IBeam TE-7VS-4 Manuel utilisateur

TE-7VS-4 User Manual

iBeamUSA.com

MetraDealer.com

techsupport@metra-autosound.com

� TECH SUPPORT

l ::: J 800-253-8324

7"

QUAD MONITOR

1.

Sun shade

2.

Bracket knobs

3.

Bracket

4.

LCD screen

5.

Menu

6.

CH 1

7. CH 2

8. Power

9. CH 3

10. CH 4

11. Mode switch

12. R/C Window

1

SPECIFCATIONS

REMOTE CONTROL

2

CONNECTION

TURNING

AV 1

AV 2

AV 3

AV 4

3

Monitor Bracket Installation

1.

Remove the screw from monitor then take out the monitor. Place U type bracket in

the installation location and mount with 3 screws.(see below pictures)

2. After screwing bracket in place, put the monitor into the bracket,adjust angle and

lock it in place with thumb screws. (see below pictures)

3. Finish installation. The adjustable angle is forward 30

°

and backward 30

°

.

(see below pictures)

4

Accessory

 



1 



 

n r <·.,

r

Announcements

5

n

For your safety, please do not watch video or operate the monitor when

driving. If the device stops working please do not dismantle the product

and consult customer service.

Warning: Please install this device in accordance with laws and

regulations. We take no responsibility for any illegal product installation.

Notes:

_______________________________________________________________________________

IMPORTANT

If you are having difficulties with the installation

of this product, please call our Tech Support line

at 1-800-253-TECH. Before doing so, look over

the instructions a second time, and make sure

the installation was performed exactly as the

instructions are stated. Please have the vehicle

apart and ready to perform troubleshooting

steps before calling.

When connecting with power cable, please make sure not to mistake the positive and

negative pole, otherwise the fuse will blow immediately for security protection.If ithappens,

please replace the blown fuse with a new one with same specification, after connecting

properly to the right pole. Don’t randomly increase the current rating of the fuse, and NEVER

use metal wire asa substitute.

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by

enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps

toward a better tomorrow.

Metra recommends MECP

certified technicians

Version 1.0

iBeam TE-7VS-4 Manuel utilisateur

Manuels écran tactile populaires d'autres marques