Mount the hot end to the printer and connect all the
wiring. Refer to the wiring schematics on our website for
connecting cables to the motherboard.
Insert the filament guide tube from the extruder into the top of the 1.75mm Bowden coupler. Make sure
to push down firmly until the tube cannot go any further. When inserting the filament guide tube, you may
feel resistance near the top of the coupler. Keep pushing until the tube bottoms out.
Step 5
Wiring reverse polarity can damage Voltage
Regulator. Ensure the correct polarity by matching
the coloring of wires between each plug.
Please refer to the wiring diagrams on the User Guides page of the Metaform website for wiring the hotend to the printer.
