Philips Selecon Aurora Manuel utilisateur

AURORA 1000W range

CYC, FLOOD & GROUNDROW

OPERATION MANUAL

THANK YOU FOR PURCHASING A SELECON AURORA FIXTURE. WE HAVE DESIGNED THIS FIXTURE TO PROVIDE

YOU WITH A SUPERIOR FITTING IN PERFORMANCE DESIGN AND ENGINEERING. WE ARE CONFIDENT THAT IT

WILL PERFORM TO YOUR EXPECTATIONS FOR MANY YEARS TO COME.

Below is information to assist you in making maximum use of your fixture, its maintenance and care. If you would

like further assistance contact your Selecon dealer or Selecon.

PLEASE NOTE: The Philips Selecon Cyc and Flood ranges are high performance entertainment fixtures designed

for entertainment and studio applications, they are not designed for continuous use as required for a work light

or rehearsal light. For these applications please use the Philips Selecon Hui Work Light.

SAFETY –MAINS POWER ISOLATION

The Aurora range is fitted with two micro-switches for each compartment, which automatically disconnect the

mains power when the color cassette is opened.

MOUNTING YOUR FIXTURE

A variety of mounting options is available for your Aurora fixture. Theatrical style hook clamps or TV style barrel

clamps are available from your Philips Selecon distributor.

A safety chain (Order Code: 20SC) MUST always be used when rigging fixtures on bars, ladders etc. The safety

chain is passed through the fixture anchor point hole located at the rear of the fixture and around the bar. Be

careful to allow sufficient slack to allow the fixture to be focused freely. Philips Selecon supply a safety chain

with all theatrical / entertainment fixtures.

The fixture should be at least 3ft away from the nearest object it is lighting.

LAMPS

Use only standard FFT type 1000W double-ended linear lamps.

To re-lamp, undo the latch at the top of the fixture and swing the color cassette forward. Carefully remove the old

lamp, and replace it with the new one. Take care not to touch the glass itself as the oil from your fingerprints can

cause premature lamp failure. After replacing the lamp, fold up the color cassette and latch it to the fixture body.

Isolate electrically before re-lamping the fixture. Also be aware that the lamp or fixture may still be hot, so

exercise necessary caution to avoid burns. Please note also that these fixtures are not suitable for mounting on

a normally flammable surface, and are not for household use.

FOCUSING

To pan the fixture, loosen the nut at the top of the yoke and adjust, then retighten. To tilt, loosen the locking

clamp handle on the side of the fixture, tilt and retighten finger tight.

Please note that the Aurora range can reach high temperatures depending on the position and orientation of

the fixture, and that gloves should always be worn when focusing these fixtures.

COLOR FILTER HOLDER

To remove the color frame, open the hinged door at the top of the color cassette and lift out the frame. Remove

the inner spring frame from the outer frame and use it as a template to cut a filter to the exact size (please note

that is the color filter cut is too small, it will shrink when hot, and may cause light leak).

Position the color filter in the outer frame, and then position one end of the inner frame into one of the channels

of the outer frame. Bend the inner frame and slip the other end of it into the outer frame’s other channel and

release it. The frame should now clamp the four edges of the color filter.

MAINTENANCE

1. REFLECTOR: Wipe with a soft cloth to remove accumulated dust.

2. GLASS: Clean with a soft cloth. To remove baked on dust use a window cleaner.

The above are the only maintenance tasks that can be safely carried out by non approved personnel. Refer below

–safety & maintenance.

SAFETY AND MAINTENANCE

Philips Selecon has manufactured this fixture in accordance with recognized best practices to recommended

international safety standards. It is the owner’s responsibility to maintain this fixture in good and safe working

condition.

Repairs should only be carried out by suitably qualified persons. Do not operate the fixture with cracked lens,

damaged cable, etc. Consult your Philips Selecon distributor for assistance. Only replace damaged parts with

authorized Philips Selecon spares.

N.B. Fixture cables –your Philips Selecon fixture is fitted with special heat resistant flexible cable, replace with

genuine Philips Selecon spare part cable kit only –refer to your Philips Selecon distributor.

Replacement cables are supplied complete with necessary terminal connectors.

Cable conductor color codes: Brown - Phase, Live

Blue - Neutral, return

Green/Yellow - Earth

LIMITED WARRANTY

Philips Selecon (“Selecon”) warrants its products against defects in materials or workmanship. The

term of this warranty is based on the product usage and is from the date of delivery.

Usage –Entertainment, Theatre Term –Three Years

Entertainment, Theatre relates to the typical conditions found in a theatre performance venue viz: 4 –6

hrs per day, six days per week.

This warranty is void in any of the following circumstances: (a) The fixture has been misused, neglected, damaged

or abused. (b) The fixture has been improperly installed, operated, repaired or maintained. (c) The fixture has

been modified. (d) The fixture has been connected to other equipment with which it is not compatible. (e) The

fixture has been used or stored in conditions outside its electrical or environmental specifications. (f) The fixture

has been used for purposes other than for which it was designed. (g) The fixture has been used outside its stated

specifications and operating parameters.

Correct installation of the luminaire is the owner’s responsibility.

To assert a warranty claim, complete Selecon’s return authorization form (available from Selecon). Return the

luminaire to Selecon or its authorized agent.

