Partner PT-6910 Series Manuel utilisateur

PT-6910 Series

User Manual

This publication, including all photographs, illustrations and software, is protected under international

reproduced without written consent of the author.

Disclaimer

The information in this document is subject to change without notice. The manufacturer makes no representa-

tions or warranties with respect to the contents hereof and specically disclaims any implied warranties of

merchantability or tness for any particular purpose. The manufacturer reserves the right to revise this publi-

cation and to make changes from time to time in the content hereof without obligation of the manufacturer to

notify any person of such revision or changes.

Trademark Recognition

All product names used in this manual are the properties of their respective owners and are acknowledged.

Federal Communications Commission (FCC)

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-

ence in a residential installation. This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

Reorient or relocate the receiving antenna.•

Increase the separation between the equipment and the receiver.•

Connect the equipment onto an outlet on a circuit different from that to which the receiver is connected.•

Consult the dealer or an experienced radio/TV technician for help.•

Shielded interconnect cables and a shielded AC power cable must be employed with this equipment to ensure

compliance with the pertinent RF emission limits governing this device. Changes or modications not ex-

pressly approved by the system’s manufacturer could void the user’s authority to operate the equipment.

Declaration of Conformity

This device complies with part 15 of the FCC rules. Operation is subject to the following conditions:•

This device may not cause harmful interference, and•

This device must accept any interference received, including interference that may cause undesired•

operation.

About this Manual

PT-6910 Series POS Terminal Models

This manual is for users of the PT-6910 Series. In the text we refer to any of these models as the PT-6910

Series, or to the specic model if there is a difference.

The manual consists of the following sections:

Chapter 1 Getting Started: This section covers unpacking and checking the

package contents, and identifying components.

Information on connecting peripheral devices, and

powering on is also provided.

Chapter 2 BIOS Setup Utility: The BIOS chapter provides information on navigating

and changing settings in the BIOS Setup Utility.

Chapter 3 Upgrading Components: This section provides information on upgrading

components.

Appendix: The appendix covers troubleshooting, information on

having the PT-6910 Series serviced, and technical

specications.

Safety information

Before installing and using the PT-6910 Series POS, take note of the following precautions:

Read all instructions carefully.•

Do not place the unit on an unstable surface, cart, or stand.•

Do not block the slots and opening on the unit, which are provided for ventilation.•

Do not push objects in the ventilation slots as they may touch high voltage components and result in•

shock and damage to the components.

The unit uses a three-wire ground cable, which is equipped with a third pin to ground the unit and•

prevent electric shock. Do not defeat the purpose of this pin. If your outlet does not support this kind of

plug, contact your electrician to replace your obsolete outlet.

Do not place anything on the power cord. Place the power cord where it will not be in the way of foot•

trafc.

Follow all warnings and cautions in this manual and on the unit case.•

When replacing parts, ensure that your service technician uses parts specied by the manufacturer. •

Avoid using the system near water, in direct sunlight, or near a heating device.•

WARNING

The system uses a 3V CR2032 battery mounted on the mainboard to

keep time. There is a risk of explosion if the wrong battery type is used

when replacing. Dispose of used batteries according to local ordinance

regulations.

CAUTION

The USB ports can be damaged if care is not taken when connecting

devices. Ensure USB devices are correctly inserted.

Plugging a phone line into the LAN port (RJ-45 connector) can damage

the connector. Take care only plug an RJ-45 connector into the LAN port.

Revision history

Version 1.0, November 2008

iii

TABLE OF CONTENTS

PT-6910 Series POS Terminal Models ......................................................... ii

CHAPTER 1 GETTING STARTED................................................ 1

PT-6910 Series POS Terminal Models .........................................................1

Unpacking ......................................................................................................1

Unpacking the Machine .................................................................................1

Checking the package contents ....................................................................2

Identifying components .................................................................................3

Removing the rear cover................................................................................7

Attaching the Customer Display (PT-6910 / PT-6915F).................................8

Attaching the Customer Display (PT-6915)....................................................9

Adjusting the Customer Display Angle (PT-6910 / PT-6915F) .....................10

Setup Considerations...................................................................................10

Connecting Peripheral Devices....................................................................11

Connecting a Cash Drawer..........................................................................12

Powering the PT-6910 Series On and Off....................................................13

CHAPTER 2 BIOS SETUP.......................................................... 15

About the Setup Utility .................................................................................15

Entering the Setup Utility ........................................................................16

BIOS Navigation Keys .............................................................................16

Using BIOS .............................................................................................17

Standard CMOS Features............................................................................18

Advanced BIOS Features ............................................................................20

CPU Feature ................................................................................................21

Hard Disk Boot Priority.................................................................................22

Advanced Chipset Features.........................................................................23

Integrated Peripherals..................................................................................25

►OnChip IDE Device .............................................................................26

►Onboard Device ..................................................................................28

►SuperIO Device...................................................................................29

Power Management Setup...........................................................................30

PnP/PCI Congurations ...............................................................................32

► IRQ Resources....................................................................................33

PC Health Status..........................................................................................34

Frequency/Voltage Control...........................................................................35

Other BIOS Options .....................................................................................36

CHAPTER 3 UPGRADING COMPONENTS............................... 39

Safety and Precautions ...............................................................................39

Before You Begin ........................................................................................40

Installing a hard disk drive ...........................................................................40

Installing a CompactFlash card (PT-6910 / PT-6915F)................................42

APPENDIX .................................................................................. 44

Troubleshooting ...........................................................................................44

Tips for Troubleshooting...............................................................................44

The Power-On Self Test...............................................................................44

Beep Errors at POST ...................................................................................44

Beep Message Errors at POST ...................................................................45

General Problems .......................................................................................46

Having the PT-6910 Series Serviced ..........................................................47

Specications...............................................................................................48

CHAPTER 1

GETTING STARTED

PT-6910 Series POS Terminal Models

This manual is for users of the PT-6910 Series. In the text we refer to any of these models as the PT-6910

Series, or to the specic model if there is a difference.

