Powerware 5125 Manuel utilisateur

Powerware®5125

Two-in-One

User’s Guide

2400–3000 VA

www.powerware.com

Requesting a Declaration of Conformity

Units that are labeled with a CE mark comply with the following harmonized standards and EU directives:

Harmonized Standards: EN 50091-1-1 and EN 50091-2; IEC 950 Second Edition, Amendments A1, A2, A3, and A4

EU Directives: 73/23/EEC, Council Directive on equipment designed for use within certain voltage limits

93/68/EEC, Amending Directive 73/23/EEC

89/336/EEC, Council Directive relating to electromagnetic compatibility

92/31/EEC, Amending Directive 89/336/EEC relating to EMC

The EC Declaration of Conformity is available upon request for products with a CE mark. For copies of the EC

Declaration of Conformity, contact:

Powerware Corporation

Koskelontie 13

FIN-02920 Espoo

Finland

Phone: +358-9-452 661

Fax: +358-9-452 665 68

Powerware is a registered trademark and Advanced Battery Management Plus (ABM Plus), X-Slot, and ConnectUPS are

trademarks of Powerware Corporation.

reproduced in any way without the express written approval of Powerware Corporation.

Class A EMC Statements

FCC Part 15

NOTE This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his own expense.

ICES-003

This Class A Interference Causing Equipment meets all requirements of the Canadian Interference Causing Equipment

Regulations ICES-003.

Cet appareil numérique de la classe A respecte toutes les exigences du Reglement sur le matériel brouilleur du Canada.

EN50091-2

Some configurations are classified under EN50091-2 as “Class-A UPS for Unrestricted Sales Distribution.” For these

configurations, the following applies:

WARNING This is a Class A-UPS Product. In a domestic environment, this product may cause radio interference, in

which case, the user may be required to take additional measures.

VCCI Notice

Special Symbols

The following are examples of symbols used on the UPS to alert you to important information:

RISK OF ELECTRIC SHOCK - Indicates that a risk of electric shock is present and the

associated warning should be observed.

CAUTION: REFER TO OPERATOR’S MANUAL - Refer to your operator’s manual for

additional information, such as important operating and maintenance

instructions.

This symbol indicates that you should not discard the UPS or the UPS batteries

in the trash. The UPS may contain sealed, lead-acid batteries. Batteries must be

recycled.

Powerware®5125 Two-in-One (2400–3000 VA) User’s Guide :www.powerware.com

TABLE OF CONTENTS

1 Powerware 5125 1................................................

2 Safety Warnings 3.................................................

3 Installation 17.....................................................

Inspecting the Equipment 17........................................................

UPS Setup 17..................................................................

Rack-Mount Setup 18..........................................................

Cabinet Setup 19.............................................................

Installing the UPS 24.............................................................

UPS Rear Panels 26..............................................................

4 Operation 29......................................................

Turning the UPS On 29............................................................

Starting the UPS on Battery 29....................................................

Turning the UPS Off 29...........................................................

Initiating the Self-Test 30..........................................................

Operating Modes 30.............................................................

Normal Mode 31.............................................................

Battery Mode 31.............................................................

Bypass Mode 32..............................................................

Standby Mode 32.............................................................

5 Additional UPS Features 33..........................................

X-Slot Modules 33...............................................................

Single-Port Module 34.........................................................

Load Segments 36...............................................................

Remote Emergency Power-Off 37....................................................

6 UPS Maintenance 39...............................................

UPS and Battery Care 39..........................................................

Storing the UPS and Batteries 39..................................................

Replacing the Electronics Module 40..................................................

When to Replace Batteries 41......................................................

Table of Contents

ii Powerware®5125 Two-in-One (2400–3000 VA) User’s Guide :www.powerware.com

Replacing Batteries 41............................................................

How to Replace Extended Battery Modules 42.........................................

How to Replace Internal Batteries 43...............................................

Testing New Batteries 44..........................................................

Recycling the Used Battery 45......................................................

7 Specifications 47..................................................

8 Troubleshooting 51.................................................

Audible Alarms and UPS Conditions 51................................................

