Neomouv ELAIA Manuel utilisateur

USER MANUAL

ELAIA

THIS MANUAL CONTAINS IMPORTANT

SAFETY AND OPERATING INSTRUCTIONS

Model conforms to safety standards

ELAIA Manual

CONTENTS

1 - PRESENTATION..................................................................................................................................... 3

2 - ADJUSTMENTS/ASSEMBLY: .............................................................................................................. 4

2.1 Adjusting the saddle: ............................................................................................................................... 4

2.1.1 Angle: ............................................................................................................................................... 4

2.1.2 Height: .............................................................................................................................................. 4

2.2 Adjusting the handlebars and the stem: ................................................................................................... 5

2.3 Hydraulic brake adjustment:.................................................................................................................... 6

2.4 Rack: ........................................................................................................................................................ 7

2.5 Mounting and dismounting the wheels:................................................................................................... 8

2.5.1 Front wheel:...................................................................................................................................... 8

2.5.2 Rear wheel:....................................................................................................................................... 8

2.6 Lights: ...................................................................................................................................................... 9

3 - USING THE E-BIKE:............................................................................................................................ 10

3.1 Indexed gearshift: .................................................................................................................................. 10

3.2 Electronic gear shifting:......................................................................................................................... 10

3.3 Display and controls: ............................................................................................................................. 10

3.4 Electric assistance:................................................................................................................................. 11

3.4.1 Operation: ....................................................................................................................................... 11

3.4.2 Performance:................................................................................................................................... 11

3.4.3 Technical specifications of the power-assistance system:.............................................................. 11

3.4.4 Starting up the battery: ................................................................................................................... 12

3.5 The electric motor:................................................................................................................................. 12

4 - CHARGING THE BATTERY:............................................................................................................. 13

4.1 Charger................................................................................................................................................... 13

4.1.1 Precautions (safety instructions): ................................................................................................... 13

4.1.2 Protecting the charger:.................................................................................................................... 13

4.2 Battery.................................................................................................................................................... 13

4.2.1 Recommendations / precautions to take with your battery: ........................................................... 14

5 - TIPS FOR INCREASING THE BATTERY LIFE PER CHARGE:................................................. 15

6 - UPKEEP AND MAINTENANCE FOR ELAIA:................................................................................. 16

6.1 Upkeep:.................................................................................................................................................. 16

6.2 Lubrication:............................................................................................................................................ 16

6.3 Maintenance:.......................................................................................................................................... 16

7 - SAFETY – RECOMMENDATIONS: .................................................................................................. 17

8 - TECHNICAL DATA.............................................................................................................................. 18

9 - DECLARATION OF CE CONFORMITY .......................................................................................... 18

10 - CERTIFICATE OF CONFORMITY................................................................................................... 18

11 TERMS OF WARRANTY..................................................................................................................... 19

ELAIA Manual

1 -PRESENTATION

Thank you for choosing a NEOMOUV Electric-Assisted Bicycle (E-Bike)

E-Bike Presentation:

Notes:

•The symbol indicates important advice or essential safety measures. Follow the various instructions.

•Some adjustment and assembly/disassembly operations require special tools and expertise; perform

these only if you have the skills to do so, otherwise consult your authorised dealer or a specialist.

•The symbol indicates the tools you will need to carry out adjustments.

• Your e-bike has a serial number engraved on the frame.

MAXIMUM LOAD:120 KG.FOR YOUR SAFETY,YOU SHOULD NOT EXCEED THE MAXIMUM LOAD WHEN

USING YOUR BICYCLE.

Rack

(25 kg max)

Display

Electric motor

Battery

ELAIA Manual

2 -ADJUSTMENTS/ASSEMBLY:

Adapt the bike to your height

2.1 Adjusting the saddle:

6mm mm Allen key

2.1.1 Angle:

Loosen the nut under the saddle.

Adjust the angle of the saddle in order to find your most comfortable position. Tighten the nut, with a maximum

tightening torque of 13 Nm.

2.1.2 Height:

The power-assisted bicycle enables you to opt for a lower saddle position than on a classic bike. With power

assistance, you expend less effort and can be seated in a lower position for improved safety. The required user

(cyclist) height for optimal utilisation of the bike ranges from 1.60 to 1.85 m. Adjust your saddle height to the

optimal sitting position as follows:

Loosen the quick-release seat clamp.

