Johnson Controls M300CJ Manuel utilisateur

JCI-6724 • 05/24/04 — Page 1 of 4

M300CJ Module

(See wiring diagram Fig. 5 for M300RJ)

GENERAL

M300CJ Control Module — The M300CJ Address-

able Control Module provides Johnson Controls intelligent

control panels a circuit for Notification Appliances (horns,

strobes, speakers, etc.) or to monitor a telephone circuit.

Addressability allows the M300CJ to be activated, either

manually or through panel programming, on a select (zone

or area of coverage) basis.

M300RJ Relay Module — The M300RJ Addressable

Relay Module provides the system with a dry-contact output

for activating a variety of auxiliary devices, such as fans,

dampers, control equipment, etc. Addressability allows the

dry contact to be activated, either manually or through panel

programming, on a select basis.

FlashScan® (U.S. Patent 5,539,389) is a new communi-

cation protocol developed by NOTIFIER Engineering that

greatly enhances the speed of communication between ana-

log intelligent devices. Intelligent devices communicate in a

grouped fashion. If one of the devices within the group has

new information, the panel CPU stops the group poll and

concentrates on single points. The net effect is response

speed greater than five times that of other designs.

FEATURES

• Built-in type identification automatically identifies these

devices to the control panel.

• Internal circuitry and relay powered directly by two-wire SLC

loop.TheM300CJmodule requirespower(for horns,strobes,

etc.), audio (for speakers), or a telephone riser (for hand-

sets).Internalrelayfeature availableonFlashScan®systems

only.

• Integral LED “blinks” green each time a communication is

received from the control panel and turns on in steady red

when activated.

• LED blink may be deselected globally (affects all devices).

• High noise immunity (EMF/RFI).

• The M300CJ may be used to switch 24-volt NAC power,

audio (up to 70.7 VRMS) or telephone.

• Wide viewing angle of LED.

• SEMS screws with clamping plates for wiring ease.

• Direct-dial entry of address 01 – 159 on FlashScan® sys-

tems (IFC-640, IFC-3030), or 01 – 99 on traditional systems

(IFC-400, IFC-640, IFC-1010/2020, IFC-3030, or FC-2000).

• Speaker, audible/visual, and telephone applications may

be wired for Class B or A (Style Y or Z).

APPLICATIONS

The M300CJ is used to switch 24 VDC audible/visual power,

high-levelaudio (speakers), or controltelephone devices. The

M300RJmaybe programmed to operatedry contacts for door

holders, Air Handling Unit shutdown, etc., and to reset four-

wire smoke detector power.

FlashScan® is a registered trademark of NOTIFIER. Noryl® is a

registered trademark of GE Plastics, a subsidiary of General Elec-

tric Company.

6724mod2.tif

CONSTRUCTION

• The face plate is made of off-white Noryl®.

• Controls include two rotary switches for direct-dial entry of

address (01-159).

• The M300CJ is configured for a single Class B (StyleY) or

Class A (Style Z) Notification Appliance Circuit.

• The M300RJ provides two Form-C dry contacts that switch

together.

OPERATION

Each M300CJ or M300RJ uses one of 159 possible module

addresses on a SLC loop. It responds to regular polls from

the control panel and reports its type and status, including

the open/normal/short status of its Notification Appliance

S1570

7300-0554:131

California

State Fire

Marshal

Permit #2029

MARYLAND

State Fire Marshal

MEA

457-99-E

Vol. VIII

May 24, 2004

M300CJ and M300RJ

Control and Relay Modules

with FlashScan®

JCI-6724

This document is not intended to be used for installation purposes. We try to keep our

product information up-to-date and accurate. We cannot cover all specific applications

or anticipate all requirements. All specifications are subject to change without notice.

For more information, contact your

Johnson Controls Field Support Center.

