microcanner MC-ATOMIC
MC-ATOMIC (V1.0) PAGE 5 OF 19
○Air Regulator at the machine is to be set at 80 P.S.I. If your
pressure needle jumps around during operation, you will need to
supply a surge tank near the machine.
○CO2 delivery system that is regulated to 20 P.S.I. (use the inline
flow controls on the can purge and under cap gas to restrict the
flow. The machine only needs a few PSI for this application. The
inline flow controls will allow you to make finer adjustments than the
regulator will). This line should have a standard quick connect for
hooking up to the filler head.
●34°F product @ 2.64 CO₂@ 15 PSI head pressure (head pressure will
vary and a longer line set may be required when running high gravity,
high IBU double IPA beer)
●Sanitizer pump to rinse filler valves (visit www.microcannerparts.com
for list of parts and instructions on assembling the pump)
●A drain under the machine or area for the water to run away from the
machine, so the bottom of the machine does not become submerged
more than ¼” in water.
3. GENERAL MACHINE SERVICE
Like any other piece of equipment, new car or tractor, your canning
machine needs to be cleaned, lubricated and periodically serviced.
Screws loosen, filters plug up with contaminates, sensors vibrate out of
adjustment and seam tooling wears. It is important to assign a technician
to learn the system and take good care of it.
●Prior to each use, all screws and sensors should be checked for
tightness.