If Selecon accepts the warranty claim, Selecon will provide, or arrange for, service, repair or replacement as

Selecon shall determine in its sole discretion. Selecon shall bear the cost of such service, repair or replacement.

However, the owner shall bear the cost of freight and insurance on the luminaire, both ways. If Selecon does not

wish to service, repair or replace the defective luminaire, it shall refund the purchase price.

Selecon’s sole responsibility is to repair, replace or service a luminaire subject to a valid warranty claim. Under no

circumstance will Selecon be liable for direct, indirect, incidental, special or consequential costs or damages,

including dismantling and re-installation costs, loss of operations or profits, to the maximum extent permitted by

law.

Selecon accepts no liability for personal injury or property damage resulting from failure to heed relevant

operating and safety procedures specified by Selecon or imposed by law.

This is an express warranty. Selecon disclaims any other express or implied warranties, including warranties of

merchantability or fitness for purpose, to the maximum extent permitted by law.

Some jurisdictions do not allow limitations or disclaimers of implied or statutory warranties. Some jurisdictions

do not allow disclaimers or exclusions of consequential or incidental damages. Therefore, the above disclaimers,

limitations and exclusions may not apply in all jurisdictions in which Selecon sells its luminaires.

This warranty gives the owner specific legal rights. The owner may have other rights or remedies pursuant to the

laws in its territory. Nothing in this limited warranty should be construed as limiting or restricting any other

statutory right or remedy of the owner, except for such limitations or restrictions herein as may be allowed by the

law of the territory.

Philips Selecon has a policy of continual product improvement and specifications are subject to change without

notice.

PHILIPS SELECON DISTRIBUTOR NETWORK

Your Philips Selecon distributor is a theatre professional with a broad knowledge of understanding of performance

requirements. Most can offer you a full service including not only stage lighting equipment but all your theatre

needs including curtains, scenic paint, sound equipment as well as supplies of lamps, filter, gaffer tape, etc.

The Philips Selecon dealer network is an international group of lighting professionals throughout North America,

Australasia, Asia and Europe.

Manufacturer

Philips Selecon, 19-21 Kawana Street, Northcote, Auckland 0627, New Zealand

Ph: + 64 9 481 0100, Fax: + 64 9 481 0101

www.seleconlight.com

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Philips Luminaire

Philips

Philips GreenSpace Accent Elbow Manuel utilisateur

Philips

Philips Calculite 8087 Manuel utilisateur

Philips

Philips Lightolier MJ5 Manuel utilisateur

Philips

Philips Selecon Manuel utilisateur

Philips

Philips 34104-48-16 Manuel utilisateur

Philips

Philips Tangent FXS Manuel utilisateur

Philips

Philips ProSpec 37107 Manuel utilisateur

Philips

Philips EvoKit 2x4 P 36L 36W 835 2 0-107 G2 Manuel utilisateur

Philips

Philips 4A35 Manuel utilisateur

Philips

Philips 1050SQ_3D Manuel utilisateur

Philips

Philips Lytecaster 1001SW Manuel utilisateur

Philips

Philips iColor Accent Powercore Manuel utilisateur

Philips

Philips Lytecaster 2008 Manuel utilisateur

Philips

Philips Lytespan 8106 Manuel utilisateur

Philips

Philips ProSpec 37108 Manuel utilisateur

Philips

Philips selecon plcyc1 MKII Mode d’emploi

Philips

Philips 69101-53-PH Manuel utilisateur

Philips

Philips 6912528PH Manuel

Philips

Philips EG1-7 Manuel utilisateur

Philips

Philips Lytespan 8108 Manuel utilisateur

Philips

Philips Calculite C4CIN Manuel utilisateur

Philips

Philips SL205A Manuel utilisateur

Philips

Philips LWL2 Series Manuel utilisateur

Philips

Philips 31607-48-16 Manuel utilisateur

Manuels Luminaire populaires d'autres marques

Emos

Emos CLASSIC ZY1431T Manuel utilisateur

Westinghouse

Westinghouse Outdoor Lighting Fixture Manuel utilisateur

Hedler

Hedler C 12 silent Manuel utilisateur

Blizzard Lighting

Blizzard Lighting Puck: CSI Manuel utilisateur

Energetic Lighting

Energetic Lighting ELYSL-5004 Series Manuel utilisateur

Lightmaxx

Lightmaxx Shaft 5R Manuel utilisateur

Triarch

Triarch 31083 Manuel utilisateur

IKEA

IKEA TIVED Manuel utilisateur

Lightolier

Lightolier LP200 Manuel utilisateur

Chauvet Professional

Chauvet Professional ROGUE R1 BEAM WASH Manuel utilisateur

Martin

Martin MAC 250 Krypton Manuel utilisateur

Cooper Lighting

Cooper Lighting Halo L3232E Manuel utilisateur

Stageline

Stageline ODW-2410RGBW Manuel utilisateur

Light Sky

Light Sky Tornado Series Manuel utilisateur

Lightolier

Lightolier Paralyte 2424 PLA2G9LS26U Manuel utilisateur

Lightolier

Lightolier Lytespan 83ED17S Manuel utilisateur

Lightolier

Lightolier Calculite CS8226 Manuel utilisateur

ArtFox

ArtFox Beam 15R extreme Manuel utilisateur