Pelonis HF-0019 Manuel utilisateur

OWNER’S MANUAL

Fan Forced

PLEASE READ AND SAVE THESE INSTRUCTIONS

IMPORTANT INSTRUCTIONS

PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, basic precautions should always be followed to reduce the

risk of fire, electric shock, and injury to persons, including the following:

1. Read all instructions before using this heater.

2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If

provided, use handles when moving this heater. Keep combustible materials, such as

furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front

of the heater and keep them away from the sides and rear.

3. Extreme caution is necessary when any heater is used by or near children or invalids and

whenever the heater is left operating and unattended.

4. Always unplug heater when not in use.

5. Do not operate any heater with a damaged cord or plug or after the heater malfunctions,

has been dropped or damaged in any manner. Return heater to authorized service facility

for examination, electrical or mechanical adjustment, or repair.

6. Do not use outdoors.

7. This heater is not intended for use in bathrooms, laundry areas and similar indoor

locations. Never locate heater where it may fall into bathtub or other water container.

8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar

coverings. Arrange cord away from traffic area and where it will not be tripped over.

9. To disconnect heater, first turn controls to off, then remove plug from outlet.

10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this

may cause an electric shock or fire, or damage the heater.

11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use

on soft surfaces, like a bed, where openings may become blocked.

12. A heater has hot and arcing or sparking parts inside. Do not use it in the areas where

gasoline, paint, or flammable liquids are used or stored.

13. Use this heater only as described in this manual. Any other use not recommended by the

manufacturer may cause fire, electric shock, or injury to persons.

14. Avoid the use of an extension cord because the extension cord may overheat and cause a

risk of fire. However, if you have to use an extension cord, the cord shall be No. 14 AWG

minimum size and rated not less than 1875 watts.

15. This heater draws 12.5 amps during operation. To prevent overloading a circuit, do not

plug the heater into a circuit that already has other appliances working.

16. It is normal for the plug to feel warm to the touch; however, a loose fit between the AC

outlet (receptacle) and plug may cause overheating and distortion of the plug. Contact a

qualified electrician to replace loose or worn outlet.

17. The output of this heater may vary and its temperature may become intense enough to

burn exposed skin. Use of this heater is not recommended for persons with reduced

sensitivity to heat or an inability to react to avoid burns.

18.“SAVE THESE INSTRUCTIONS”

Heater

Model HF-0019

OPERATING INSTRUCTIONS

Place the heater on a firm level surface free from obstructions, and at least 3 ft. away from any

wall and any other objects such as furniture, curtains, plants or combustible material.

Insert the power plug into an AC supply socket.

Press the “POWER”button D, the unit will cycle as OFF-Standby-Low-High-Fan-OFF.

OFF— the unit is off and the display is off also;

Standby— the unit is off and the display shows the environment temp. You can set

Timer on.

Low-- the heater operates at low power.

High-- the heater operates at high power.

Fan— The Fan circulates room air only. The heating elements are “OFF”.



If the heater turns on first time, it will be on for two minutes automatically.

The ∧or ∨button Band Ccan be used to adjust Timer and the desired temperature.

Please see the following fig:

How to use the Timer: this heater has a 8-hour-timer, which can automatically turn the

unit ON when it is in Standby mode, or turn the unit OFF when it is LO,HI or FAN mode.

TIMER ON: When the heater is Standby mode (the unit doesn’t work but the display is

on), press the Timer button, the buzzer sounds, the symbol

will illuminate, it shows the time on the display. Press ∧or ∨button Band Cone time,

the buzzer sounds, and the time add or reduce 0.5 hours. It will be automatically turns on

at the time you set.

For example: it is now 6:00 AM. If you want the heater turns on at 11:30 AM, firstly you

press the POWER button to select Standby mode. Then press Timer button and ∧or ∨

button to adjust to 5.5. Now the heater will turn on after 5.5 hours. That is to say, it will

automatically be on at 11:30 AM.

TIMER OFF: when the heater is on LOW,HIGH or FAN mode, press the Timer button, the

buzzer sounds, it shows the timer on display. Press∧or ∨button Band Cto adjust your

desired time to shut off the unit automatically.

Note: If the timer is on, the symbol illuminate. At this time, if you press the POWER

button, the timer will be cancelled and the unit work will be the status as you select OFF,

Standby,Low,High or Fan.

