•
IMPORTANT: Please read all of the instructions before installation.
GENERAL:
•
•
•
•
This product must be installed in
compliance with all relevant regional
regulations.
It is the responsibility of the installer to
ensure a watertight seal is achieved.
All outlets used primarily for personal
hygiene shall deliver water at a safe
temperature as per regional regulations.
Where a Hand Shower and/or Overhead Shower is fitted with a flow regulator the lower flow rate
may not be suitable for the connection to some gravity fed Water Heaters, low pressure supply
networks, Instantaneous Water Heaters, Tempering Valves, Solar Water Heaters & Thermostatic
Mixing Valves. Check with the manufacturers of these products.
Where showers incorporate flow controllers, care must be exercised during installation to ensure
that the male connecting threads do not damage the flow controllers.
NOTE: Use plumbers tape or similar on ¹⁄₂"
male threaded connection to ensure a
reliable seal.
CARE AND CLEANING:
• Never use abrasives or abrasive cleaning agents to clean this product. To clean the chrome-plated
surface use contamination free warm soapy water and a damp soft cloth.
• Lime deposits can be prevented from forming on the faceplate by wiping immediately after use. If
shower performance is compromised by the build-up of lime-scale, soak in limescale remover for up
to 10 minutes. Do not attempt to remove limescale with sharp objects or abrasives. Do not use
products containing chlorine bleach or hydrochloric acid as these can damage the shower. Always
rinse the shower thoroughly after cleaning to remove cleaning products that can damage the shower.
• Clean face plate using a brush with soft bristles.
• Do not use any sharp objects to clean nozzles.
• Clean filter washer located in the ball joint periodically.
Overhead Shower
Filter Washer
Arm
(If Supplied)
Trim Ring
Min 10mm
Max Ø 25mm
Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to www.methven.com or call
customer service for full details.
New Zealand
0800 804 222
Australia
13 14 16
UK
0800 195 1602
IS ISSUE A
