7
Notes:
1. If there is a “*” at the right side of one item, the current list is the final option, press
the dial right button to launch it.
2. If the selected item and other items in the menu list don’t have any marks, press the
dial right button to launch the option once. “?” is displayed during the process. “OK” is
displayed after the process is completed, and “ERR” is displayed if the option fails.
Menu type introduction:
If there is a “＞”mark at the right side of the selected item, press the dial
right button for the next menu.
If the selected item has a “【】”and contains a number, rotate the dial to
adjust its value.
If the selected item has a “()”and contains an option, press the right
button to switch among options
dial +/-
rotate the dial clockwise to increase/decrease value
？/ok turn on/off LED light on the wheel
0-100 adjust the brightness
？/ok auto tune
balance chk check the balance state of camera
switch ？/ok/err turn on/off the focus motor 1
set A ？/ok/err set the point A of focus motor 1
set B ？/ok/err set the point B of focus motor 1
Clear AB ？/ok/err Clear the calibration information
Guidance > Enter the guidance mode
switch ？/ok/err turn on/off the focus motor 1
set A ？/ok/err set the point A of focus motor 1
set B ？/ok/err set the point B of focus motor 1
Clear AB ？/ok/err Clear the calibration information
Guidance > Enter the guidance mode
> Enter the dolly zoom mode
inception 0--100 set the rotation speed of inception mode
？/on/off turn on/off the motion control of tilt axis
？/on/off turn on/off the motion control of roll axis
？/on/off turn on/off the motion control of pan axis
0-100 set the rotation speed of motion control
tracking 0-100 set the max speed of tracking
on/off
turn on/off the manual positioning of tilt axis
on/off
turn on/off the manual positioning of roll axis
on/off
turn on/off the manual positioning of pan axis
？/ok calibrating/calibrated the gyroscope
？/ok calibrating/calibrated the accelerometer
0-100 set the offset value of tilt axis
0-100 set the offset value of roll axis
0-100 set the offset value of pan axis
* switch display language to English
* switch display language to Chinese
？/ok save to configuration 1
？/ok load configuration 1
？/ok save to configuration 2
？/ok load configuration 2
？/ok save to configuration 3
？/ok load configuration 3
？/ok restore default parameter settings
device name and firmware information
gimbal
advanced
general
Focus
otion sen
anual po
alibration
anguage
onfig
onfig2
onfig3
ngle offs
onfig1
witch
1
2
ED
operation
L1 L2 L3 L4 L5 Value Function
