Nibe F2040 Series Guide de l'utilisateur
Installer manual
LEK
LEK
LEK
NIBE™ F2040
8, 12, 16 kW
Air/water heat pump
IHB GB 1335-2
231844
Table of Contents
1 Important information 2
Safety information 2
2 Delivery and handling 6
Transport and storage 6
Assembly 6
Supplied components 8
Removing the covers 9
Removing the front panel 9
Removing the side panel 10
3 The heat pump design 11
General 11
Electrical connection 16
4 Pipe connections 19
General 19
Pipe coupling heating medium circuit 19
Docking alternatives 21
5 Electrical connections 22
General 22
Connections 24
6 Commissioning and adjusting 30
Preparations 30
Filling and venting the heating medium sys-
tem 30
Compressor heater 30
Start-up and inspection 31
Readjusting, heating medium side 32
Adjustment, charge flow 33
7 Disturbances in comfort 34
Troubleshooting 34
8 Accessories 38
9 Technical data 40
Dimensions and setting-out coordinates 40
Sound pressure levels 42
Technical specifications 43
Electrical circuit diagram 46
Item register 52
1Table of Contents |NIBE™ F2040
Safety information
This manual describes installation and service proced-
ures for implementation by specialists.
This appliance can be used by children
aged from 8 years and above and per-
sons with reduced physical, sensory or
mental capabilities or lack of experience
and knowledge if they have been given
supervision or instruction concerning
use of the appliance in a safe way and
understand the hazards involved. Chil-
dren shall not play with the appliance.
Cleaning and user maintenance shall
not be made by children without super-
vision.
Rights to make any design or technical
modifications are reserved.
©NIBE 2013.
Symbols
NOTE
This symbol indicates danger to machine or
person.
Caution
This symbol indicates important information
about what you should observe when main-
taining your installation.
TIP
This symbol indicates tips on how to facilitate
using the product.
Marking
The CE marking means that NIBE ensures that the
product meets all regulations that are placed on it
based on relevant EU directives. The CE mark is obligat-
ory for most products sold in the EU, regardless where
they are made.
Serial number
The serial number for F2040 can be found on the side
of the foot.
F2040-8
LEK
DATA
Serial number
F2040-12
LEK
D ATA
Serial number
NIBE™ F2040Chapter 1 | Important information2
1 Important information
F2040-16
LEK
DATA
Serial number
Caution
Always give the product's serial number when
reporting a fault.
Country specific information
Installer manual
This installer manual must be left with the customer.
3Chapter 1 | Important informationNIBE™ F2040
Inspection of the installation
Current regulations require the heating installation to be inspected before it is commissioned. The inspection must
be carried out by a suitably qualified person. Fill in the page for information about installation data in the User
manual.
DateSignatureNotesDescription
✔
System flushed
System vented
Particle filter
Shut-off and drain valve
Charge flow set
Fuses property
Safety breaker
Communication cable connected
F2040 addressed (only when cascade
connection)
Miscellaneous
NIBE™ F2040Chapter 1 | Important information4
Contact information
KNV Energietechnik GmbH, Gahberggasse 11, 4861 SchörflingAT
Tel: +43 (0)7662 8963-0 Fax: +43 (0)7662 8963-44 E-mail: mail@knv.at www.knv.at
NIBE Wärmetechnik AG, Winterthurerstrasse 710, CH-8247 FlurlingenCH
Druzstevni zavody Drazice s.r.o, Drazice 69, CZ - 294 71 Benatky nad JizerouCZ
NIBE Systemtechnik GmbH, Am Reiherpfahl 3, 29223 CelleDE
Vølund Varmeteknik A/S, Member of the Nibe Group, Brogårdsvej 7, 6920 VidebækDK
NIBE Energy Systems OY, Juurakkotie 3, 01510 VantaaFI
AIT France, 10 rue des Moines, 67000 HaguenauFR
NIBE Energy Systems Ltd, 3C Broom Business Park, Bridge Way, Chesterfield S41 9QGGB
NIBE Energietechniek B.V., Postbus 2, NL-4797 ZG WILLEMSTAD (NB)NL
ABK AS, Brobekkveien 80, 0582 Oslo, Postadresse: Postboks 64 Vollebekk, 0516 OsloNO
NIBE-BIAWAR Sp. z o. o. Aleja Jana Pawła II 57, 15-703 BIAŁYSTOKPL
Tel: 085 662 84 90 Fax: 085 662 84 14 E-mail: sekretariat@biawar.com.pl www.biawar.com.pl
© "EVAN" 17, per. Boynovskiy, Nizhny NovgorodRU
NIBE AB Sweden, Box 14, Hannabadsvägen 5, SE-285 21 MarkarydSE
For countries not mention in this list, please contact Nibe Sweden or check www.nibe.eu for more information.
5Chapter 1 | Important informationNIBE™ F2040
Transport and storage
F2040 must be transported and stored vertically.
Assembly
႑Place F2040 outdoors on a solid level base that can
take the weight, preferably a concrete foundation.
If concrete slabs are used they must rest on asphalt
or shingle.
႑The concrete foundation or slabs must be posi-
tioned so that the lower edge of the evaporator is
at the level of the average local snow depth, al-
though a minimum of 300 mm.
႑The F2040 should not be positioned next to sensit-
ive walls, for example, next to a bedroom.
႑Also ensure that the placement does not inconveni-
ence the neighbours.
႑F2040 must not be placed so that recirculation of
the outdoor air can occur. This causes lower output
and impaired efficiency.