How to set Temperature: If the heater has not any control for over 5 seconds, the display

will show the environmental temperature. At this time, press ∧or ∨button to set your

desired temperature. The adjustable range is from 40oF to 95oF.

If the set temperature is higher than room temperature, the unit works normally; if the set

temperature is lower than room temperature, the display flashes, and the heating element

was turned off automatically, after a few seconds, the fan will be off. The heater will

resume until the room temperature gets lower than set temp.

Note: If press both ∧and ∨buttons, the oC and oF can be interchanged.

To turn on the Oscillation feature (optional), turn the Oscillation switch “ON”.

Note: If the fan was shut off, either because of by pressing POWER to select OFF or

Standby, or the unit was turn off automatically for high room temperature, the oscillation

will be off.

IMPORTANT!

Your heater is equipped with a polarized alternating current line plug (a plug having one blade wider

than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are

unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit,

contact your electrician to replace your outlet. DO NOT defeat the safety purpose of the polarized plug.

Parts and Name

Oscillation Switch Up Button Down Button

Power Timer

Timer

Power

Timer Off

ison

Timer On

is on

Up or Down key

If on

If standby

Thetimer cancelled

Up or Down key To adjust the desired temp

If on Low or High mode

LO HI

Power

Timer

SERVICE & SUPPORT

In the event of a warranty claim or if service is required for this heater, please contact us at the

following:

Toll Free: 866-876-4332

Email us at: [email protected]

For questions or comments, please write to:

2617 North Great Southwest Parkway

Grand Prairie, TX 75050, USA

For your records, staple your sales receipt to this manual and record the following:

DATE OF PURCHASE: ________________________________

________________________

PLACE OF PURCHASE:________________________________

________________________

SERIAL NUMBER:________________________________

___________________________

(STAPLE SALES RECEIPT HERE)

NOTE: PROOF OF PURCHASE IS REQUIRED FOR ALL

WARRANTY CLAIMS

ADDITIONAL FEATURES

This heater has additional features:

Front Safety Guards - prevent the front grill from touching the floor when the heater is

tipped over forward.

Convenient Carry Handle – allows for easy transport from room to room.

TROUBLESHOOTING

If your heater fails to operate, please follow these instructions:

Ensure your set temperature is higher than the circumstance temperature.

Ensure that your circuit breaker or fuse is working properly.

Be sure the heater is plugged in and that the electrical outlet is working properly.

Check for any obstruction. If you find any obstruction, turn the heater “OFF”. Unplug

the heater and wait a few minutes for it to cool down. Carefully remove the obstruction.

Plug the heater in and turn it on again by referring to the OPERATING INSTRUCTIONS.

NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEE THE WARRANTY

INFORMATION FOR INSTRUCTIONS. PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER

YOURSELF. DOING SO MAY VOID THE WARRANTY AND COULD CAUSE DAMAGE OR PERSONAL

INJURY. IF THE PROBLEM STILL PERSISTS, PLEASE CONTACT US BY REFERRING TO THE

SERVICE & SUPPORT INFORMATION ON THE FOLLOWING PAGE.

CLEANING AND STORAGE

It is recommended that the heater be cleaned at least one time during the operating season in

order to provide the optimum level of performance. ALWAYS TURN THE POWER SWITCH OFF

AND UNPLUG THE HEATER BEFORE CLEANING.Be sure to save the box for off-season storage.

Turn the heater “OFF”, unplug it and wait for the heater to cool down.

Use a dry cloth to clean only external surfaces of the heater.

Do not use any cleaning agents or detergents.

Never immerse the heater in water.

Pack the heater in the original carton and store it in a cool and dry place.

SPECIFICATIONS

Model No.: HF-0019

Voltage: 120V, 60Hz

Current: Maximum continuous draw: 12.5 Amps.

Output: 5200 BTUs

Power: Low=900 Watts, Hi=1500 Watts

Tolerances on all specifications: not exceeded than 105%

ONE (1) YEAR LIMITED WARRANTY

Please read all instructions before attempting to use this product.

Please return the Warranty Registration card within fifteen (15) days from the date of

purchasing this product.

PELONIS warrants as limited herein to the original purchaser of retail that each new Pelonis

Fan Forced heater, shall be free of defects in material and workmanship for a period of one (1)

year from the date of original purchase. This one (1) year warranty is limited to the heating

elements, motor, and electric control circuit board.

