La Crosse Technology TX6 Manuel utilisateur

TX6U

Wireless 433 MHz

Temperature Sensor/Transmitter

Instruction Manual

QUICK SET-UP GUIDE

Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries.

1. Have the indoor station and outdoor remote 3 to 5 feet apart.

2. Batteries should be out of both units for 10 minutes.

3. Place the batteries into the outdoor remote first then into the indoor station.

(All outdoor remotes must be started before the indoor station)

4. DO NOT PRESS ANY BUTTONS FOR 10 MINUTES.

In this time the display and sensor will start to talk to each other and the display will show both the indoor

temperature and an outdoor temperature. If the station does not display both temperatures after the 10

minutes please retry the set up as stated above. After both indoor and outdoor temperatures are displayed

for 10 minutes you can place your sensor outdoors and set your time.

The remote sensor should be placed in a dry, shaded area. The remote sensor has a range of 80 feet. Any

walls that the signal will have to pass through will reduce distance. An outdoor wall or window will have

20 to 30 feet of resistance and an interior wall will have 10 to 20 feet of resistance. Your distance plus

resistance should not exceed 80 ft. in a straight line.

NOTE: Fog and mist will not harm your remote sensor but direct rain must be avoided.

Battery Installation:

1. Remove the mounting bracket. The bracket snaps on and off easily.

2. Remove the battery cover, by sliding the cover down.

3. Observing the correct polarity install 2 AA batteries. The batteries will fit tightly (to

avoid start-up problems make sure they do not spring free).

4. Replace the battery cover by sliding upwards. Be sure battery cover is on securely.

MOUNTING THE REMOTE TEMPERATURE SENSOR/TRANSMITTER

The remote temperature sensor/transmitter can be mounted in two ways:

• with the use of screws, or

• using the adhesive tape.

A. MOUNTING WITH SCREWS

1) Remove the mounting bracket from the remote temperature sensor/transmitter.

2) Place the mounting bracket over the desired location. Through the three screw holes of the

bracket, mark the mounting surface with a pencil.

3) Where marked, start the screw holes into mounting surface.

4) Screw mounting bracket onto the mounting surface. Ensure that the screws

are flush with the bracket.

B. MOUNTING WITH ADHESIVE TAPE

1) With a nonabrasive solution, clean and dry the back of the mounting bracket

and the mounting surface to ensure a secure hold. The mounting surface

should be smooth and flat.

2) Remove the protective strip from one side of the tape. Adhere the tape to

the designated area on the back of the mounting bracket.

3) Remove the protective strip from the other side of the tape. Position the remote temperature

sensor/transmitter in the desired location, ensuring that the weather station can receive the signal.

Mounting

Bracket

SPECIFICATIONS

Temperature measuring range:

Outdoor: -21.8°F to 157.2°F with 0.2°F

resolution. (-29.9°C to 69.9°C

resolution) “OFL” displayed if

outside this range

Outdoor temperature checking

interval (remote temperature

sensor/transmitter):

Every 1 minute

Transmission Range: 80 feet (in open space)

Power Supply:

Temperature sensor/transmitter: 2 x AA, IEC LR6, 1.5V

Battery life cycle: Approximately 12 months

Recommended battery type: Alkaline

Dimensions (L x W x H)

Temperature sensor/transmitter: 1.57“ x 0.9“ x 5.04“

(40 x 23 x 128 mm)

WARRANTY INFORMATION

La Crosse Technology provides a 1-year warranty on this temperature sensor/transmitter. Contact La

Crosse Technology immediately upon discovery of any defects covered by this warranty.

Before sending the weather station in for repairs, contact La Crosse Technology. The temperature

sensor/transmitter will be repaired or replaced with the same or similar model.

This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty

batteries, or the temperature sensor/transmitter’s inability to transmit a signal due to any source of

interference.

LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL,

CONSEQUENTIAL, PUNITIVE OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE

OPERATION OR MALFUNCTION OF THIS WEATHER STATION. THIS PRODUCT IS NOT TO BE

USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. THIS PRODUCT IS NOT A

TOY. KEEP OUT OF CHILDRENS’ REACH.

