Monoprice 31005 Manuel utilisateur
MP 35" Zero-G 100Hz Curved Monitor
with AMD FreeSync™2.0
P/N 31005
User's Manual
2
SAFETY WARNINGS AND GUIDELINES
Please read this entire manual before using this device, paying extra attention to these
safety warnings and guidelines. Please keep this manual in a safe place for future reference.
This device is intended for indoor use only.
Do not expose this device to water or moisture of any kind. Do not place drinks or
other containers with moisture on or near the device. If moisture does get in or on
the device, immediately unplug it from the power outlet and allow it to fully dry
before reapplying power.
Do not touch the device, the power cord, or any other connected cables with wet
hands.
Do not place the monitor on an unstable surface where it could fall and cause either
personal injury or damage to the monitor and/or other equipment.
Do not subject the product to extreme force, shock, or fluctuations in temperature
or humidity.
Do not expose this device to excessively high temperatures. Do not place it in, on,
or near heat sources, such as a fireplace, stove, radiator, etc. Do not leave it in direct
sunlight.
This device ventilates excessive heat through the slots and openings in the case. Do
not block or cover these openings. Ensure that the device is in an open area where
it can get sufficient airflow to keep from overheating.
Do not place or install this device in an area where it can be exposed to excessive
amounts of dust, humidity, oil, smoke, or combustible vapors.
Prior to operation, check the unit and power cord for physical damage. Do not use if
physical damage has occurred.
Before plugging the unit into a power outlet, ensure that the outlet provides the
same type and level of power required by the device.
Take care to prevent damage to the power cord. Do not allow it to become
crimped, pinched, walked on, or become tangled with other cords. Ensure that the
power cord does not present a tripping hazard.
3
Never unplug the unit by pulling on the power cord. Always grasp the connector
head or adapter body.
Ensure that power is turned off and disconnected before making any electrical
connections.
Remove the batteries from the controller if it will go unused for a lengthy period of
time.
Clean using a soft, dry cloth only. Do not use chemical cleaners, solvents, or
detergents. For stubborn deposits, moisten the cloth with warm water.
This monitor has no user serviceable parts. Do not open the case or otherwise
attempt to modify this monitor.
Do not leave a single image on the display for a long period of time. Doing so could
cause "burn-in" of the image. It is recommended to use a variable desktop
background and to use a screen saver to prevent "burn-in". Alternatively, ensure
that the monitor is powered off for at least 2 hours out of every 12.
FEATURES
Three HDMI® and one DisplayPort inputs
3440 x 1440p @ 100Hz maximum video resolution
Fully compliant with the HDMI 2.0 and DisplayPort 1.2 specifications
5ms GTG response time
178° vertical and horizontal viewing angles
500,000:1 dynamic contrast ratio
300 cd/m² brightness
More than 16.7 million colors
Includes IR remote control
Supports AMD FreeSync™ 2.0
4
CUSTOMER SERVICE
The Monoprice Customer Service department is dedicated to ensuring that your ordering,
purchasing, and delivery experience is second to none. If you have any problem with your
order, please give us an opportunity to make it right. You can contact a Monoprice
Customer Service representative through the Live Chat link on our website
www.monoprice.com during normal business hours (Mon-Fri: 5am-7pm PT, Sat-Sun: 9am-
PACKAGE CONTENTS
Please take an inventory of the package contents to ensure you have all the items listed
below. If anything is missing or damaged, please contact Monoprice Customer Service for a
replacement.
1x 35" Curved Monitor
1x Stand Base
2x Stand Legs
6x Stand Screws
1x High Speed HDMI® Cable
1x AC Power Adapter
1x AC Power Cord
1x IR Remote Control
2x AAA Batteries
1x User's Manual
PRODUCT OVERVIEW
Input Panel
DC IN: DC barrel connector for connecting the included AC power adapter.
DP 1: DisplayPort video input supporting the DisplayPort 1.2 specification at resolutions
up to 3440 x 1440p @ 100Hz.
5
HDMI 3: HDMI video input supporting the HDMI 2.0 specification at resolutions up to
3440 x 1440p @ 100Hz.
HDMI 2: HDMI® video input supporting the HDMI 1.4 specification at resolutions up to
3440 x 1440p @ 60Hz.
HDMI 1: HDMI® video input supporting the HDMI 1.4 specification at resolutions up to
3440 x 1440p @ 60Hz.
AUDIO OUT: 3.5mm stereo analog audio output.
Front
6
Rear
Keypad
1. MENU: If the OSD menu is not displayed, press the MENU button to display the OSD
menu. If the OSD menu is displayed, press the MENU button to select the
highlighted function.