Wearing suitable cycling shoes, sit on the saddle, place one of the pedals in the lowest position, rest one heel

on the pedal, and your leg should rest normally on the pedal without being stretched. Raise or lower the saddle

to get the correct height. While pedalling backwards, you should not have to move your hips from side to side.

To calculate the height, you can also use the SH (Seat Height) formula = 0.885xIL (inside leg measurement). To measure

your inside leg, stand barefoot with your feet five centimetres apart. Without applying too much pressure, place a pole or

stick at horizontally at groin height and then measure the height from the stick to the ground. This will give you the IL

(inside leg) measurement.

Nut

Quick-release

clamp

ELAIA Manual

Tighten the quick-release clamp.

THE SEAT POST SHOULD NOT BE EXTENDED BEYOND THE ENGRAVED SAFETY MARK (VERTICAL BARS).

The minimum height between the highest point of the saddle and the ground is 89 cm with a suspension seat

post and 85 cm with a rigid seat post.

2.2 Adjusting the handlebars and the stem:

5 mm and 3mm Allen key.

6 mm Allen Key

For your comfort, the position of your handlebars must be at the same level as the height of your saddle or a

bit higher according to your comfort.

Do the same with the second screw to set the angle of tour handlebars, after making your adjustments, tighten

the screws vigorously, with a max. tightening torque of 10 Nm.

Or with the 4 handlebar angle adjustment screws, a max. tightening torque of 6 Nm.

Safety

mark

Handlebarangle

adjustment screw

Handlebar angle

adjustment screw

ELAIA Manual

2.3 Hydraulic brake adjustment:

The Elaia is equipped with front and rear hydraulic disc brakes. The maintenance of this system must be carried

out by a specialist. Nevertheless, here are a few recommendations:

-Periodically check the condition of the lining on the brake pads. It is important to avoid leaving this until

the last minute as if the lining is damaged, the disc rubs against the metal of the pads which damages

them.

Here are 2 ways to monitor the wear and tear on your pads:

oBy sound: the braking sound will be more metallic when the lining is worn.

oBy sight: you can see the thickness of the lining when looking from the front of the calliper.

-Regularly check the condition of the discs to ensure they are clean and not too worn. Only use alcohol

or water to clean the discs.

-Completely avoid any contact with greasy substances on the disc and the pads. The pads must be

changed should this occur (they are porous and will absorb the greasy substance).

AS A GENERAL RULE,THE HYDRAULIC DISC BRAKING SYSTEM SHOULD NOT BE ADJUSTED BY NON-EXPERTS.WE

RECOMMEND THAT YOU CALL A SPECIALIST SHOULD YOU HAVE ANY DOUBTS ABOUT WHAT TO DO.

ELAIA Manual

2.4 Rack:

DO NOT LOAD RACK BEYOND THE STIPULATED WEIGHT:25 KG.

Any carrying device or other equipment installed by you on your rack (e.g., child seats, other equipment, etc.)

must be compatible with the robustness and build of the bike.

YOU SHOULD PERIODICALLY CHECK THE TIGHTNESS OF THE RACK’S FASTENINGS.

THIS TYPE OF RACK IS NOT DESIGNED TO TOW A TRAILER.

Any alterations made to the rack by the user will at their own risk.

When the rack is loaded, changes in the behaviour of the bicycle must be taken into account (wind stability,

braking distances, changes in direction, etc.). For their safety, the user must be aware of these changes in

operation.

When installing a child seat or panniers, the user must perform a safety check (e.g., hanging straps that are in

danger of catching in the spokes and raise the risk of a fall; check the secureness of the fastenings on the child

seat, the potential trapping of the child's fingers under the saddle, etc.)

The reflector and the rear light must not be covered by the equipment or seat that has been fitted to the rack.

The load on the rack must be evenly distributed on both sides to ensure the stability of the equipment while

riding on public roads.

ELAIA Manual

2.5 Mounting and dismounting the wheels:

AS A GENERAL RULE,NEVER OPERATE THE BRAKE LEVERS WHEN A WHEEL IS OFF THE BIKE.

THE WHEEL WILL BE VERY DIFFICULT TO REMOUNT SHOULD THIS HAPPEN.

2.5.1 Front wheel:

Dismounting the front wheel:

-First, you must loosen the wheel’s fastenings.

-Once this has been done, slide the wheel forward to remove it.

