Markforged SINTER-2 Manuel utilisateur
1
SINTER-2 USER GUIDE
Markforged
480 Pleasant St
Watertown MA 02472
USA
https://support.markforged.com
suppor[email protected]
For the latest PDF version of this document, visit our
support website.
Copyright © 2019-20 Markforged, Inc. All rights reserved.
Changes are periodically made to the information herein
which will be incorporated in revised editions of this
publication.
Markforged may make changes or improvements to
the product(s) described in this publication at any time
and without notice.
Version 1.1 / October 2020
3
SINTER-2 USER GUIDE
SAFETY NOTES 4
CONNECTING YOUR FURNACE 5
NETWORK REQUIREMENTS 7
POWERING THE FURNACE ON/OFF 9
SETTING UP AND LOADING PARTS 10
SETTING GAS SUPPLY REGULATORS 11
DOOR FUNCTION AND OPERATION 14
STARTING A SINTER RUN 17
SMALL PART EXPRESS RUN 23
RAPID COOLING 25
REMOVING THE RAFT FROM A SINTERED PART 26
REPLACING THE GAS SUPPLY 27
REPLACING GAS SUPPLY FILTERS 31
REPLACING THE EXHAUST FILTERS 33
TROUBLESHOOTING A LEAK 38
CLEARING AN EXHAUST CLOG 44
GAS USE MANAGEMENT 47
SINTER-2 USER GUIDE
4
SAFETY NOTES
Note: Consult the Safety Sheet included with your device for a comprehensive list of safety notes,
along with an explanation of the safety icons used in this manual.
R
●
●
●
●
Safety
Sheet
Facilities Guide
5
SINTER-2 USER GUIDE
CONNECTING YOUR FURNACE
If
1.
Note: Make sure that your LAN (Local Area Network) uses DHCP
2.
er)
1.
SINTER-2 USER GUIDE
6
2.
3.
1.
2.
7
SINTER-2 USER GUIDE
NETWORK REQUIREMENTS
Advanced
Networking Features
SINTER-2 USER GUIDE
8
s3.amazonaws.com,
mfeiger-production.
s3.amazonaws.com
443 TCP yes Downloading .MFP part files
produced by Eiger (printers
only)
cdn.eiger.io 443 TCP yes device operation
www.eiger.io 443 TCP yes Connecting to Eiger --
required for viewing printer
status, queuing print jobs,
keeping printer software up
to date, etc.
*.pool.ntp.org 123 UDP yes Time synchronization via
NTP is required for furnace
to connect securely to
Eiger. See note above about
NTP requirements and
alternatives.
ipv4.connman.net 80 TCP no Status check of furnace’s
network connection
-- primarily used for
troubleshooting
data.logentries.com 443 TCP no Remote logging of device
events and errors
data.logentries.com 10000 TCP no legacy logging (version older
than 9/14/2018)
9
SINTER-2 USER GUIDE
POWERING THE FURNACE ON/OFF
●
●
●
SINTER-2 USER GUIDE
SETTING UP AND LOADING PARTS
Note: Only chemically debound (i.e. washed) “brown” parts can be run in the Sinter-2; see the Wash-1
User Guide for further information. Parts of dierent material must be sintered separately.
(Raftless printing is also available; see the Support website for details.)
Note: Parts that touch during the sintering process may bond together, resulting in unrecoverable
failed parts.
entirely
Table des matières
Autres manuels Markforged Imprimante 3D
