METHVEN AIO ACCESSORIES Manuel utilisateur

Methven warrants this product against manufacturing defects and that it is suitable for use

under the general operating conditions speciﬁed in this instruction sheet. However, regional

regulations apply and may aﬀect your warranty. Please refer to www.methven.com or call

customer service for full details.

New Zealand Australia UK

www.methven.com

Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with

contamination free warm soapy water and a damp soft cloth.

Care and Cleaning:

Please refer to your warranty statement at

www.methven.com

AIO ACCESSORIES

Installation Guide

MA382270 - ISSUE A

*Single and Double Towel Rails available

in both 600mm and 900mm

Soap Dish Holder

Bathroom Shelf

All Methven accessories are constructed from brass, and are able to hold up to 5 kilograms.*

*(Bathroom Shelves are constructed from brass and stainless steel)

SEPT 2017

20mm

60mm 640 mm / 940mm

130mm

26mm

97mm

384mm

19mm

105mm

All Methven accessories are constructed from brass, and are able to hold up to 5 kilograms.

IMPORTANT:

Installation:

Single Towel Rail (600mm and 900mm)

Towel Ring

Toilet Roll Holder

Robe Hook

2. Pre-drill the holes

Now drill into the marked measurements, right through the tiles into the wall.

3. Insert the wall plugs

Remove the tape and insert the wall plugs into your holes. If you need to, use a hammer to

gently tap the plugs in.

4. Remove the plates from your accessory

Using the Allen key provided, remove the plates from your accessory.

Please read all of the instructions before installation.

5. Screw the plates to the wall

Using your drill, screw the plates into the wall plugs so that they are ﬂush with the tiles.

6. Check the plates are level

With your tape measure, check that the distance from the plates to the edge of the tiles below

them is the same. If not, then you will need to make adjustments. This will ensure your

accessory will look straight once it is installed.

IMPORTANT NOTE:

Wall materials vary. The accessory ﬁxing kit supplied is suited for solid wall ﬁxing. For timber

framed walls, pleasure ensure the accessory is ﬁxed to a noggin/stud behind the wall. Where

stud/noggin is not available, please use suitable hollow wall ﬁxing.

121mm

60mm

240mm

20mm

60mm 179mm

7. Attach the accessory to the wall

Finally, connect the accessory to the plates on the wall. Tighten it using the Allen key. Then

check that the accessory is level.

8. Check the levels

Finally, check that the accessory is straight, using your spirit level. If not, then you will need

to make some adjustments. Please refer to the following series of images for your

corresponding accessory.

20mm

60mm 640mm / 940mm

Please note that the plate will need to be installed vertically for the Robe Hook

Double Towel Rail (600mm and 900mm)

Measure and mark positions

Choose a position for your accessory. Measure the distance between the ﬁxings on the base of

the accessory and transfer these measurements onto the wall. Measure an equal distance down

from the bottom of a tile and mark the measurements to make sure they are even and level.

20mm

70mm

49mm

20mm

110mm 640mm / 940mm

Table des matières

Autres manuels METHVEN Appareil de salle de bains

METHVEN

METHVEN 01-8284 Manuel utilisateur

METHVEN

METHVEN KIRI SATINJET ULTRA LOW FLOW Manuel utilisateur

METHVEN

METHVEN KEA Manuel utilisateur

METHVEN

METHVEN 01-8345 Manuel utilisateur

METHVEN

METHVEN KRSRCPAU Manuel utilisateur

METHVEN

METHVEN SATINJET WALL SHOWER Manuel utilisateur

METHVEN

METHVEN Minimalist 17-6250 Manuel utilisateur

METHVEN

METHVEN DEVA ETHOS ETH106 Manuel utilisateur

METHVEN

METHVEN SATINJET ESCAPE MKII Manuel utilisateur

METHVEN

METHVEN MINIMALIST MK2 Manuel utilisateur

METHVEN

METHVEN RERE 16-1027 Manuel utilisateur

METHVEN

METHVEN TUROA ACCESSORIES Manuel utilisateur

METHVEN

METHVEN Kiri 3 Manuel utilisateur

METHVEN

METHVEN SATINJET SQUARE OVERHEADDRENCHER Manuel utilisateur

METHVEN

METHVEN MINIMALIST MK2 Manuel utilisateur

METHVEN

METHVEN Tahi 01-6150 Manuel utilisateur

METHVEN

METHVEN TUROA Manuel utilisateur

METHVEN

METHVEN AIO AURAJET TWIN SHOWER AOSSCPAU Manuel utilisateur

METHVEN

METHVEN Ovalo Wall Top 01-0806 Manuel utilisateur

METHVEN

METHVEN Satinjet Waipori WASSCPGR Manuel utilisateur

METHVEN

METHVEN Deva PHK1 Manuel utilisateur

METHVEN

METHVEN 03-9548 Manuel utilisateur

METHVEN

METHVEN Amio Manuel utilisateur

METHVEN

METHVEN Amio 01-4606 Manuel utilisateur

Manuels Appareil de salle de bains populaires d'autres marques

DURAVIT

DURAVIT C.1 C15240 0090 Manuel

Heatstore

Heatstore HSTRL500WTN Manuel utilisateur

Sunshower

Sunshower PURE SOLO Manuel utilisateur

Delabie

Delabie Delabie Sporting 714700 Manuel utilisateur

Kohler

Kohler K-13056 Instructions de montage

ESS

ESS Container TCL-11 Manuel utilisateur

Mustee

Mustee 22C Manuel utilisateur

VITRA

VITRA V-Flow Manuel utilisateur

baliv

baliv DUK-80.30 T Manuel utilisateur

Malmet

Malmet B105BT Manuel utilisateur

bathstore

bathstore Transition H1690MM Mode d’emploi

BELLOSTA

BELLOSTA Edward 0800/M Manuel utilisateur

baliv

baliv DU-5160 Manuel utilisateur

Franke

Franke PRTR0006 Manuel utilisateur

Gessi

Gessi RILIEVO 59011 Manuel utilisateur

noken

noken VITAE 100188525-N299998810 Manuel utilisateur

Allen + Roth

Allen + Roth 1142VA-30-201 Manuel utilisateur

Britex

Britex HBDA Manuel utilisateur