Heacent Prusa i3 Manuel utilisateur
Heacent 3D printer assembly manual
Prusa i3
Y-axis assembly
1. Y axis motor section：
Find the belowing parts bag, Y-axis motor
Assembled parts are separated as shown below, note that the motor between the Y-axis motor bracket with
a nylon pad to use
Installed after the negative with a positive picture, note the Y-axis limit switch open
2.Y shaft portion of the belt tension
Find the belowing parts
Installed after the following chart, note that through the bearings do not tighten the screws, allow enough
space for the bearing rotation
3.Y axis rack assembly
Find the belowing parts
Axis rails 395mm * 2, screw 415mm * 2, screw 310mm * 2, screw 205mm * 3, * 4 linear bearings
First rail assembly with the direction as shown
The figure axis is 395mm to 415mm screw
As shown after installation
Part 2 packed out parts, install the printer front below
As shown after installation
Remove the Y-axis motor good step Part 1 rear rack mounted assembly diagram Press
As shown after installation
4.Heating plate mounting
Find out the following diagram parts
Install the belt holder in accordance with the following diagram
After assembly the following diagram：
Installation of heating plate
Note that the line toward the direction of the heating plate where the motor, spring screws installed in the
figure.
Installed after the Y-axis linear bearings card in care of the heating plate acrylic slot, tied with cable ties, as
shown below
Installing toothed belt according to the following chart
Belt connector according to the following chart card in slot Y axis belt fixed
Table des matières
