Philips HC5410/83 Manuel utilisateur
Always here to help you
User manual
Register your product and get support at
www.philips.com/welcome
HC5410/83
HC3410/17
HC3410/13
1
6
Introduction
Congratulations on your purchase and welcome to Philips! To fully
benet from the support that Philips offers, register your product at
www.philips.com/welcome.
General description (Fig. 1)
1 Cutting unit
2 Length setting adjuster
3 On/off button
4 Trimming comb
5 Beard comb 1-23mm (HC3410/17 only)
6 Beard comb 1.5mm (HC5410/83 only)
7 Beard comb 3mm (HC5410/83 only)
8 Adapter
9 Socket for small plug
10 Brush
11 Case (HC5410/83 only)
12 Scissors (HC3410/13 only)
13 Comb
Important
Read this user manual carefully before you use the appliance and save it for
future reference.
Danger
- Keep the adapter dry.
Warning
- The adapter contains a transformer. Do not cut off the adapter to
replace it with another plug, as this causes a hazardous situation.
- This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
- Children should be supervised to ensure that they do not play with the
appliance.
Caution
- Never immerse the appliance in water or rinse it under the tap. Only
the cutting unit can be rinsed under the tap.
- Use, charge and store the appliance at a temperature between 5°C
and 35°C.
- Only use the adapter supplied.
- If the adapter is damaged, always have it replaced with one of the
original type in order to avoid a hazard.
- Do not use the appliance if the cutting unit or the trimming comb is
damaged or broken, as this may cause injury.
ENGLISH
Electromagnetic elds
This Philips appliance complies with all standards and regulations regarding
exposure to electromagnetic elds (EMF).
General
- The appliance is equipped with an automatic voltage selector and is
suitable for mains voltages from 100 to 240 volts.
- The adapter transforms 100-240 volts to a safe low voltage of less than
24 volts.
Preparing for use
Note:This appliance can only be used directly from the mains.
Preparing the appliance
1 Make sure the appliance is switched off.
2 Insert the appliance plug into the appliance (1) and put the adapter in
the wall socket (2).
ENGLISH 7
Using the appliance
The hair length settings are indicated in millimeters, the comb cuts the hair
to a length of 1mm to 23mm.The settings correspond to the remaining
hair length after cutting.
When you trim for the rst time, be careful. Do not move the trimmer
too fast. Make smooth and gentle movements.
Tip: Start trimming at a high length setting and reduce the length setting
gradually until you have reached the desired hair length.
Trimming with comb
1 Attach the comb onto the appliance.
2 Turn the length setting adjuster to the desired length setting.
Note: When you trim for the rst time, start at the highest length setting to
familiarise yourself with the appliance.
3 Switch on the appliance.
4 To trim most effectively, move the trimmer against the hair growth
direction. Make sure the surface of the comb always stays in contact
with the skin.
ENGLISH8
Trimming without comb
Use the trimmer without the trimming comb to clip hair close to the skin
(0.5mm) or to contour the neckline and sideburns.
Be careful when you trim without comb because the cutting
element removes every hair it touches.
1 Push the comb off the appliance.
2 Switch on the appliance.
3 Make well-controlled movements. Touch the hair lightly with the
trimmer.
Using the beard comb (HC5410/83, HC3410/17 only)
- The hair length settings are indicated in millimeters.
HC3410/17: One adjustable beard comb that cuts the hair to a length of
1-23mm.
HC5410/83: Two xed lengths beardcombs that cuts the hair to a length of
1.5mm and 3mm.
1 Attach the comb onto the appliance.
ENGLISH 9
2 HC3410/17 only:Turn the length setting adjuster to the
desired length setting.
3 Switch on the appliance.
4 To trim most effectively, move the trimmer against the hair growth
direction. Make sure the surface of the comb always stays in contact
with the skin.
Cleaning
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as alcohol, petrol or acetone to clean the appliance.
Never immerse the appliance in water or rinse it under the tap.
Note: Only the cutting element and the comb can be cleaned with water.
1 Make sure the appliance is switched off and disconnected from the
mains.
2 Wipe the housing of the appliance with a dry cloth.
3 Remove the comb and clean it with the brush or rinse it under the
tap.
4 Press the release button (1). The cutting unit comes off the appliance
(2).
ENGLISH10
Autres manuels pour HC5410/83
1
Ce manuel convient aux modèles suivants
2
Table des matières
Langues :
Autres manuels Philips tondeuse à cheveux
Philips
Philips HC5450/16 Manuel utilisateur
Philips
Philips QC5170/02 Manuel utilisateur
Philips
Philips HQC281 Manuel utilisateur
Philips
Philips NORELCO CCS060 Manuel utilisateur
Philips
Philips QC5055/60 Manuel utilisateur
Philips
Philips HS015/03 Manuel utilisateur
Philips
Philips QC5170/60 Manuel utilisateur
Philips
Philips HQC241/20 Manuel utilisateur
Philips
Philips QC5340 Manuel utilisateur
Philips
Philips Beolink 1000 Manuel utilisateur
Philips
Philips 9000 series Manuel utilisateur
Philips
Philips HQC483/00 Manuel
Philips
Philips QC5050 Manuel utilisateur
Philips
Philips Essence 5000 Series Manuel utilisateur
Philips
Philips Norelco QC5350 Manuel utilisateur
Philips
Philips HC5410/83 Manuel utilisateur
Philips
Philips QC5040 Manuel utilisateur
Philips
Philips HQC440 Manuel utilisateur
Philips
Philips QC5010 Manuel utilisateur
Philips
Philips HC9450/20 Manuel utilisateur
