NETGEAR Stora Manuel utilisateur

Installation Guide

1. Check your Package Contents

Before starting the installation, check your package for the following items:

• NETGEAR Stora

• Power adapter

• Ethernet cable

• Installation guide

• Warranty card

• Resource CD

Note: If you purchased a diskless unit, or a unit with only one disk, first complete

and validate the installation before adding the disks. See Installing a Disk Drive for

installation instructions.

Before you begin....

Make sure that you have an Internet connection. When you have completed the

Stora installation, your network should resemble this illustration.

Estimated setup time: 15 minutes.

Note: See the NETGEAR® Stora User Manual to configure advanced features.

The link to the User Manual is on your Resource CD, and also on the NETGEAR

support site at http://kb.netgear.com/app/products/model/a_id/16165.

USB port

2. Connect the Stora to your Network

The router in your network needs to have an ethernet port available to connect the

Stora unit to the router via the Ethernet cable. Your router also needs to be

configured to automatically provide an IP address for your network devices.

1. Unpack the unit and stand it on its feet—

be sure it has ample ventilation.

Avoid putting the unit in a location where it

could be knocked over easily. Do not place

items on top of the Stora, or place any

liquids near or on top of the unit.

2. Connect one end of the provided Ethernet

cable to your router and the other end to

the back of the Stora unit.

3. Plug in the power adapter to a power

source and connect the other end to the

unit.

4. Press the On button on the back of your

unit. The blue light flickers while the unit

boots and obtains an IP address; then it

turns solid blue.

The LEDs on the Stora exhibit the following

behavior:

• Power indicator LED on the front:

- Solid blue: Stora unit has power and is running normally.

• Hard drive LEDs (HD1 and HD2) on the front:

- Solid green: Drive is operating normally.

- Solid amber: Indicates a problem with the drive.

- Blinking green: Indicates activity, such as copying data.

• Ethernet Connection LEDs on the back:

- Solid amber: Indicates a 10/100M connection.

- Solid green: Indicates a 1G connection.

- Blinking green or amber: Indicates link activity.

Power

supply

Ethernet

cable

3. Run the Setup Program on the CD

Running the setup program (on a Mac or PC) configures the device and makes it

ready for storing data. You also give your unit a unique name, and create your own

user name and password. Note: Mac screens might look different.

To run the Setup program:

1. Insert the Resource CD into your computer. Wait for the

Setup program to initialize—approximately 2 minutes.

The Welcome to Stora setup screen displays.

On a PC, if the CD does not start automatically, go to My

Computer and double-click StoraSetup.exe to start the

Setup program.

2. Select your language from the dropdown list.

3. Click Step 1, Set Up Your Stora.

4. When the software license agreement

displays, click I Accept.

5. When the Registration screen

displays, enter your product key,

which is located on the small label

attached to the CD sleeve.

6. Give your Stora a name and write it

here for future reference. Click Next.

Stora name: ___________________

7. In the provided fields, create your user

name and a password. Write them

here for reference.

User name: _____________________

Password: ______________________

8. Click Next and follow the onscreen

prompts to complete.

When the Setup screen redisplays, the

check box next to Set Up Your Stora

shows a green check mark indicating

that you have completed this step.

You can now exit and use the device.

NETGEAR® Stora

January 2011

This symbol was placed in accordance with the European Union Directive 2002/96 on the Waste

Electrical and Electronic Equipment (the WEEE Directive). If disposed of within the European Union,

this product should be treated and recycled in accordance with the laws of your jurisdiction

implementing the WEEE Directive.

trademarks of NETGEAR, Inc. in the United States and/or other countries. Other brand and product names are

trademarks or registered trademarks of their respective holders. Information is subject to change without notice.

Optional—Install the Stora Application

Once the initial setup is complete, you have the option to install the Stora

Application software now, or anytime once the initial setup is complete:

1. Click Step 2 Install Desktop Applications Software (Optional).

2. Follow the on-screen prompts.

Remote Access to your Stora

To remotely copy files to and from

your new Stora:

1. Go to http://www.mystora.com

and log in to your Stora device.

2. Enter the Stora name that you

created when you set up your

device.

3. Enter the user name and

password that you created

during setup.

For more information about remotely accessing your Stora, see the NETGEAR®

Stora User Manual on the Resource CD.

Installing a Disk Drive

If you purchased a NETGEAR Stora with no disk drives, or with only one installed

drive, and you want to add a second drive for redundancey, carefully follow these

instructions.

IMPORTANT! The second drive must be the same size as the first drive.

You can insert a second disk drive into the Stora without turning the unit off. The

Stora automatically detects the second drive and builds it as a “mirror drive.”

To add or remove a disk drive:

1. Remove the front cover of your Stora unit.

If you are replacing a drive, unlock it by

pulling down the latch on the back of the

unit. This releases the hard drive from the

locked position.

2. Insert the new hard drive.

a. The label on the drive needs to face the

outside of the unit.

b. Slide the disk into place in either slot

until it locks.

c. Replace the front cover.

3. The green LED on the front of the Stora

blinks continuously until the installed drive

build process is complete.