႑The evaporator should be sheltered from direct
wind. Place F2040 protected from wind against the
evaporator.
႑Large amounts of condensation water as well as
melt water from defrosting can be produced. Con-
densation water must be led off to a drain or similar
(see page 7).
႑Care must be exercised so that the heat pump is
not scratched during installation.
LEK
LEK
PLQ PP
0LQ PP
Do not place F2040 directly on the lawn or other non
solid surface.
If there is a risk of snow slip from roof, a protective roof
or cover must be erected to protect the heat pump,
pipes and wiring.
NIBE™ F2040Chapter 2 | Delivery and handling6
2 Delivery and handling
Condensation run off
Condensation water trough
The condensation water trough is used to collect and
lead away condensation water from the heat pump.
NOTE
It is important to the heat pump function that
condensation water is led away and that the
drain for the condensation water run off is not
positioned so that it can cause damage to the
house.
NOTE
Pipe with heating cable for draining the con-
densation water trough are not included.
NOTE
To ensure this function the accessory KVR 10
should be used.
NOTE
The electrical installation and wiring must be
carried out under the supervision of an author-
ised electrician.
NOTE
Self regulating heating cables must not be
connected.
Caution
If none of the recommended alternatives is
used good lead off of condensation water
must be assured.
႑The condensation water (up to 50 litres/day) collec-
ted in the trough should be routed by pipe to an
appropriate drain, it is recommended that the
shortest outdoor stretch possible is used.
႑The section of the pipe that can be affected by frost
must be heated by the heating cable to prevent
freezing.
႑Route the pipe downward from F2040.
႑The outlet of the condensation water pipe must be
at a depth that is frost free or alternatively indoors
(with reservation for local ordinances and regula-
tions).
႑Use a water trap for installations where air circula-
tion may occur in the condensation water pipe.
႑The insulation must be tight against the bottom of
the condensation water trough.
Drain pan heater, control
The drain pan heater is supplied with power when one
of the following conditions is met:
1. Operating mode "Heating" or "Hot water" is activ-
ated.
2. The compressor has been in operation for at least
30 minutes after last start.
3. The ambient temperature is lower than 1 C.
Recommended alternatives
Stone caisson
LEK
Frostfrit
t
Frost proof depth
If the house has a cellar the stone caisson must be po-
sitioned so that condensation water does not affect
the house. Otherwise the stone caisson can be posi-
tioned directly under the heat pump.
The outlet of the condensation water pipe must be at
frost free depth.
7Chapter 2 | Delivery and handlingNIBE™ F2040
Drain indoors
Water seal
The condensation water is lead to an indoor drain
(subject to local rules and regulations).
Route the pipe downward from F2040.
The condensation water pipe must have a water seal
to prevent air circulation in the pipe.
Gutter drainage
Frostfritt
djup
LEK
Frost proof depth
Water seal
The outlet of the condensation water pipe must be at
frost free depth.
Route the pipe downward from F2040.
The condensation water pipe must have a water seal
to prevent air circulation in the pipe.
Installation area
The distance between F2040 and the house wall must
be at least 150 mm. Clearance in front of F2040 should
be at least one metre.
3000 mm
400 mm
Minimalt
fritt utrymme
Minimalt
fritt utrymme
Fritt utrymme
framför
150 mm
Fritt
utrymme
bakom
600mm
Minimum
free space
Minimum
free space
Free
space
behind
400 mm 600 mm
150 mm
3000 mm
Free space
in front
Supplied components
LEK
Particle filter R25 (HQ1).
2 flexible hoses (R25) with
4 seals
NIBE™ F2040Chapter 2 | Delivery and handling8
Autres manuels pour F2040 Series
6
Ce manuel convient aux modèles suivants
3
Table des matières
Autres manuels Nibe Pompe à chaleur
Nibe
Nibe S1155 Guide de l'utilisateur
Nibe
Nibe FIGHTER 1220 Manuel utilisateur
Nibe
Nibe AG-WT10 series Guide de l'utilisateur
Nibe
Nibe F730 Guide de l'utilisateur
Nibe
Nibe F750 Guide de l'utilisateur
Nibe
Nibe F1255 Series Manuel utilisateur
Nibe
Nibe F1355 Series Guide de l'utilisateur
Nibe
Nibe AG-WL10 series Guide de l'utilisateur
Nibe
Nibe ClimateMaster Tranquility TC L Series Manuel du propriétaire
Nibe
Nibe CLIMATEMASTER TRT Series Manuel du propriétaire
Nibe
Nibe F130 Manuel utilisateur
Nibe
Nibe F110 Manuel utilisateur
Nibe
Nibe F730 Guide de l'utilisateur
Nibe
Nibe F130 Manuel utilisateur
Nibe
Nibe F1126 Manuel utilisateur
Nibe
Nibe F110 Manuel utilisateur
Nibe
Nibe ERS 20-250 Guide de l'utilisateur
Nibe
Nibe F470 Manuel utilisateur
Nibe
Nibe FIGHTER 1110 Manuel utilisateur
Nibe
Nibe S2125 Guide de l'utilisateur
Manuels Pompe à chaleur populaires d'autres marques
Mitsubishi Electric
Mitsubishi Electric PUZ-SWM60VAA Manuel utilisateur
Dimplex
Dimplex LI 16I-TUR Guide de l'utilisateur
Carrier
Carrier WSHP Open v3 Guide de configuration rapide
TGM
TGM CTV14CN018A Manuel utilisateur
Carrier
Carrier 38MGQ Series Manuel utilisateur
Kokido
Kokido K2O K880BX/EU Guide de dépannage
