Lantech IPES-0104FA Manuel utilisateur

IPES-0104FA

4 10/100TX PoE at/af + 100FX Industrial Switch

Quick Installation Guide

Introduction

The Lantech IPES-0104FAis a 4 x 10/100TX + 1 100FX with 4-PoE-injector Industrial PoE+ Switch feeding up to

30W/port for plug-and-play installation. This slim switch is Wall-mountable or DIN rail mountable, making installation

easier and flexible.

The IPES-0104FAis designed to meet with critical network environment with IP 30 enclosure and test under extensive

Industrial EMI and Safety standards. It supports EFT protection for 2000VDC power and 6000VDC ESD contact

protection, which can reduce unstable environment damage caused by power line and Ethernet. The IPES-0104FA also

supports IEEE 802.3at/af standard for PoE/PoE+ auto-detection and PoE classification resistors for hand-shaking with PD

(power device), which can prevent any connected devices from burning down by sending high voltage (48V) out.

The Lantech IPES-0104FAis the best Industrial switch to connect with IP Camera, Wireless Equipments where are placed

outdoor or tight space cabinets such as street cabinet, wireless hotspots etc.

Housing dimension

Installation package

This unit can be installed by din-rail mounted or wall-mounted. Din-rail brackets and wall-mounted bracket are included.

Power and alarm relay connection

The PWR1 and PWR2 can be redundant with each other or you can use one of them to supply the switch.

The middle contact was designed for alarm relay connection.

Power Supply:

44~56 VDC

LED indicator

ON –port 5 FX fiber is detected

OFF –port 5 FX fiber is not detected.

Flashing –port 5 FX fiber is active

PWR1

ON -- when V1+, V1- is connected

LNK /ACT

ON—TX link is detected

OFF –TX port is not detected

Flashing –TX port is active

6 pin Terminal Block x1

PWR2

ON -- when V2+, V2- is connected

FAULT

ON –

connect only PW1 or PW2.

OFF-

both PW1 and PW2 are connected

Recommendation for Shielded network cables

STP cables have additional shielding material that is used to reduce external interference. The

shield also reduces the emission at any point in the path of the cable. Our recommendation is

to deploy an STP network cable in demanding electrical environments. Examples of

demanding indoor environments are where the network cable is located in parallel with

electrical mains supply cables or where large inductive loads such as motors or contactors are

in close vicinity to the camera or its cable. It is also mandatory to use an STP cable where the

power device (like IP camera) is used outdoors or where the network cable is routed outdoors.

Table des matières

Autres manuels Lantech Changer

Lantech

Lantech LPES-2208CA Manuel utilisateur

Lantech

Lantech IGS-0008A Manuel utilisateur

Lantech

Lantech LGS-2404 Manuel utilisateur

Lantech

Lantech LGS-2816C-RPS Manuel utilisateur

Lantech

Lantech IPES-5408T-X-IGN Series Manuel utilisateur

Lantech

Lantech IPGS-0016 Manuel utilisateur

Lantech

Lantech IPES-5208T-X Series Manuel utilisateur

Lantech

Lantech IPGS-0204DSFP Manuel utilisateur

Lantech

Lantech LGS-1104 Manuel utilisateur

Lantech

Lantech LPGS-2424C Series Manuel utilisateur

Lantech

Lantech IPES-3424DSFP-2P Manuel utilisateur

Lantech

Lantech TPGS-L6208XT Manuel utilisateur

Lantech

Lantech IPES-0008A Series Manuel utilisateur

Lantech

Lantech IES-5416DF Series Manuel utilisateur

Lantech

Lantech IPGS-0204DSFP-12V Manuel utilisateur

Lantech

Lantech IPES-5416T Series Manuel utilisateur

Lantech

Lantech IES-5416T Series Manuel utilisateur

Lantech

Lantech IES-3208C Manuel utilisateur

Lantech

Lantech LES-2400-RPS Manuel utilisateur

Lantech

Lantech LGS-2300-RPS Manuel utilisateur

Lantech

Lantech IES-0208CA Manuel utilisateur

Lantech

Lantech mini Switch 800 Manuel utilisateur

Lantech

Lantech IGS-L5408MGSFPR-AC Manuel utilisateur

Lantech

Lantech TPGS-L6216XT Manuel utilisateur

Manuels Changer populaires d'autres marques

URC

URC Total Control MFS-8 Manuel utilisateur

Azbil

Azbil HPQ-D11 Manuel utilisateur

Sony

Sony DFS-900M Manuel utilisateur

SICK

SICK i17S Manuel utilisateur

F&F

F&F SZR-277 Manuel utilisateur

Shure

Shure UAMS/BK Manuel utilisateur

Dräger

Dräger X-zone Switch Off Manuel utilisateur

Asco

Asco Joucomatic 349 Series Manuel utilisateur

BT Mini Hub Manuel utilisateur

D-Link

D-Link DES-1226G Manuel utilisateur

Johnson Controls

Johnson Controls FS80-C Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuel utilisateur

MicroNet

MicroNet SP1200A Manuel utilisateur

Ruijie

Ruijie RG-PF2920 Series Manuel d'installation et d'exploitation

Altinex

Altinex DA1914SX Manuel utilisateur

MiLAN

MiLAN MIL-SM2401M Manuel utilisateur

RJM

RJM MASTERMIND PBC/6X Manuel utilisateur

Atlas

Atlas MMK-KVM8 Manuel utilisateur