507 East Michigan Street, Milwaukee, WI 53202

Page 2 of 4 — JCI-6724 • 05/24/04

RELAY CONTACT RATINGS

for both M300CJ and M300RJ

PRODUCT LINE INFORMATION

M300CJ Intelligent Addressable Control Module.

M300RJ Intelligent Addressable Relay Module.

A2143-20 Capacitor, required for Class A (Style Z) opera-

tion of speakers.

SMB500 Optional Surface-Mount Backbox.

CB500 Control Module Barrier — required by UL for

separating power-limited and non-power limited

wiring in the same junction box as M300CJ.

noitpircseDdaoLnoitacilppA mumixaM egatloV tnerruC gnitaR

evitsiseRdedoC-noNCDV03A0.3

evitsiseRdedoCCDV03A0.2

evitsiseRdedoC-noNCDV011A9.0

evitsiseRdedoC-noNCAV521A9.0

)sm5=R/L(evitcudnIdedoCCDV03A5.0

)sm2=R/L(evitcudnIdedoCCDV03A0.1

)53.0=FP(evitcudnIdedoC-noNCAV521A5.0

Circuit (NAC). The LED blinks with each poll received. On

command, it activates its internal relay. The M300CJ super-

vises Class B (Style Y) or Class A (Style Z) notification or

control circuits.

Upon code command from the panel, the M300CJ will dis-

connect the supervision and connect the external power sup-

ply in the proper polarity across the load device. The discon-

nection of the supervision provides a positive indication to

the panel that the control relay actually turned ON. The ex-

ternal power supply is always relay isolated from the com-

munication loop so that a trouble condition on the external

power supply will never interfere with the rest of the system.

Rotary switches set a unique address for each module. The

address may be set before or after mounting. The built-in

TYPE CODE (not settable) will identify the module to the

control panel, so as to differentiate between a module and a

sensor address.

SPECIFICATIONS for M300CJ

Normal operating voltage: 15 to 32 VDC.

Maximum current draw: 6.5 mA (LED on).

Average operating current: 350 µA direct poll (CLIPmode),

375 µA group poll (FlashScan® mode) with LED flashing.

External supply voltage (between Terminals T3 and T4):

maximum 80 volts (RMS or DC).

Drain on external supply: 2 mA maximum (using internal

EOL relay).

EOL resistance: 47K ohms.

Temperature range: 32°F to 120°F (0°C to 49°C).

Humidity range: 10% to 93% non-condensing.

Dimensions: 4.5" (11.43 cm) high x 4" (10.16 cm) wide x

1.25" (3.175 cm) deep. Mounts to a 4" (10.16 cm) square x

2.125" (5.398 cm) deep box.

SPECIFICATIONS for M300RJ

Normal operating voltage: 15 to 32 VDC.

Maximum current draw: 6.5 mA (LED on).

Average operating current: 230 µA direct poll (CLIPmode),

255 µA group poll (FlashScan® mode) with LED flashing.

EOL resistance: not used.

Temperature range: 32°F to 120°F (0°C to 49°C).

Humidity range: 10% to 93% non-condensing.

Dimensions: 4.5" (11.43 cm) high x 4" (10.16 cm) wide x

1.25" (3.175 cm) deep. Mounts to a 4" (10.16 cm) square x

2.125" (5.398 cm) deep box.

6724mt1.wmf

6724mt2.wmf

MOUNTING

DIAGRAMS

Note CB500 Module Barrier,

which creates isolated quadrant.

6724rate.tbl

JCI-6724 • 05/24/04 — Page 3 of 4

The Face Plate

WIRING DIAGRAMS

The following wiring diagrams are provided:

1) M300CJ: Typical notification appliance circuit configuration,

NFPA Style Y.

2) M300CJ:Typicalfault-tolerant notification appliancecircuit con-

figuration, NFPA Style Z.

3) M300CJ: Typical wiring for speaker supervision and switch-

ing, NFPA Style Y.