WARNING!! Stora formats hard drives differently than a computer does.

DO NOT swap hard drives between a Stora and a computer,

or your data will be lost.

Troubleshooting

• CD error message. An error message could display if 1) the Power LED is

not solid blue, 2) the Ethernet cables are not securely connected, or 3) your

computer is behind a firewall.

• Check the LEDs to verify correct operation. When powered on, the blue

Power button light is on. Green LEDs labeled 1 and 2 indicate which hard

drive is installed and detected. If the drive LED is amber, turn off the Stora

unit, and then turn it on again.

• Turn off your Stora correctly. To turn off your Stora, press the Power

button until the blue LED blinks (about 5 seconds).

• Verify the Ethernet connection. Make sure that your Ethernet cable is

securely connected to your router and to the Stora, and the LEDs on the

back of the Stora are lit.

• Turn off your firewall. Make sure that the computer accessing the Stora

does not have its firewall turned on. See the NETGEAR® Stora User Manual

on the Resource CD for information about turning off the firewall.

Technical Support

Thank you for selecting NETGEAR products.

After installing your device, locate the serial number on the label of your product and

use it to register your product at http://www.NETGEAR.com/register. Registration is

required before you can use the telephone support service. Registration via the

NETGEAR website is strongly recommended.

Go to http://kbserver.netgear.com for product updates and Web support.

For additional information about setting up, configuring, and using your Stora, see

the User Manual.

For complete DoC please visit the NETGEAR EU Declarations of Conformity

website at: http://kb.netgear.com/app/answers/detail/a_id/11621/

Autres manuels pour Stora

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels NETGEAR Matériel réseau

NETGEAR

NETGEAR ReadyNAS OS 6 Desktop Storage Systems Manuel utilisateur

NETGEAR

NETGEAR RNDP6310 - ReadyNAS Pro NAS Server Manuel utilisateur

NETGEAR

NETGEAR ProSafe ANT2409 Manuel utilisateur

NETGEAR

NETGEAR ProSecure UTM150 Manuel utilisateur

NETGEAR

NETGEAR ND508 - Network Drive - 8 GB Manuel utilisateur

NETGEAR

NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN... Manuel utilisateur

NETGEAR

NETGEAR ReadyNAS OS 6 Desktop Storage Systems Manuel utilisateur

NETGEAR

NETGEAR M4100 Series ProSAFE Manuel utilisateur

NETGEAR

NETGEAR RNRX4410 - ReadyNAS 2100 NAS Server Manuel utilisateur

NETGEAR

NETGEAR WMS5316 - ProSafe 16-AP Wireless Management... Manuel utilisateur

NETGEAR

NETGEAR GS716TP Manuel

NETGEAR

NETGEAR ProSafe UTM9S Guide de configuration rapide

NETGEAR

NETGEAR ANT24BDC - Power Injector For The 500 mW... Manuel utilisateur

NETGEAR

NETGEAR Nighthawk Mesh WiFi 6 System Manuel utilisateur

NETGEAR

NETGEAR SSL312-100NAS - ProSafe SSL312 SSL VPN Concentrator... Manuel utilisateur

NETGEAR

NETGEAR ReadyDATA 5200 Manuel utilisateur

NETGEAR

NETGEAR ProSafe AX742 Manuel utilisateur

NETGEAR

NETGEAR AXM751 - ProSafe XFP Transceiver Module Manuel utilisateur

NETGEAR

NETGEAR ReadyDATA 5200 Manuel utilisateur

NETGEAR

NETGEAR ANT24BNA Manuel utilisateur

NETGEAR

NETGEAR RNDP600E - ReadyNAS Pro Pioneer Edition NAS... Manuel utilisateur

NETGEAR

NETGEAR ProSecure UTM25S Manuel utilisateur

NETGEAR

NETGEAR UTM10 - ProSecure Unified Threat Management... Instructions d'installation et d'utilisation

NETGEAR

NETGEAR UTM5 - ProSecure Unified Threat Management... Manuel utilisateur

Manuels Matériel réseau populaires d'autres marques

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manuel utilisateur

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manuel utilisateur

Yudor

Yudor YDS-16 Manuel utilisateur

D-Link

D-Link ShareCenter DNS-320L Manuel utilisateur

Samsung

Samsung ES1642dc Instructions d'utilisation

Honeywell Home

Honeywell Home LTEM-PV Instructions de montage

evertz

evertz 7700 Series Manuel utilisateur

D-Link

D-Link ShareCenter DNS-343 Manuel utilisateur

Asante

Asante AsanteBridge 1012 Manuel utilisateur

FireBrick

FireBrick FB2700 Manuel utilisateur

Audiovox Electronics

Audiovox Electronics ARWH2T Manuel utilisateur

ADC

ADC DSX-1 Manuel

NetComm

NetComm NF2 Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 5620 Manuel utilisateur

Dell EMC

Dell EMC XC6420 Series Manuel utilisateur

Lanner

Lanner NCA-1020A Manuel utilisateur

Allied Telesis

Allied Telesis AT-TN121-A Manuel utilisateur

Arista

Arista CCA-ETM-Q12 Manuel utilisateur