7
2. SELECT: Press the SELECT button to select the video input.
3. V.+: If the OSD menu is not displayed, press the V.+ button to increase the volume
level. If the OSD menu is being displayed, press the V.+ button to move the
highlight to the right.
4. V.-: If the OSD menu is not displayed, press the V.-button to decrease the volume
level. If the OSD menu is being displayed, press the V.-button to move the highlight
to the left.
5. ▲: If the OSD menu is not displayed, press the ▲button to adjust the aspect ratio.
If the OSD menu is displayed, press the ▲button to move the highlight up.
6. ▼: If the OSD menu is not displayed, press the ▼button to cycle through the
crosshair modes. If the OSD menu is displayed, press the ▼button to move the
highlight down.
7. : Press the button to turn the monitor on or to put it in standby mode.
Remote Control
Turns the monitor on or puts it into standby mode.
Selects the video input.
Turns audio muting on or off.
Selects the image aspect ratio.
Up selects the channel.
Down selects the channel. Quick enter for target crosshairs.
Decreases the volume level.
8
Increases the volume level.
Displays the source.
Enters the OSD menu.
Exits the OSD menu.
Quick enter for low blue mode.
Quick enter for ECO mode.
Quick enter for sleep mode.
INPUT SOURCE MENU
Press the SELECT button on the Keypad to display the Input
Source Menu.
Use the ▲and ▼buttons to move the highlight to the
desired input.
Press the V.-button or wait 3 seconds to select the
highlighted input.
Select the AUTO option allow the monitor to automatically
switch to the active input.
9
INSTALLING THE STAND
Unless you will be using a wall or desk mount, you will need to install the stand before you
can use the monitor. Perform the following steps to install the stand.
1. Remove the monitor from the box, but leave the foam packing on it.
2. Using two of the included Stand Screws, attach the two Stand Legs to the Stand
Base, as shown in the images below.
3. Place a towel or blanket on a flat work surface to protect the monitor while
installing the stand.
4. Place the monitor with the foam packing face down on work area, then attach the
Stand Base to the back of the monitor using the four remaining Stand Screws, as
shown in the images below.
10
INSTALLATION
1. Ensure that all equipment to be connected is powered off and unplugged from their
power sources.
2. Place the monitor it its intended location.
3. Using the included High Speed HDMI® Cable, plug one end into one of the HDMI
inputs on the monitor, then plug the other end into the HDMI output on your PC.
Note that HDMI 3 supports the HDMI 2.0 specification at up to 100Hz refresh rate,
while HDMI 1 and HDMI 2 support the HDMI 1.4 specification at up to 60Hz refresh
rate.
4. Plug the DC barrel connector on the included AC Power Adapter into the DC IN jack
on the Input Panel.
5. Plug the included AC Power Cord into the C14 connector on the AC Power Adapter,
then plug the other end into a nearby AC power outlet.
OSD MENU MAP
Main Menu
Item
Sub Menu
Item
Option
Function
BRIGHTNESS
BRIGHTNESS
0~100
Level can be adjusted from 0 to 100
CONTRAST
0~100
Level can be adjusted from 0 to 100
BLACK LEVEL
0~100
Level can be adjusted from 0 to 100
ECO
STANDARD
Choose the picture mode.
TEXT
GAME
MOVIE
ECO
FPS1
Table des matières
Autres manuels Monoprice Moniteur
Monoprice
Monoprice 12178 Manuel utilisateur
Monoprice
Monoprice 43021 Manuel utilisateur
Monoprice
Monoprice DARK MATTER 44710 Manuel utilisateur
Monoprice
Monoprice 33821 Manuel utilisateur
Monoprice
Monoprice Dark Matter 44632 Manuel utilisateur
Monoprice
Monoprice 13808 Manuel utilisateur
Monoprice
Monoprice 10707 Manuel utilisateur
Monoprice
Monoprice Zero-G 31004 Manuel utilisateur
Monoprice
Monoprice 37923 Manuel utilisateur
Monoprice
Monoprice 16384 Manuel utilisateur
Monoprice
Monoprice 38035 Manuel utilisateur
Monoprice
Monoprice 10734 Manuel utilisateur
Monoprice
Monoprice 12520 Manuel utilisateur
Monoprice
Monoprice Dark Matter 40778 Manuel utilisateur
Monoprice
Monoprice 33822 Manuel utilisateur
Monoprice
Monoprice 24657 Manuel utilisateur
Monoprice
Monoprice CrystalPro 37922 Manuel utilisateur
Monoprice
Monoprice 30602 Manuel utilisateur
Monoprice
Monoprice 11441 Manuel utilisateur
Monoprice
Monoprice 27771 Manuel utilisateur