4) M300CJ: Typical fault-tolerant wiring for speaker supervision

and switching, NFPA Style Z.

5) M300RJ: Relay module wiring diagram.

Fig. 1 M300CJ: Typical notification appliance circuit configuration, NFPA Style Y.

Fig. 2 M300CJ: Typical fault-tolerant notification appliance circuit configuration, NFPA Style Z.

• Connect modules to Listed compatible Johnson Controls control panels only.

• All wiring shown is supervised and power limited.

• Module polarities are shown in alarm.

• Connect modules to Listed compatible Johnson Controls control panels only.

• All wiring shown is supervised and power limited.

• Module polarities are shown in alarm.

6827wir1.wmf

6827wir2.wmf

j6724fc.wmf, JCI01rev.tif

Page 4 of 4 — JCI-6724 • 05/24/04

Fig. 3 M300CJ: Typical wiring for speaker supervision and switching, NFPA Style Y.

• Connect modules to Listed compatible

Johnson Controls control panels only.

• All wiring shown is supervised.

• Wires must be supervised per NFPA.

• Module polarities are shown in alarm.

Fig. 4 M300CJ: Typical fault-tolerant wiring for speaker supervision and switching, NFPA Style Z.

• Connect modules to Listed compatible Johnson Controls control panels only.

• All wiring shown is supervised.

• Wires must be supervised per NFPA.

• Module polarities are shown in alarm.

6724wir3.wmf

6724wir4.wmf

6724wir5.wmf

Fig. 5

M300RJ: Relay module

wiring diagram.

• Connect modules to Listed

compatible Johnson Controls

control panels only.

• Module does NOT supervise

controlled circuits.

NOTE regarding AUDIO AMPLIFIER in Figures 3 & 4 above:

1) Audio circuit wiring must be twisted-pair as a minimum. See installation manual for detailed information.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Johnson Controls Unité de contrôle

Johnson Controls

Johnson Controls S1-TTSCC Manuel utilisateur

Johnson Controls

Johnson Controls VG7000 Series Manuel utilisateur

Johnson Controls

Johnson Controls Tyco DV-5a Series Manuel utilisateur

Johnson Controls

Johnson Controls VG1xA5Gx Manuel utilisateur

Johnson Controls

Johnson Controls GS-20 Series Manuel utilisateur

Johnson Controls

Johnson Controls MS-IOU4710-0U Manuel utilisateur

Johnson Controls

Johnson Controls Digital Vision Network 5000 Series Guide de démarrage rapide

Johnson Controls

Johnson Controls GH-5000 Manuel utilisateur

Johnson Controls

Johnson Controls Tyco DV-5a Series Manuel utilisateur

Johnson Controls

Johnson Controls METASYS NU-XBN101-0 Manuel utilisateur

Johnson Controls

Johnson Controls GM 20 Series Manuel utilisateur

Johnson Controls

Johnson Controls MS-NCM4510-2 Manuel utilisateur

Johnson Controls

Johnson Controls A19ZBC Series Manuel de service

Johnson Controls

Johnson Controls System 350 Manuel de service

Johnson Controls

Johnson Controls S1-TTSCC01 Guide de démarrage rapide

Johnson Controls

Johnson Controls tyco AMD-2 Manuel utilisateur

Johnson Controls

Johnson Controls Penn System 350 S350P Manuel utilisateur

Johnson Controls

Johnson Controls Tyco RSV-1 Manuel utilisateur

Johnson Controls

Johnson Controls Tyco DV-5a Series Manuel utilisateur

Johnson Controls

Johnson Controls Autocall MX Indoor Isolated Callpoint Manuel utilisateur

Johnson Controls

Johnson Controls VP1000 Series Manuel utilisateur

Johnson Controls

Johnson Controls VP101DBB Manuel utilisateur

Johnson Controls

Johnson Controls VMA 1410 Guide d'installation

Johnson Controls

Johnson Controls A19 Series Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur