Use of this device as part of a transmission system, or combined
transmission system not specified by the manufacturer, may require
further testing to ensure that it remains compliant with the essential
requirements and other relevant provisions of current EU Low Voltage,
EMC and Radio Equipment Directives. Approval and clearance from the
Spectrum Management Authority may also be required.
Installation must adhere to safety regulations and the requirements of
the relevant authorities. We recommend that at least two people are
present during installation. Keep a file containing installation
instructions and plans, including details of the transmission system
(antennas, feeders, filters, etc) and operating instructions for all
equipment at the transmission site at all times. Display posters
detailing first aid treatment and treatment for electrical shock, along
with telephone numbers for contacting the emergency services in the
event of personal injury.
Ensure antenna system lightning strike protection is in place.
To reduce the risk of electrical shock, do not remove the cover, or any
screws. There are no user serviceable parts inside; refer servicing to
qualified personnel.
Do not expose this appliance to rain or moisture. The transmitter
should not be used near water. Care should be taken so that objects
do not fall - and liquids are not spilled - into the enclosure through
openings.
To reduce the risk of fire, always replace fuses with the same type and
rating.
The transmitter should be mounted into a well-ventilated standard 19
inch equipment rack. It should be situated so that its location or
position does not interfere with its proper ventilation.
The transmitter should be situated away from heat sources.
The transmitter should be connected to a power supply only of the
type described in the operating instructions or as marked on the unit.
Precautions should be taken so that the grounding or polarisation of
this appliance is not defeated.
The unit should be cleaned only as recommended by the
manufacturer.