Silencing an Audible Alarm 51....................................................

Service and Support 54...........................................................

Powerware®5125 Two-in-One (2400–3000 VA) User’s Guide :www.powerware.com

CHAPTER 1

POWERWARE 5125

The Powerware

5125 uninterruptible power system (UPS) protects

your sensitive electronic equipment from basic power problems such as

power failures, power sags, power surges, brownouts, and line noise.

Power outages can occur when you least expect it and power quality can

be erratic. These power problems have the potential to corrupt critical

data, destroy unsaved work sessions, and damage hardware — causing

hours of lost productivity and expensive repairs.

With the Powerware 5125, you can safely eliminate the effects of power

disturbances and guard the integrity of your equipment. The Powerware

5125 is designed for critical applications such as PCs, severs,

workstations, and telecommunications equipment. Figure 1 shows the

Powerware 5125 UPS with an optional Extended Battery Module (EBM).

Figure 1. The Powerware 5125

Providing outstanding performance and reliability, the Powerware

5125’s unique benefits include the following:

:2U rack height conserves valuable rack space.

:Advanced Battery Management Plus (ABM PlusZ) doubles battery

service life, optimizes recharge time, and provides a warning before

the end of useful battery life.

:Hours of extended run time with up to four EBMs.

:Hot-swappable batteries simplify maintenance by allowing you to

replace batteries safely without powering down the critical load.

Powerware 5125

2Powerware®5125 Two-in-One (2400–3000 VA) User’s Guide :www.powerware.com

:Start-on-battery capability allows you to power up the UPS even if

utility power is not available.

:Advanced power management with the Software Suite CD for graceful

shutdowns and power monitoring.

:Sequential shutdown and load management through separate

receptacle groups, called load segments.

:Emergency shutdown control through the Remote Emergency

Power-Off (REPO) port.

:Optional X-SlotZmodules provide enhanced communication

capabilities for increased power protection and control.

:The Powerware 5125 is backed by worldwide agency approvals.

Powerware®5125 Two-in-One (2400–3000 VA) User’s Guide :www.powerware.com

CHAPTER 2

SAFETY WARNINGS

Read the following precautions before you install the UPS.

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS. This manual contains important instructions that you

should follow during installation and maintenance of the UPS and batteries. Please

read all instructions before operating the equipment and save this manual for future

reference.

DANGER

This UPS contains LETHAL VOLTAGES. All repairs and service should be performed

by AUTHORIZED SERVICE PERSONNEL ONLY. There are NO USER

SERVICEABLE PARTS inside the UPS.

WARNING

:This UPS contains its own energy source (batteries). The output receptacles may

carry live voltage even when the UPS is not connected to an AC supply.

:Do not remove or unplug the input cord when the UPS is turned on. This removes

the safety ground from the UPS and the equipment connected to the UPS.

:To reduce the risk of fire or electric shock, install this UPS in a temperature and

humidity controlled, indoor environment, free of conductive contaminants. Ambient

temperature must not exceed 40C (104F). Do not operate near water or

excessive humidity (95% max).

:To comply with international standards and wiring regulations, the total equipment

connected to the output of this UPS must not have an earth leakage current

greater than 2.5 milliamperes.

Safety Warnings

4Powerware®5125 Two-in-One (2400–3000 VA) User’s Guide :www.powerware.com

CAUTION

:Batteries can present a risk of electrical shock or burn from high short-circuit

current. Observe proper precautions. Servicing should be performed by qualified

service personnel knowledgeable of batteries and required precautions. Keep

unauthorized personnel away from batteries.

:Proper disposal of batteries is required. Refer to your local codes for disposal

requirements.

:Never dispose of batteries in a fire. Batteries may explode when exposed to flame.

Sikkerhedsanvisninger

VIGTIGE SIKKERHEDSANVISNINGER

GEM DISSE ANVISNINGER

DENNE BRUGERVEJLEDNING INDEHOLDER VIGTIGE

SIKKERHEDSANVISNINGER

FARE

Denne UPS indeholder LIVSFARLIG HØJSPÆNDING. Alle reparationer og

vedligeholdelse bør kun udføres af en AUTORISERET SERVICETEKNIKER. Ingen af

UPS’ens indvendige dele kan repareres af brugeren.

