Masterbuilt 20070710 Manuel utilisateur

Heating Element Replacement Instruction for

20070710, 20070810, 20070910 Electric Smokers

PARTS AND HARDWARE

ITEM

NUMBER

QUANTITY

DESCRIPTION

1 1 Replacement Element

2 1 Gasket

3 2 Replacement Wire Assembly

4 2 Wire Nuts

5 2 Element Screws

Required Tools: Short Phillips head Screwdriver

Wire Stripper

• ALWAYS REMOVE PLUG FROM OUTLET BEFORE SERVICING!

• MAKE SURE UNIT HAS FULLY COOLED TO AVOID BURNING!

• EDGES MAY BE SHARP. USE CAUTION TO AVOID INJURY!

!CAUTION!

090126-04SS

Step 1:

Remove woodchip loader from unit

Step 2:

Remove cooking grates, woodchip holder

and drip pan out of smoker.

*Disconnect from power source and allow unit to fully cool before replacing heating element.

Step 3:

Remove 4 screws from the woodchip

housing (A) and detach from inside smoker

to expose heating element as illustrated.

Step 4:

Remove back plate from rear of smoker

exposing leads for heating element.

Carefully remove heat shrink from female

leads (B) and disconnect from male spades

Caution! Sharp edges may cause injury!

Before continuing, be sure to note that edges of

thin sheet metal in this step could cause injury.

Step 5:

Unscrew heating element support screws

and detach rubber housing from rear

enclosure.

Step 6:

Inside unit, pull heating element from back

of unit, pulling away gasket from element

bracket and exposing ground wire. Remove

ground wire from heating element as shown.

Step 7:

Connect ground wire to new heating ele-

ment in reverse order of step 6.

Step 8:

Align male spades of heating element with

holes on back wall, inserting them at a slight

angle as shown in illustration while making

sure ground wire does not get lodged

between the element bracket and housing.

Step 9:

Following step 5 in reverse, hold element in

place while having someone secure element

to housing.

Step 10:

If existing female leads are clear of

corrosion, reattach leads in reverse order as

in steps 5-1. However, if there is clear

damage or corrosion to female leads they will

need to be replaced as shown in steps 11-13

on the following page.

*Steps 8-9 require assistance.

Step 11:

If female spades need to be replaced, cut

the existing spade off, then strip insulation

back 3/8” using wire stripper.

Step 13:

Insert replacement wire leads onto ele-

ment terminals as shown.

Step 12:

Attaching bare replacement wiring

assembly to existing wire from body, join

the two bare ends of wire together and twist

until wires are held securely to each other.

Place wire not over the two wires and twist

wirenut until secure on both wires.

*Before reinstalling woodchip housing, plug unit

into outlet and test element to ensure correct

operation. Once unit checks out, unplug unit and

allow smoker to fully cool.

*A small piece of electrical tape wrapped

around wirenut and wires adds security.

Step 11:

Reassemble smoker following steps 5-1 in

reverse order. Unit is now operational. Enjoy!

Masterbuilt Manufacturing, Inc.

1 Masterbuilt Court

Columbus, Georgia 31907

Customer Service 1-800-489-1581

3/8

Autres manuels pour 20070710

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Masterbuilt Fumeur

Masterbuilt

Masterbuilt MES 130P Manuel utilisateur

Masterbuilt

Masterbuilt MPS 230S Manuel utilisateur

Masterbuilt

Masterbuilt GMES Manuel utilisateur

Masterbuilt

Masterbuilt MPS 20B Manuel utilisateur

Masterbuilt

Masterbuilt 20070211 Mode d’emploi

Masterbuilt

Masterbuilt MES 30B Manuel utilisateur

Masterbuilt

Masterbuilt 20100814 Manuel de l'opérateur

Masterbuilt

Masterbuilt 20070211 Mode d’emploi

Masterbuilt

Masterbuilt 20072612 Mode d’emploi

Masterbuilt

Masterbuilt 20051011 Mode d’emploi

Masterbuilt

Masterbuilt 20070407 DIGITAL SMOKEHOUSE Mode d’emploi

Masterbuilt

Masterbuilt 20071011 Mode d’emploi

Masterbuilt

Masterbuilt SIGNATURE Series Mode d’emploi

Masterbuilt

Masterbuilt MB20077618 Manuel utilisateur

Masterbuilt

Masterbuilt THE ROOK GMCS Manuel utilisateur

Masterbuilt

Masterbuilt MPS 340 G Manuel utilisateur

Masterbuilt

Masterbuilt CG600S Manuel utilisateur

Masterbuilt

Masterbuilt MB20100112 Manuel utilisateur

Masterbuilt

Masterbuilt 710 Manuel utilisateur

Masterbuilt

Masterbuilt 20070710 Mode d’emploi

Masterbuilt

Masterbuilt MES 430G Instructions d'installation

Masterbuilt

Masterbuilt 20070411 Manuel utilisateur

Masterbuilt

Masterbuilt 20072612 Mode d’emploi

Masterbuilt

Masterbuilt CS40G1DW Manuel utilisateur

Manuels Fumeur populaires d'autres marques

Smoke hollow

Smoke hollow 30166E Manuel utilisateur

oklahoma joes

oklahoma joes 15202037 Manuel utilisateur

Trail Embers

Trail Embers SMK7030AS Manuel utilisateur

Klarstein

Klarstein 10031325 Manuel utilisateur

Kingsford

Kingsford SC2315801-KF Manuel utilisateur

Char-Broil

Char-Broil 1000 Manuel utilisateur

Auber

Auber WS-1500DPMS Manuel utilisateur

Char-Broil

Char-Broil 1000 Manuel utilisateur

oklahoma joes

oklahoma joes 14201884 Manuel utilisateur

Pit Boss

Pit Boss 10806 Manuel utilisateur

Lang BBQ Smokers

Lang BBQ Smokers 36 Series Mode d’emploi

Smokey Bandit

Smokey Bandit Lumberjack Manuel utilisateur

Char-Broil

Char-Broil 12701705 Manuel utilisateur

Rosle

Rosle Silence Manuel utilisateur

Royal Catering

Royal Catering RCRO-1300 Manuel utilisateur

New Braunfels

New Braunfels Bandera 09201553 Manuel utilisateur

Char-Broil

Char-Broil 12101625 Manuel utilisateur

Pit Boss

Pit Boss PBVPS1 Manuel de la liste des pièces