5
Remote Control Functions
Home Position: To return mount to the home
position press: Run then arrow. This will
Auto-Swivel mount to center position and raise
mount to the topmost position.
Stop: Press any button to stop movement
Set Memory Position: To Set Positions 1, 2
• Drive the mount to the desired Position
• Press Set
• Press the Memory button (1, 2)
System Reset: If the mount is not working as
expected, updates calibration while keeping
set limits
• Press Set
• Press Run
• Press/Hold Set
• Mount will move to the top position
• Keep holding for 5 seconds after mount
reaches top position
Set Left/Right/Bottom Limit:The Mount will
not drive past
• Drive Mount to desired limit
• Press Set
• Press one of ( )
• Press/Hold Set for 4 to 8 Seconds
• Check it was correctly done by trying to
move the mount past limit
Clearing Any Memory Position: A position
does NOT need to be cleared to change it.
• From any Position
• Press Set
• Press button to clear
(12 )
• Press/Hold Set for at least 11 Seconds
Automatically Move to Position
The mount can be automatically moved to any
set position without having to hold the button.
To do this, press Run and then the Position
Button ( 12 ). To stop movement,
simply push any button on the remote.
When Auto-moving, the mount will center the
swivel, go to the required height, then swivel
to position.
Note: Press each button rmly; a quick tap
probably will not work.
Remote Control Buttons
Move the mount up to the top
most position
• Hold to drive to position
Move the mount down to the bottom most
set position
• Mount cannot be driven lower then
set limit
• Comes set for lowest bottom position
• Hold to drive to position
Swivel the mount to the right most
set position
• Mount cannot be driven past
set right limit
• Comes set for 30 degrees of swivel
to the right
• Hold to drive to position
Swivel the mount to the left most
set position
• Mount cannot be driven past
set left limit
• Comes set for 30 degrees of swivel
to the left
• Hold to drive to position
1Move the mount to the set 1 position
• Mount will drive to this position from
either direction
• Does not come set out of the box
• Hold to drive to position
2Move the mount to the set 2 position
• Mount will drive to this position from
either direction
• Does not come set out of the box
• Hold to drive to position
Run Automatically move to the position
selected ( 12 )
• Press Run
• Press one of ( 12 ) within
3 seconds
• The mount will move to the limit
automatically
• Press any button to stop movement
• For Auto-Moving, the mount will rst
swivel to center position (0 degrees),
adjust height, then swivel.
Set Used to Set and Clear Positions.
BEFORE INSTALLATION
1 Learning Your Remote Functions.
Remote Buttons
Up Button
Down Button
Swivel Right
Swivel Left
1Memory 1
2Memory 2
RUN Run Button
SET Set Button
Pairing RF Remote
Controller should be already
paired out of the box.
• Unplug Power to mount for
30 seconds
• Hold the button while
plugging in power.
• keep holding button
for 10 seconds
The RF remote requires a
CR2032 battery
Quick Note: To return mount to the home position press: Run then arrow.
This will Auto-Swivel and move mount to the topmost position.
