Pelonis HF-0023 Manuel utilisateur
OWNER’S
MANUAL
Fan Forced
Area
Heater
PLEASE READ AND SAVE THESE INSTRUCTIONS
Model HF-0023
IMPORTANT INSTRUCTIONS
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce
the risk of fire, electric shock, and injury to persons, including the following:
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces
.
If provided, use handles when moving this heater. Keep combustible materials, such
as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from
the front of the heater and keep them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids
and whenever the heater is left operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Return heater to
authorized service facility for examination, electrical or mechanical adjustment, or
repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms, laundry areas and similar indoor
locations. Never locate heater where it may fall into bathtub or other water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Arrange cord away from traffic area and where it will not be tripped over.
9. To disconnect heater, first turn controls to off, then remove plug from outlet.
10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this
may cause an electric shock or fire, or damage the heater.
11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not
use on soft surfaces, like a bed, where openings may become blocked.
12. A heater has hot and arcing or sparking parts inside. Do not use it in the areas where
gasoline, paint, or flammable liquids are used or stored.
13. Use this heater only as described in this manual. Any other use not recommended by
the manufacturer may cause fire, electric shock, or injury to persons.
14. Avoid the use of an extension cord because the extension cord may overheat and
cause a risk of fire. However, if you have to use an extension cord, the cord shall be
No. 14 AWG minimum size and rated no less than 1875 watts.
15. This heater draws 12.5 amps during operation. To prevent overloading a circuit, do
not plug the heater into a circuit that already has other appliances working.
16. It is normal for the plug to feel warm to the touch; however, a loose fit between the AC
outlet (receptacle) and plug may cause overheating and distortion of the plug. Contact
a qualified electrician to replace loose or worn outlet.
17. The output of this heater may vary and its temperature may become intense enough to
burn exposed skin. Use of this heater is not recommended for persons with reduced
sensitivity to heat or an inability to react to avoid burns.
18.“SAVE THESE INSTRUCTIONS”
CAUTION:
This heater includes a Thermal Cut
-
Off Overheat Protection System that shuts the
heater off if it overheats due to abnormal conditions. If this occurs, turn the heater ”OFF”, unplug
it, and inspect and remove any objects on or adjacent to the heater. Allow it to cool for a few
minutes, plug it back in, and resume normal operation.
ADDITIONAL FEATURES
This heater has additional features:
Internal Safety Fuse - acts as back up protection to the Thermal Cut-Off Protection System.
Convenient Carry Handle – allows for easy transport from room to room.
TROUBLESHOOTING
If your heater fails to operate, please follow these instructions:
Ensure that your circuit breaker or fuse is working properly.
Be sure the heater is plugged in and that the electrical outlet is working properly.
Check for any obstruction. If you find any obstruction, turn the heater “ OFF” . Unplug the
heater and wait a few minutes for it to cool down. Carefully remove the obstruction. Plug
the heater in and turn it on again by referring to the OPERATING INSTRUCTIONS.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEE THE
WARRANTY INFORMATION FOR INSTRUCTIONS. PLEASE DO NOT ATTEMPT TO OPEN OR
REPAIR THE HEATER YOURSELF. DOING SO MAY VOID THE WARRANTY AND COULD
CAUSE DAMAGE OR PERSONAL INJURY. IF THE PROBLEM STILL PERSISTS, PLEASE
CONTACT US BY REFERRING TO THE SERVICE & SUPPORT INFORMATION ON THE
FOLLOWING PAGE.
CLEANING AND STORAGE
It is recommended that the heater be cleaned at least one time during the operating season in order to
provide the optimum level of performance. ALWAYS TURN THE POWER SWITCH OFF AND
UNPLUG THE HEATER BEFORE CLEANING. Be sure to save the box for off-season storage.
Turn the heater “ OFF” , unplug it and wait for the heater to cool down.
Use a dry cloth to clean only external surfaces of the heater.
Do not use any cleaning agents or detergents.
Never immerse the heater in water.
Pack the heater in the original carton and store it in a cool and dry place.
SPECIFICATIONS
Model No.: HF-0023
Voltage: 120V, 60Hz
Current: Maximum continuous draw: 12.5 Amps.
Output: 5200 BTUs
Power: LOW = 900 Watts, HIGH = 1500 Watts; LOW&OSC = 900 Watts,
HIGH&OSC = 1500 Watts
To
lerances on all specifications: Approximately +5%,
-
10%.
OPERATING INSTRUCTIONS
Place the heater on a firm level surface free from obstructions, and at least 3 ft. away
from any wall and any other objects such as furniture, curtains, plants or combustible
material.
With the Power and Setting Control “ A” in the ” OFF” position, plug the heater into a
grounded 120V outlet.
Turn the heater ” ON” by turning the Power and Setting Control “A” clockwise to your
desired power setting ( LOW, HIGH , LOW& OSC or HIGH & OSC). The Power
Indicator Light “ B” will illuminate. The power settings operate as follows:
LOW: The Fan and heating elements operate at 900 Watts.
HIGH: The Fan and heating elements operate at 1500 Watts.
LOW&OSC: The Fan and heating elements operate at 900 Watts.
HIGH&OSC: The Fan and heating elements operate at 1500 Watts.
Turn the Thermostat Control “D” to your desired setting from “ MIN” to “ MAX”. Turning
the thermostat clockwise will increase the “set” temperature; turning the thermostat
counterclockwise will decrease the “set” temperature.
