Panasonic SH-ALL1C Manuel utilisateur

SQT0184-4

until

2014/03/24

Owner’s Manual

Network Audio Connector

Model No. SH-ALL1C

Thank you for purchasing this product.

Please read these instructions carefully before using this product,

and save this manual for future use.

- 2 -

Table of contents

Accessories........................................................................................ 3

Unit care............................................................................................. 4

Control reference guide...................................................................... 5

Indicator illumination .......................................................................... 6

Connections ....................................................................................... 8

Network settings............................................................................... 12

Enjoying music ................................................................................. 19

Firmware updates ............................................................................ 23

Others .............................................................................................. 24

Troubleshooting................................................................................ 27

Specifications ................................................................................... 30

How to use this manual

Click/Tap this icon to jump to “Table of contents”.

≥Pages to be referred to are indicated as “l±±”. You can jump to the

corresponding page by clicking/tapping this.

- 3 -

Accessories



≥Do not use AC power supply cord (AC mains lead) with other equipment.

≥Product numbers provided in this owner’s manual are correct as of May 2014.

These may be subject to change.

1 AC power supply cord (AC mains lead)

(K2CB2CB00022)

(K2CT2YY00097)

(K2CQ2YY00119)

(K2CJ2YY00101)

1 Audio cable

(K2KYYYY00242)

2 Stands

(RYQ1443-K1)

For the United Kingdom and Ireland

For Continental Europe

For Australia and New Zealand

- 4 -

Unit care

Clean this unit with a soft, dry cloth.

≥Never use alcohol, paint thinner or benzine to clean this unit.

≥Before using chemically treated cloth, carefully read the cloth’s instructions.

∫To dispose or transfer this unit

The unit may keep the user settings information in the unit. If you discard

this unit either by disposal or transfer, then follow the procedure to return

all the settings to the factory defaults to delete the user settings.

(l27, “To return all settings to the factory defaults”)

≥The operation history may be recorded in the memory of this unit.

Disposal of Old Equipment

Only for European Union and countries with recycling

systems

This symbol on the products, packaging, and/or

accompanying documents means that used electrical and

electronic products must not be mixed with general household

waste.

For proper treatment, recovery and recycling of old products,

please take them to applicable collection points in accordance

with your national legislation.

By disposing of them correctly, you will help to save valuable

resources and prevent any potential negative effects on

human health and the environment.

For more information about collection and recycling, please

contact your local municipality.

Penalties may be applicable for incorrect disposal of this

waste, in accordance with national legislation.

- 5 -

Control reference guide

1Mode switch [MODE]

Set the downsampling setting (l24)/

Turn the beep sound on/off (l25)

2WPS pairing switch [-WPS]

Enter WPS pairing mode (l16) / firmware update mode (l23)

3Standby/on switch [Í/I]

Touch to switch the unit from on to standby mode or vice versa. In standby

mode, the unit is still consuming a small amount of power.

4Mode indicator (amber)

5Network indicator (blue/red)

6Operation indicator (amber)

–WPS

MODE

: Touch area

- 6 -

Indicator illumination

The indicator patterns illustrated below are displayed during normal

operational conditions.

Indicator Description

Operation indicator (amber) Blinks once

≥The unit detects the switch touched.

Blinks twice

≥The unit detects a valid operation

performed by touching and holding

the switch.

Mode indicator (amber) Blinks once

≥The following setting is turned on.

“Downsampling” (l24)

“Operation sound setting” (l25)

– When the setting is turned off, it blinks

twice.

Blinks

≥It may blink when the unit turns to

standby mode.

– Do not disconnect the AC power

supply cord (AC mains lead). Doing

so may cause malfunction or

damage.



≥The mode indicator also blinks when

the volume is changed on the app.

(l19)

–WPS

MODE

–WPS

MODE

- 7 -

Indicator Description

Network indicator (blue/red) Blinks alternately

≥The unit is carrying out an internal

process.

– Wait for maximum of approximately

60 seconds before the blinking stops.

– Do not disconnect the AC power

supply cord (AC mains lead). Doing

so may cause malfunction or

damage.

Network indicator (blue) Blinks slowly

≥The unit is ready for network setup.

(l12)

Blinks

≥The unit is waiting for the WPS

connection. (l16)

Blinks fast

≥The unit is waiting for the WPS PIN

code connection. (l16)

Network indicator (blue) Lights up

≥The unit is connected to the

network.

Network indicator (red) Blinks

≥The unit is connecting to the

network.