ADVARSEL!

:Denne UPS indeholder egen energiforsyning (batterier). Udgangsnetstikkene kan

lede strøm, selv når UPS’en ikke er tilsat en AC-energikilde.

:Netledningen må ikke fjernes og stikket må ikke trækkes ud, mens UPS’en er

tændt. Dette fjerner sikkerhedsjorden fra UPS’en og fra det udstyr, der er sat til.

:Installér denne UPS i et temperatur- og fugtighedskontrolleret indendørsmiljø, frit

for ledende forureningsstoffer for at formindske risikoen for brand og elektrisk

stød. Rumtemperaturen må ikke overstige 40C. UPS’en bør ikke betjenes nær

vand eller høj fugtighed (maksimalt 95%).

:I overensstemmelse med internationale normer og bestemmelser for el-installation

må det udstyr, der er forbundet til udgangen af denne UPS, tilsammen ikke

overskride en jordafdelingsspænding på mere end 2,5 milliampere.

Autres manuels pour 5125

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Powerware UPS

Powerware

Powerware PowerRite XT Manuel utilisateur

Powerware

Powerware 5125 P33 Manuel utilisateur

Powerware

Powerware UPS 1000 - 2200 Manuel utilisateur

Powerware

Powerware 9305 Manuel d'utilisation

Powerware

Powerware 9120 Manuel utilisateur

Powerware

Powerware 5115 RM Manuel utilisateur

Powerware

Powerware Ferrups FE/QFE 500VA Manuel utilisateur

Powerware

Powerware P93 Manuel utilisateur

Powerware

Powerware 5140 Manuel utilisateur

Powerware

Powerware BPIV 30 kVA Manuel utilisateur

Powerware

Powerware 9305 Manuel d'utilisation

Powerware

Powerware 9330 Manuel utilisateur

Powerware

Powerware 5140 Manuel utilisateur

Powerware

Powerware 700 3000 VA Manuel utilisateur

Powerware

Powerware Prestige 6000 Guide de configuration

Powerware

Powerware 5125 9910 P18 Manuel utilisateur

Powerware

Powerware 5115 Manuel utilisateur

Powerware

Powerware Plus 80 Mode d’emploi

Powerware

Powerware 5125 Manuel utilisateur

Powerware

Powerware Uninterruptible Power Supply Manuel utilisateur

Powerware

Powerware Prestige series 9 Manuel utilisateur

Powerware

Powerware 9125 Manuel utilisateur

Powerware

Powerware 5105 Manuel utilisateur

Powerware

Powerware 9330 Manuel utilisateur

Manuels UPS populaires d'autres marques

Pylontech

Pylontech Victron & Pylontech US5000 Manuel utilisateur

Tecnoware

Tecnoware EVO DSP PLUS MM 6.8 Manuel utilisateur

Mecer

Mecer ME-1000-WTU Manuel utilisateur

Mustek

Mustek PowerMust 530(B) Plus Manuel d'installation et d'exploitation

Emerson

Emerson Liebert NXL series Manuel utilisateur

MAKELSAN

MAKELSAN BOXER SERIES Manuel utilisateur

Block

Block PC-0524-400-0 Manuel utilisateur

CyberPower

CyberPower CP585LCD Manuel utilisateur

Eaton

Eaton 3S Instructions de montage

CyberPower

CyberPower Office Tower Series UPS 1000 Manuel utilisateur

CyberPower

CyberPower BM100 Manuel utilisateur

Best Power

Best Power 610 Manuel utilisateur

Best Power

Best Power Unity/I UT3K Manuel utilisateur

Mustek

Mustek PowerMust 400 Offline Manuel utilisateur

Xantrex

Xantrex Trace 512 UR-UPS Manuel utilisateur

Forza

Forza SL-1501UL Manuel utilisateur

LEGRAND

LEGRAND keor 310081 Manuel utilisateur

ABB

ABB Conceptpower DPA 500 Manuel utilisateur