HP ProCurve Networking J8462A Manuel utilisateur
61195864L1-13B, April 2005 www.procurve.com Copyright 2005 Hewlett-Packard Development Company, LP
Quick Start Guide 5991-2108
ProCurve Secure Router dl Analog Modem Backup Module
J8462A
SPECIFICATIONS
Features ITU V.90 Compliant
Async
Standards FCC Part 15 Class A, EN 55022 Class A, EN 61000-3-2,
EN 61000-3-3
ETSI TBR 21, IC CS-03, ACTA/FCC Part 68, AS/ACIF S002
UL/CUL 60950, AS/NZS 60950, EN 60950, IEC 60950
Physical Dimensions: 6.35cm (2.5 in) W x 9.53cm (3.75 in) D
Operating Temperature: 0°C to 50°C (32°F to 122°F)
Relative Humidity: Up to 95 percent, noncondensing at 30°C
(86°F)
Non-Operating Temperature: -20°C to 70°C (-4°F to 158°F)
Non-Operating Relative Humidity: Up to 95 percent,
noncondensing at 30°C (86°F)
Altitude: Up to 3.05 km (10,000 ft)
Eth 0/1
Eth 0/2
dl
3
P/N: J8462A
US: PNBMM04AJ8462
IC: 2250A-J8462
ITE
32F8
P/N: J8462A
US: PNBMM04AJ8462
IC: 2250A-J8462
ITE
32F8
2
P/N:J8462A
US:PNBMM04AJ8462
IC:2250A-J8462
ITE
32F8
1
INSTALLATION INSTRUCTIONS
1. Remove power from the base unit.
2. If the ProCurve Router interface module is already installed in the
ProCurve Secure Router chassis, release the screws at both
edges of the module front panel and slide the module out of the
chassis.
3. Carefully align the P1 connector on the interface module with the
J1 connector on the backup module. Using only fingertip pressure
so that neither circuit board bends or flexes, ensure that the
connectors are firmly seated. Secure the backup module to the
interface module using the screws and standoff posts supplied.
4. Slide the interface module with the backup module attached into
the ProCurve Secure Router option slot until the module is firmly
seated against the chassis.
5. Secure the screws at both edges of the module.
6. Connect the cables to the associated device(s).
7. Complete installation of the base unit.
8. Restore power to the base unit.
ANALOG MODEM BACKUP (RJ-11) CONNECTION PINOUT
Pin Name Description
1-3 — Unused
4 R Network-Ring
5TNetwork-Tip
6-8 — Unused
Note For safety information for the routers and all modules,
please refer to the safety and ESD precautions in the
ProCurve Secure Router Installation Guide included
in your router shipment.
61195864L1-13B, April 2005 Printed in the USA Copyright 2005 Hewlett-Packard Development Company, LP
Quick Start Guide 5991-2108
ProCurve Secure Router dl Analog Modem Backup
Module
ANALOG MODEM BACKUP MODULE COMMANDS
alias <text>
Comment line to provide the text name assigned by the SNMP network
management system.
caller-id override always <number>
Forces a replacement of the incoming caller ID number with the number
given. The received caller ID, if any, is discarded, and the given override
number is used to connect the incoming call to a circuit of the same number.
Use no caller-id override (default) to disable any caller ID overrides.
caller-id override if-no-CID <number>
Allows a replacement of the received caller ID number, but only if there is no
caller ID available on the incoming call. The received caller ID, if available,
is used to connect the call. However, if no caller ID is received, the given
override number is used to connect the incoming call to a circuit of the same
number.
description <text>
Comment line to provide an identifier for this interface (for example, circuit
ID, contact information, etc.).
<text> Shows up to 80 alphanumeric characters.
dialin
Enables the modem for remote console dialin disabling the use of the
modem for backup.
init-string <string>
Specifies an initialization string for the modem using standard AT
commands.
<string> Initialization string using standard AT
commands. The default string is
ATE0Q0V1X4\N0.
shutdown
Turns off the interface. By default, all interfaces are disabled. Use the no
shutdown command to enable the interface and allow it to pass data.
Note This command list is an illustration of available
commands. For complete command descriptions and
default values, refer to the SROS Command Line
Interface Reference Guide provided on your ProCurve
SROS Documentation CD.
Autres manuels HP Modem
HP
HP Pavilion xe800 - Desktop PC Manuel
HP
HP V.90 56K PCI Modem Manuel utilisateur
HP
HP p5091a Manuel utilisateur
HP
HP Compaq Presario Manuel utilisateur
HP
HP D7808A Manuel utilisateur
HP
HP J8135A Manuel utilisateur
HP
HP Pavilion 9888 Manuel
HP
HP 8886 - Photosmart Camera Dock Digital Docking... Manuel utilisateur
Manuels Modem populaires d'autres marques
Davicom
Davicom DM562AP Manuel utilisateur
EpiValley
EpiValley TATA indicom SXC-1080 Manuel utilisateur
Zte
Zte WiMAX Manuel utilisateur
Intelimax
Intelimax MA-2060 Manuel utilisateur
SMC Networks
SMC Networks D3CM1604V Manuel d'utilisation et d'entretien
Telstra
Telstra Wi-Fi 4G Advanced Pro X Manuel utilisateur
US Robotics
US Robotics 3453C Manuel utilisateur
MaxTech
MaxTech Plug & Play Internal Voice/FAX/Data/SVD... Manuel utilisateur
Zte
Zte MF823 Manuel utilisateur
Four-Faith
Four-Faith F1403 Manuel utilisateur
Sierra Wireless
Sierra Wireless AIRLINK MP595W Manuel utilisateur
Gemtek
Gemtek WiMAX WIXFBR-103 Manuel utilisateur