This warranty gives you specific legal rights. You may also have other rights specific to your state. Some

states do no allow the exclusion of consequential or incidental damages therefore the above exclusion of

limitation may not apply to you.

For warranty work, technical support or information contact:

La Crosse Technology

1116 South Oak Street

La Crescent, MN 55947

Phone: 507.895.7095

Fax: 507.895.8000

e-mail: [email protected] (warranty work)

[email protected] (information on other products)

web: www.lacrossetechnology.com

FCC ID: OMO-01TX

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING

TWO CONDITIONS:

1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND

2. THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE

UNDESIRED OPERATION.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels La Crosse Technology Accessoires

La Crosse Technology

La Crosse Technology LTV-THP1-T1 Manuel utilisateur

La Crosse Technology

La Crosse Technology TX8U Manuel utilisateur

La Crosse Technology

La Crosse Technology TX7U Manuel utilisateur

La Crosse Technology

La Crosse Technology D012.104.E1 Manuel utilisateur

La Crosse Technology

La Crosse Technology D000.104 Manuel utilisateur

La Crosse Technology

La Crosse Technology TX60U-IT Manuel utilisateur

La Crosse Technology

La Crosse Technology LTV-POOLv2 Manuel utilisateur

La Crosse Technology

La Crosse Technology 925-1418 Manuel utilisateur

La Crosse Technology

La Crosse Technology TX191 Manuel utilisateur

La Crosse Technology

La Crosse Technology LTV-R1 Manuel utilisateur

La Crosse Technology

La Crosse Technology LTV-R3 Manuel utilisateur

La Crosse Technology

La Crosse Technology TX141-Bv2 Manuel utilisateur

La Crosse Technology

La Crosse Technology Alerts TX60U-IT Manuel utilisateur

La Crosse Technology

La Crosse Technology TX-23U Manuel utilisateur

La Crosse Technology

La Crosse Technology LTV-W2 Manuel utilisateur

La Crosse Technology

La Crosse Technology TX8U Manuel utilisateur

La Crosse Technology

La Crosse Technology TX15U Manuel utilisateur

La Crosse Technology

La Crosse Technology WCLTV-WSDR1 Manuel utilisateur

La Crosse Technology

La Crosse Technology TX23U Manuel utilisateur

La Crosse Technology

La Crosse Technology TX141TH-BCHv3 Manuel utilisateur

La Crosse Technology

La Crosse Technology TX141TH-BV4 Manuel utilisateur

La Crosse Technology

La Crosse Technology TX5 Manuel utilisateur

La Crosse Technology

La Crosse Technology CA82738-1 Manuel utilisateur

La Crosse Technology

La Crosse Technology TX13U Manuel utilisateur

Manuels Accessoires populaires d'autres marques

Hillco

Hillco 2810 Manuel utilisateur

Siemens

Siemens QSA2700D Manuel de l'opérateur

Contours

Contours ZY024 Manuel utilisateur

Saivod

Saivod VS621 Manuel utilisateur

Virtuox

Virtuox VirtuCLEAN 2.0 Manuel utilisateur

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manuel utilisateur

Z-Wave

Z-Wave HSD-200Z Manuel utilisateur

turck

turck FMX-IM-2UPLI63FX Manuel utilisateur

Decagon Devices

Decagon Devices 10HS Manuel utilisateur

UPPAbaby

UPPAbaby Cup Holder Manuel utilisateur

Elko

Elko SmartSensor Leakage Wireless Manuel utilisateur

Grizzly

Grizzly H8371 Manuel utilisateur

Panasonic

Panasonic HG-T Series Manuel utilisateur

IFM Electronic

IFM Electronic Efector 250 Series Guide de référence

DigiDesign

DigiDesign 888/24 I/O Manuel utilisateur

PROZIS

PROZIS QUAY Manuel utilisateur

patagonia

patagonia PSI Vest Manuel utilisateur

SFC Energy

SFC Energy EFOY GO! Manuel utilisateur