Unpacking

This chapter describes the procedures from unpacking the PT-6910 Series POS, to powering it on. The follow-

ing topics are described.

Unpacking the machine on page• 1

Checking the package contents on page• 2

Identifying components on page• 3

Removing the rear cover on page 7•

Attaching the customer display on page 8•

Adjusting display angles o• n page 8

Connecting peripheral devices on page 10•

Connecting a cash drawer on page 11•

Powering the PT-6910 Series on and off on page 12•

Unpacking the Machine

The machine and cable accessories are packed in a cardboard carton with foam padding for protection during

shipping.

Figure 1.1 Unpacking the

machine

Carefully unpack the machine and keep the packing materials. If you need to ship it in the future, repack it

as shown in Figure 1.1.

2 CHAPTER 1 GETTING STARTED

Checking the package contents

After you unpack the device check that the following items are included.

If any item is missing or appears damaged, contact your dealer immediately.

PT-6910 Series (Some units ship with

customer display and MSR installed.

Power Adapter

Power Cable

MSR (optional)

Customer Display (optional)

System QIG

System

QIG

CF Card Reader (optional)

1. User Manual and Driver CD

2. WEPOS Recovery DVD (optional)

Identifying components

This section describes the parts and connectors on the machine.

Front-right view

Figure 1.2 Front-right view

Component Description

1 15-inch TFT LCD touch screen

2 Power Button

3 USB Cover

4 Green Power indicator LED

5 Amber Hard drive activity LED

13452

USB Cover

4 CHAPTER 1 GETTING STARTED

Rear view

Figure 1.3 Rear view

Component Description

1 Heat sink rear cover (PT-6915)

2 CompactFlash card cover

3 Rear cover

4 Rear cover latches

PT-6915 PT-6910 / PT-6915F

Autres manuels pour PT-6910 Series

Table des matières

Autres manuels Partner Terminal tactile

Partner

Partner A4-1-K Manuel utilisateur

Partner

Partner PT-6212-EB Manuel utilisateur

Partner

Partner SP-600-A Manuel utilisateur

Partner

Partner WT-100 Manuel utilisateur

Partner

Partner SP-850-S Manuel utilisateur

Partner

Partner SP-1000-BZ Manuel utilisateur

Partner

Partner SP-1000 Manuel utilisateur

Partner

Partner SP-3511 Manuel utilisateur

Partner

Partner E5-1-K Manuel utilisateur

Partner

Partner SP-5514 Manuel utilisateur

Partner

Partner OT-310 Manuel utilisateur

Partner

Partner PT-6200 Manuel utilisateur

Partner

Partner SP-850-S Manuel utilisateur

Partner

Partner PT-1630 Manuel utilisateur

Partner

Partner C10-1E Manuel utilisateur

Partner

Partner SP-550 Manuel utilisateur

Partner

Partner SP-1000-C Manuel utilisateur

Partner

Partner Themis TI-890 Manuel utilisateur

Partner

Partner SP-630-Q Manuel utilisateur

Partner

Partner PT-6210-E Manuel utilisateur

Partner

Partner OT-310 Manuel utilisateur

Partner

Partner PT-5900 Manuel utilisateur

Partner

Partner PT-5910 Manuel utilisateur

Partner

Partner PT-1300 Manuel utilisateur

Manuels Terminal tactile populaires d'autres marques

Wincor Nixdorf

Wincor Nixdorf iPOS plus Advanced Manuel utilisateur

Ingenico

Ingenico AXIUM EX4000 Manuel utilisateur

Heisei Electronics

Heisei Electronics Q-POS 815 Manuel utilisateur

Amano

Amano MTX-15 Manuel utilisateur

FLOWBIRD

FLOWBIRD CWT Compact Touch Manuel utilisateur

Demco

Demco SP7 Manuel utilisateur

Lathem

Lathem PC600 Series Manuel utilisateur

NCR

NCR RealPOS 7460-2 Manuel

Simrad

Simrad MS50 Instructions de montage

Unitech

Unitech MR350 MKII Guide de démarrage rapide

Jungheinrich

Jungheinrich WMT 210 Manuel utilisateur

Motorola

Motorola MTP850 Manuel utilisateur

YASKAWA

YASKAWA 62H-MDC0 Manuel utilisateur

MVG industries

MVG industries NeptuLink Manuel utilisateur

Price Industries Limited

Price Industries Limited FDC Manuel d'instructions

Honeywell

Honeywell TemaKey Manuel utilisateur

EBN

EBN BPC65-B-A16G Manuel utilisateur

Prestel

Prestel VCS-G2PRO Manuel utilisateur