– When the network connection cannot

be established, the blinking keeps

going. Check the network connection.

(l12)

–WPS

MODE

–WPS

MODE

–WPS

MODE

–WPS

MODE

–WPS

MODE

- 8 -

Connections

You can enjoy music from a device on the network by using this unit.

At first, you must connect an audio system, amplifier or receiver, etc. to

this unit.

This unit can be installed either vertically or horizontally.

∫Horizontal

Install the unit with the rubber feet side down as shown below.

STEP1: Installation

Ex. Connecting to an audio system

Rubber feet

- 9 -

∫Vertical

Place the stands and fit the unit into them.

Install the unit with the AllPlay

icon side up.

Stands (supplied)

Rubber feet

When placing the stands, align

them with the rubber feet.

Stands (supplied)

- 10 -

Connect an audio system, amplifier or receiver, etc. to this unit using an

audio cable (supplied) or an optical cable (not supplied).

∫Using an audio cable (supplied)

∫Using an optical cable (not supplied)



≥For details, refer to the operating instructions of the connected device.

STEP2: Connecting to an audio system, etc.

AUDIO OUT

AUDIO IN AUDIO OUT L

Audio cable (supplied)

Optical cable (not supplied)

Autres manuels pour SH-ALL1C

Table des matières

Autres manuels Panasonic Matériel réseau

Panasonic

Panasonic Transistors 2SC4562G Manuel utilisateur

Panasonic

Panasonic Switching Diodes MA2Z001 Manuel utilisateur

Panasonic

Panasonic i-pro WJ-NT314 Manuel utilisateur

Panasonic

Panasonic Transistors 2SC5846 Manuel utilisateur

Panasonic

Panasonic PIN diodes MA27P02 Manuel utilisateur

Panasonic

Panasonic Transistors 2SB1218G Manuel utilisateur

Panasonic

Panasonic Transistors 2SC1318 Manuel utilisateur

Panasonic

Panasonic WU-SX04 Manuel utilisateur

Panasonic

Panasonic Photo IC PNA4601M Manuel utilisateur

Panasonic

Panasonic WJ-PB85M16 Manuel utilisateur

Panasonic

Panasonic Transistors 2SC4691J Manuel utilisateur

Panasonic

Panasonic Schottky Barrier Diodes MA3Z7930G Manuel utilisateur

Panasonic

Panasonic Schottky Barrier Diodes MA3X727 (MA727) Manuel utilisateur

Panasonic

Panasonic Schottky Barrier Diodes MA24D70 Manuel utilisateur

Panasonic

Panasonic K-NL404K/G Manuel utilisateur

Panasonic

Panasonic PIN Photodiodes PNZ334 (PN334) Manuel utilisateur

Panasonic

Panasonic CZ-CFUSCC1 Manuel utilisateur

Panasonic

Panasonic Transistors 2SC3935 Manuel utilisateur

Panasonic

Panasonic Schottky Barrier Diodes MA24D60 Manuel utilisateur

Panasonic

Panasonic TY-FB8HM Manuel utilisateur

Panasonic

Panasonic Transistors 2SB1722G Manuel utilisateur

Panasonic

Panasonic WJNT204 - NETWORK IF UNIT Manuel utilisateur

Panasonic

Panasonic Schottky Barrier Diodes MA2SD32 Manuel utilisateur

Panasonic

Panasonic Transistor 2SC5378 Manuel utilisateur

Manuels Matériel réseau populaires d'autres marques

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manuel utilisateur

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manuel utilisateur

Yudor

Yudor YDS-16 Manuel utilisateur

D-Link

D-Link ShareCenter DNS-320L Manuel utilisateur

Samsung

Samsung ES1642dc Instructions d'utilisation

Honeywell Home

Honeywell Home LTEM-PV Instructions de montage

evertz

evertz 7700 Series Manuel utilisateur

D-Link

D-Link ShareCenter DNS-343 Manuel utilisateur

Asante

Asante AsanteBridge 1012 Manuel utilisateur

FireBrick

FireBrick FB2700 Manuel utilisateur

Audiovox Electronics

Audiovox Electronics ARWH2T Manuel utilisateur

ADC

ADC DSX-1 Manuel

NetComm

NetComm NF2 Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 5620 Manuel utilisateur

Dell EMC

Dell EMC XC6420 Series Manuel utilisateur

Lanner

Lanner NCA-1020A Manuel utilisateur

Allied Telesis

Allied Telesis AT-TN121-A Manuel utilisateur

Arista

Arista CCA-ETM-Q12 Manuel utilisateur