B
C
Carry
Handle
IMPORTANT!
Your heater is equipped with a
polarized alternating current line plug
(a plug having one blade wider than
the other). This plug will fit into the
power outlet only one way. This is a
safety feature. If you are unable to
insert the plug fully into the outlet, try
reversing the plug. If the plug should
still fail to fit, contact your electrician to
replace your outlet. DO NOT defeat
the safety purpose of the polarized
plug.
Control Panel Functions
Power and Setting Control Power Indicator Light
Thermostat Control
A
B
C
A
SERVICE & SUPPORT
In the event of a warranty claim or if service is required for this heater, please contact us at the
following:
Tel: 866-876-4332 (M-F 8:30am to 5:30pm CST)
For questions or comments, please write to:
PELONIS.
2617 North Great Southwest Parkway
Suite 100
Grand Prairie, TX 75050, USA
For your records, staple your sales receipt to this manual and record the following:
DATE OF PURCHASE: ________________________________
________________________________
PLACE OF PURCHASE: ________________________________
________________________________
SERIAL NUMBER:________________________________
________________________________
(STAPLE SALES RECEIPT HERE)
NOTE: PROOF OF PURCHASE IS REQUIRED FOR
ALL WARRANTY CLAIMS
ONE (1) YEAR LIMITED WARRANTY
Please read all instructions before attempting to use this product.
Please return the Warranty Registration card within fifteen (15) days from the date of
purchasing this product.
PELONIS warrants as limited herein to the original purchaser of retail that each new Pelonis
Fan Forced heater shall be free of defects in material and workmanship for a period of one (1)
year from the date of original purchase. This one (1) year warranty is limited to the heating
elements, motor, and electric control circuit board.
In the event of malfunctions or failure of your Pelonis Fan Forced heater, simply deliver or send
the heater, postage prepaid along with PROOF OF PURCHASE, within the warranty period of
one (1) year, to PELONIS. PELONIS reserves the right to inspect the claimed defective part or
parts to determine if the defect or malfunction complaint is covered by this warranty. PELONIS
shall, within sixty (60) days after receipt of the product, at its option, repair and/or replace the
defective part or parts free of charge. This warranty shall only cover defects arising from normal
usage. PELONIS assumes no responsibility whatsoever if the Fan Forced heater should fail
during the warranty period by reason of:
Misuse, negligence, physical damage or accidents.
Lack of maintenance (see instructions for proper maintenance).
Repair by any unauthorized party during the warranty period.
Damage caused by connection to an improper input voltage (see specification label on
your heater).
PELONIS makes no further warranties or representations, express or implied except those
contained herein. No representative or dealer is authorized to assume any other liability
regarding the Fan Forced heater. The duration of the implied warranty granted under State law,
including warranties of merchantability and fitness for particular purpose are limited in duration
should the duration of the express warranty grant it hereunder. PELONIS shall in no event be
liable for direct, indirect, special or consequential damages.
Some states do not allow limitations on how long an implied warranty lasts, and/or the above
limitations or exclusion may not apply to you. This warranty gives you specific legal rights and
you may have other rights which vary from state to state.
Table des matières
Autres manuels Pelonis Chauffage
Pelonis
Pelonis PSH750R Manuel utilisateur
Pelonis
Pelonis HF-0055 Manuel utilisateur
Pelonis
Pelonis PSH23FT3DSBC Manuel utilisateur
Pelonis
Pelonis Safe-T FURNACE HC-445 Manuel utilisateur
Pelonis
Pelonis PHTPU1501WC Manuel utilisateur
Pelonis
Pelonis HC-0113 Manuel utilisateur
Pelonis
Pelonis PSH750S Manuel utilisateur
Pelonis
Pelonis HC-0119A Manuel utilisateur
Pelonis
Pelonis NTY15-16LA Manuel utilisateur
Pelonis
Pelonis PHT30D7BBC Manuel utilisateur
Pelonis
Pelonis HO-201 Manuel utilisateur
Pelonis
Pelonis HB-215T Manuel utilisateur
Pelonis
Pelonis PHTPU1501 Manuel utilisateur
Pelonis
Pelonis NTH15-17MR Manuel utilisateur
Pelonis
Pelonis HT-0605 Manuel utilisateur
Pelonis
Pelonis HC-1010 Manuel utilisateur
Pelonis
Pelonis HF-0019 Manuel utilisateur
Pelonis
Pelonis HC-350 Manuel utilisateur
Pelonis
Pelonis CH1001 Manuel utilisateur
Pelonis
Pelonis NT20-12D Manuel utilisateur
Manuels Chauffage populaires d'autres marques
oventrop
oventrop Regucor Series Manuel utilisateur
Blaze King
Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur
ELMEKO
ELMEKO ML 150 Manuel utilisateur
BN Thermic
BN Thermic 830T Manuel utilisateur
KING
KING K Series Mode d’emploi
Empire Comfort Systems
Empire Comfort Systems RH-50-5 Guide de démarrage rapide
Empire Heating Systems
Empire Heating Systems WCC65 Manuel utilisateur
Wetekom
Wetekom 92 86 43 Manuel utilisateur
Desa
Desa SPC170-F Manuel utilisateur
Watlow
Watlow Watrod Electric Tubular Heaters Manuel utilisateur
Haverland
Haverland ECO-DRY GPS Series Manuel de la liste des pièces
Stelpro
Stelpro ASILVC2060 Series Manuel utilisateur