Norac UC5 Topcon X30 Manuel utilisateur
Generic Unit
Installation Manual
GN01
Printed in Canada
Copyright 2009 by NORAC Systems International Inc.
Reorder P/N: UC5-BC-GN01-INST Rev L (Generic Unit)
NOTICE: NORAC Systems International Inc. reserves the right to improve products and their specifications without notice and
without the requirement to update products sold previously. Every effort has been made to ensure the accuracy of the information
contained in this manual. The technical information in this manual was reviewed at the time of approval for publication.
Contents
1Introduction................................................................................................................ 1
2Technical Specifications ............................................................................................ 2
3General UC5 System Layout.................................................................................... 3
4Kit Parts ...................................................................................................................... 4
5Pre-Install Checklist................................................................................................... 9
6Ultrasonic Sensor Installation ................................................................................ 10
7Roll Sensor Installation............................................................................................ 15
8Module Installation .................................................................................................. 21
9Connecting the Sensors to the CANbus ............................................................... 26
10Hydraulic Installation .............................................................................................. 27
11Software Setup......................................................................................................... 32
12Cable Drawings ........................................................................................................ 33
1
1Introduction
Congratulations on your purchase of the NORAC UC5 Spray Height Control System. This
system is manufactured with top quality components and is engineered using the latest
technology to provide operating reliability unmatched for years to come.
When properly used the system can provide protection from sprayer boom damage, improve
sprayer efficiency, and ensure chemicals are applied correctly.
Please take the time to read this manual completely before attempting to install the system. A
thorough understanding of this manual will ensure that you receive the maximum benefit from
the system.
Your input can help make us better! If you find issues or have suggestions regarding the parts
list or the installation procedure, please don’t hesitate to contact us.
Every effort has been made to ensure the accuracy of the information contained in
this manual. All parts supplied are selected to specially fit the sprayer to facilitate
a complete installation. However, NORAC cannot guarantee all parts fit as
intended due to the variations of the sprayer by the manufacturer.
Please read this manual in its entirety before attempting installation.
2
2Technical Specifications
CAN ICES-3(A)/NMB-3(A)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at their
own expense.
This Class A digital apparatus complies with Canadian ICES-003.
Pursuant to EMC Directive – Article 9, this product is not intended for residential use.
Table 1: System Specifications
Supply Voltage (rated)
12VDC
Supply Current (rated)
10
A
Hydraulic Pressure (ma
x
imum)
3300 psi
Baud Rate 250 kbps
Clock Frequency (maximum)
96 MHz
Solenoid Valve PWM Frequency
300 Hz
Ultrasonic Sensor Transmit Frequency
50 kHz
Operating Temperature Range
0°C to 80°C
3
3General UC5 System Layout
Figure 1 and Figure 2 illustrate the general layout of the UC5 system components:
Figure 1: General UC5 System Layout (Self Propel Type)
Figure 2: General UC5 System Layout (Pull Type)
4
4Kit Parts
The following diagrams illustrate the GN01 kit specific parts of the NORAC UC5 system.
Interface cables, power cables, hoses and fittings are shown in this manual and may not be
included. Cables are available separately from NORAC. Please refer to the UC5 Generic
Cable Ordering Guide (P/N: UC5-BC-CABLE-GUIDE) for cable ordering information (available
at www.norac.ca).
4.1 Kit Overview
Figure 3: GN01 System Parts
* Interface and Power cables must be ordered separately.
5
4.2 Hydraulic Plumbing: Single Acting
Figure 4: GN01 Hydraulic Plumbing: Single Acting
* Hydraulic hoses and some fittings must be ordered separately.
6
4.3 Hydraulic Plumbing: Double Acting
Figure 5: GN01 Hydraulic Plumbing: Double Acting
* Hydraulic hoses and some fittings must be ordered separately.
7
4.4 List of Parts
Item Part Number Name Quantity
B05 44706-01 KIT CABLE TIE BLACK 10 PCS 21 IN 150 PCS 7.5 IN 1
B20 44971 SENSOR MOUNTING BRACKET LOW PROFILE 16GA 2
B21 44973 SENSOR MOUNTING BRACKET LOW PROFILE 16 GA LARGE FLANGE 1
C01 43220-10 CABLE UC5 NETWORK 14 AWG 10M 1
C02 43220-01 CABLE UC5 NETWORK 14 AWG 1M 2
C03 43220-03 CABLE UC5 NETWORK 14 AWG 3M 1
C05 43210-20 CABLE UC5 NETWORK 18 AWG 20M 2
C10 43230-04 CABLE UC5 VALVE 2PIN DT TO 2PIN DT 4
E01 43710 UC5 CONTROLLER MODULE 1
E02 43720 UC5 VALVE MODULE 1
E03 43732 UC5 INPUT MODULE PASS THRU 1
E04 43741 UC5 ROLL SENSOR VER. 2 2
E05 43750 UC5 ULTRASONIC SENSOR 3
E11 43765 UC5 NETWORK COUPLER 8-WAY 1
E12 43764 UC5 NETWORK COUPLER 2-WAY 1
E20 43764T UC5 NETWORK COUPLER 2-WAY WITH TERMINATOR 2
H10 44865-34 HYDRAULICS FITTING KIT - GN1 1
M02 UC5-BC-GN01-INST MANUAL INSTALLATION UC5 GENERIC UNIT 1
P01 106034 UC5 NETWORK 2 PIN PLUG 4
P02 106602 UC5 NETWORK 12 PIN PLUG (A-KEY) 1
P03 105882 UC5 NETWORK 6 PIN PLUG 2
V01 44963D VALVE BLOCK ASSEMBLY 2 STATION CC/LS PROP DT 4 BOLT 1
Autres manuels pour UC5 Topcon X30
55
Table des matières
Autres manuels Norac Contrôleurs
Norac
Norac UC4+ Manuel utilisateur
Norac
Norac UC4+ Manuel utilisateur
Norac
Norac UC5 Topcon X30 Manuel utilisateur
Norac
Norac UC4+ Roll Control Manuel utilisateur
Norac
Norac FLEXI-COIL 67 Series Manuel utilisateur
Norac
Norac UC4+ Hardi OEM Manuel utilisateur
Norac
Norac UC5-BC-JD11 Manuel utilisateur
Norac
Norac UC5 Topcon X30 Manuel utilisateur
Norac
Norac UC4+ 1200/1600 Manuel utilisateur
Norac
Norac UC4 Plus Rogator 64 Series Manuel utilisateur
Norac
Norac UC4+ Manuel utilisateur
Norac
Norac UC4+ Manuel utilisateur
Norac
Norac UC4+ Mode d’emploi
Norac
Norac UC5 Topcon X30 Manuel utilisateur
Norac
Norac UC5 Topcon X30 Manuel utilisateur
Norac
Norac UC5 Topcon X30 Manuel utilisateur
Norac
Norac UC5 Topcon X30 Manuel utilisateur
Norac
Norac UC5 Topcon X30 Manuel utilisateur
Norac
Norac UC4+ SPRACOUPE 4000 Series Manuel utilisateur
Norac
Norac UC5 Topcon X30 Manuel utilisateur