In the event of malfunctions or failure of your Pelonis Fan Forced heater, simply deliver or send

the heater, postage prepaid along with PROOF OF PURCHASE, within the warranty period of one

(1) year, to PELONIS.PELONIS reserves the right to inspect the claimed defective part or parts

to determine if the defect or malfunction complaint is covered by this warranty. PELONIS shall,

within sixty (60) days after receipt of the product, at its option, repair and/or replace the

defective part or parts free of charge. This warranty shall only cover defects arising from normal

usage. PPELONIS assumes no responsibility whatsoever if the Fan Forced heater should fail

during the warranty period by reason of:

Misuse, negligence, physical damage or accidents.

Lack of maintenance (see instructions for proper maintenance).

Repair by any unauthorized party during the warranty period.

Damage caused by connection to an improper input voltage (see specification label on

your heater).

PELONIS makes no further warranties or representations, express or implied except those

contained herein. No representative or dealer is authorized to assume any other liability

regarding the Fan Forced heater. The duration of the implied warranty granted under State law,

including warranties of merchantability and fitness for particular purpose are limited in duration

should the duration of the express warranty grant it hereunder. PELONIS shall in no event be

liable for direct, indirect, special or consequential damages.

Some states do not allow limitations on how long an implied warranty lasts, and/or the above

limitations or exclusion may not apply to you. This warranty gives you specific legal rights and

you may have other rights which vary from state to state.

Table des matières

Autres manuels Pelonis Chauffage

Pelonis

Pelonis NY1506-18SRA Manuel utilisateur

Pelonis

Pelonis PFH15A2BGB Manuel utilisateur

Pelonis

Pelonis PSH750R Manuel utilisateur

Pelonis

Pelonis PSH700 Manuel utilisateur

Pelonis

Pelonis HC-0155M Manuel utilisateur

Pelonis

Pelonis NTK15A Manuel utilisateur

Pelonis

Pelonis HF-0063 Manuel utilisateur

Pelonis

Pelonis HT-0605 Manuel utilisateur

Pelonis

Pelonis NF15-9BMB Manuel utilisateur

Pelonis

Pelonis HF-1003 Manuel utilisateur

Pelonis

Pelonis PSH700S Manuel utilisateur

Pelonis

Pelonis NTY15-16LA Manuel utilisateur

Pelonis

Pelonis HV-1004 Manuel utilisateur

Pelonis

Pelonis HF-0063 Manuel utilisateur

Pelonis

Pelonis NTH15-17MR Manuel utilisateur

Pelonis

Pelonis 1500W-II Manuel utilisateur

Pelonis

Pelonis PSH750S Manuel utilisateur

Pelonis

Pelonis NT15-13L Manuel utilisateur

Pelonis

Pelonis PSH08F1ABBC Manuel utilisateur

Pelonis

Pelonis HC-350 Manuel utilisateur

Pelonis

Pelonis HF-0055 Manuel utilisateur

Pelonis

Pelonis PSH700G Manuel utilisateur

Pelonis

Pelonis PHTPU1501WC Manuel utilisateur

Pelonis

Pelonis HC-1010 Manuel utilisateur

Manuels Chauffage populaires d'autres marques

oventrop

oventrop Regucor Series Manuel utilisateur

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur

ELMEKO

ELMEKO ML 150 Manuel utilisateur

BN Thermic

BN Thermic 830T Manuel utilisateur

KING

KING K Series Mode d’emploi

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guide de démarrage rapide

Well Straler

Well Straler RC-16B Manuel utilisateur

EUROM

EUROM 333299 Manuel utilisateur

Heylo

Heylo K 170 Manuel utilisateur

Eterna

Eterna TR70W Manuel utilisateur

Clarke

Clarke GRH15 Mode d’emploi

IRSAP

IRSAP The Radiator Company Ovali Manuel utilisateur

Empire Heating Systems

Empire Heating Systems WCC65 Manuel utilisateur

Wetekom

Wetekom 92 86 43 Manuel utilisateur

Desa

Desa SPC170-F Manuel utilisateur

Watlow

Watlow Watrod Electric Tubular Heaters Manuel utilisateur

Haverland

Haverland ECO-DRY GPS Series Manuel de la liste des pièces

Stelpro

Stelpro ASILVC2060 Series Manuel utilisateur