-Insert a piece of plastic in the calliper (between the two pads).

Mounting the front wheel:

-Carry out the dismounting operations in inverse order. Check the tightness of the wheel attachment and

its alignment.

-Once the wheel is in place, operate the brake handle 3-4 times. This allows the pads to settle correctly.

-Check that the brake disc is properly centred and rotates without friction.

-Finally, check that the wheel brakes are working properly.

2.5.2 Rear wheel:

Dismounting the rear wheel:

-First, you must loosen the wheel’s fastenings.

-Once this has been done, slide the wheel forward and remove the chain from the axle to remove it.

-Insert a piece of plastic in the calliper (between the two pads).

Mounting the rear wheel:

-Remove the piece of plastic from the calliper.

-Take the wheel and place the chain on the small sprocket on the right-hand side, then place the wheel

between the brake pads.

-Insert the wheel axle backward into the housing on the left and right of the frame. Attach the washers

and the wheel nuts. Tighten the nuts by hand initially, until they make contact with the frame.

Checking the wheel alignment:

-Centre the wheel in relation to the frame.

-Check the centring and positioning in line with the front wheel, as well as the positioning of the chain.

-Screw on the wheel nuts on both sides without tightening them.

-Check the positioning, centring and position of the chain again.

Checking the brake adjustment:

-Operate the brake handle 3-4 times. This allows the pads to settle correctly.

-Check that the brake disc is properly centred and rotates without friction.

-Finally, check that the wheel brakes are working properly.

Alternately and progressively tighten the wheel nuts on each side (max. tightening torque 25 Nm)

Replace the nut covers.

ELAIA Manual

2.6 Lights:

Your bike is equipped with:

Fixed front and rear lighting. The front and rear lights are powered by the battery.

To start up the lights

please refer to the enclosed BOSCH display user manual.

ALWAYS KEEP YOUR LIGHTS CLEAN AND IN GOOD CONDITION.

LIGHTS ARE OBLIGATORY AT NIGHT.

ELAIA Manual

3 -USING THE E-BIKE:

3.1 Indexed gearshift:

Your gearshift is composed of a derailleur and 9 rear sprockets.

3 sprockets with 11, 13 and 15 teeth (large development), which allow you to increase your speed in

easy conditions (light descent, flat);

3 intermediate sprockets with 17, 20 and 23 teeth to use under normal conditions;

3 sprockets (small development) with 26, 34 and 36 teeth for difficult hills and starts.

The (indexed) gear selectors are located on the right side of the handlebars.

3.2 Electronic gear shifting:

You can find all information relating to the electronic gearshift in the enclosed BOSCH display user

manual.

3.3 Display and controls:

You can find all information relating to the display and controls in the enclosed BOSCH display user

manual.

Table des matières

Autres manuels neomouv Scooter

neomouv

neomouv NOVA S Manuel utilisateur

neomouv

neomouv KALYSO Manuel utilisateur

neomouv

neomouv FACELIA Manuel utilisateur

Manuels Scooter populaires d'autres marques

TEKTRO

TEKTRO CHEETAH Manuel utilisateur

Douglas

Douglas Vespa Sprint Guide d'installation

PLAYTIVE

PLAYTIVE AS-2448 Manuel utilisateur

Ebinger

Ebinger DONKEY XL Manuel utilisateur

Flyer

Flyer Mountain Guide de l'utilisateur

BackCountry eBikes

BackCountry eBikes Storm Manuel utilisateur

equipmed

equipmed FreeRoam II Manuel utilisateur

Yoto

Yoto Lion Manuel utilisateur

WESTHILL BIKES

WESTHILL BIKES LINK Manuel utilisateur

BAnff

BAnff eProdigy series Manuel utilisateur

Winther

Winther 475 Manuel utilisateur

Jetson

Jetson JBZL17 Manuel utilisateur

First Choice Mobility

First Choice Mobility Roma Medical Corella S741 Manuel utilisateur

Carrera

Carrera impel Manuel utilisateur

Afikim

Afikim Superlight SL-3 Manuel utilisateur

CareCo

CareCo ZOOM Manuel utilisateur

Douglas

Douglas Vespa G.S. Manuel utilisateur

Gazelle

Gazelle with BOSCH System Manuel utilisateur

neomouv ELAIA Manuel utilisateur

Manuels Scooter populaires d'autres marques