display (17).

• LED

When the front panel does not install on the unit, the LED indicator (18) is flashing.

• RESET

Press RESET button (19) to re-initialized the unit in case abnormalities or malfunction

is observed. When reset is activated, all preset station/program will be cleared.

Reset button can be access by any pointed material.

VOL BAS TRE BAL FAD

(Volume) (Bass) (Treble) (Balance) (Fader)

RADIO OPERATION

• SELECT BAND

Press BND button (7) to change bands as below:

3 bands: 2 bands:

• SELECT STATION

Rotate the TUNE knob (8) clockwise or anti-clockwise to choose the desired

frequency.

• SELECTING LOCAL/DISTANT

In radio operation, press RPT/LOC button (9) select between local setting for

reception of strong station and distant setting for reception of weak stations when

tuning.

• SELECTING MONO/STEREO

In radio operation, press INT/MON button (10) to select mono or stereo reception

for radio stations. You can sometimes improve reception of distant stations by

selecting mono operation.

FM MW LW FM AM

CD OPERATION

• DISC PLAY

Push a compact disc with the label

side facing up into the disc slot (13)

and you will hear a click sound.

If no sound heard, the CD should be

incorrectly inserted into the disc slot.

(As figure shows)

Then it automatically starts playing the

first track of the disc.

The display will indicate the track

number and playing time.

During the playing, press button (12) to temporarily stop the playing or press it

again to recover playing.

Press (eject) button (14) to eject CD from the slot. The unit switches to radio

operation.

• SELECT TRACKS

In CD operation, press MAN/SKIP buttons –(15) or +(16) to move to the previous

track or the following track. Track number shows on display.

In CD operation, hold MAN/SKIP buttons –(15) or +(16) to fast reverse or fast

forward. CD play starts from when you release the button.

• REPEAT

In CD operation, press RPT/LOC button (9) to continuously repeat the same track.

Press once more to continuously repeat the same disc. Press it at the third time to

release the mode.

• PLAY IN RANDOM ORDER

Press and hold RND/LOU button (11) for more than 1.5 seconds to play all tracks

on the current CD in random order. Press it more than 1.5 seconds again to cancel

the function.

• PREVIEW ALL TRACKS

During CD operation, press INT/MON button (10) to play first 10 seconds of each

track on current CD. Press it again to stop intro and recover normal playing.

Table des matières

Autres manuels Pyramid Récepteur de voiture

Pyramid

Pyramid CDR78 Manuel utilisateur

Pyramid

Pyramid CDR86DX Manuel utilisateur

Pyramid

Pyramid CDR-38DX Manuel utilisateur

Pyramid

Pyramid CDR27DX Manuel utilisateur

Pyramid

Pyramid CDR40DX Manuel utilisateur

Pyramid

Pyramid CDRCS80D Guide de démarrage rapide

Pyramid

Pyramid CDR31FD Manuel utilisateur

Pyramid

Pyramid CDR37FD Manuel utilisateur

Pyramid

Pyramid PDVD79 Manuel utilisateur

Pyramid

Pyramid 1902EQ Manuel utilisateur

Pyramid

Pyramid 1906EQ Manuel utilisateur

Pyramid

Pyramid CDR-36DX Manuel utilisateur

Pyramid

Pyramid CDR25P Manuel utilisateur

Pyramid

Pyramid CDR35FD Manuel utilisateur

Pyramid

Pyramid CDR88DFX Manuel utilisateur

Pyramid

Pyramid CDR83MP Manuel utilisateur

Pyramid

Pyramid CDR21KIT Manuel utilisateur

Pyramid

Pyramid CDR79MP Manuel utilisateur

Pyramid

Pyramid CDR98MP3 Manuel utilisateur

Pyramid

Pyramid CDR22P Manuel utilisateur

Pyramid

Pyramid CDR82DFX Manuel utilisateur

Pyramid

Pyramid CDR42DX Manuel utilisateur

Pyramid

Pyramid 2706D Manuel utilisateur

Pyramid

Pyramid CDRCS91MP Guide de démarrage rapide

Manuels Récepteur de voiture populaires d'autres marques

Motorola

Motorola VWA63 Manuel utilisateur

Nextar

Nextar D3201 Manuel utilisateur

Alpine

Alpine CDE-163BT Manuel utilisateur

Pioneer

Pioneer DEH-P645R Manuel utilisateur

Axxera

Axxera XDMA7600 Mode d'emploi

XM OnyX Manuel utilisateur

Sound Storm

Sound Storm STM93R Manuel utilisateur

Soundstream

Soundstream VIR-5000 Manuel utilisateur

Avson

Avson MKT Platform Manuel utilisateur

Sony

Sony MEX-1HD - Audio Library System Manuel utilisateur

Pioneer

Pioneer DVH-P500UB Manuel utilisateur

JVC

JVC KD-AHD69 Manuel utilisateur

Blaupunkt

Blaupunkt SANTIAGO CR 87 Manuel utilisateur

Sony

Sony CDX-4160 - Cd Receiver Manuel utilisateur

XFIRE AUDIO

XFIRE AUDIO BMW42S Manuel utilisateur

VDO

VDO CD 2253 Manuel utilisateur

Volvo

Volvo 13 84 580 Manuel utilisateur

ZENEC

ZENEC ZE-160DVD Manuel utilisateur