Haier HWM60-10 Manuel utilisateur
Full Automatic Washing Machine
HWM60-10
User's manual
This manual is for
Please read this manual
carefully before using.
Retain it for future reference. 0030807260
Contents
Names of the parts................................................1
Safety precautions ...............................................2
Installation and adjustment ..................................4
Install the water inlet hose....................................6
Preparation before washing ................................7
Put in the laundries ..............................................8
Put in the detergent ..............................................9
Use the operation buttons ...................................10
Close the top lid ...................................................14
Finish washing .....................................................15
Disposal after washing .........................................15
Trouble shooting Answer to question................16
Packing list ...........................................................17
Specifications...........................................back cover
Meaning and description of the symbols
Before Using
Before Using
Names of the parts
Warning sign
Forbidden sign
Contents marked with that symbol
are related to the safety of the
product and the personal safety
of the users. Please operate in
strict conformity to the contents,
otherwise it may cause damage
of the machine or injure the
personal safety of the user.
Contents marked with that symbol
are actions forbidden to perform.
Performing of those actions may
result in damage of the machine
or injure the personal safety of
the user.
Accessories
Bottom plate
(one)
water inlet hose
(one)
ST4X16
tapping screws
(eight)
Lint filter
(two)
Adjustable foot
fixed foot (3)
back cover
Cabinet
base frame
Drain hose
Control panel
film
Control panel
Filter cover
Power line
Pulsator
Inner tub
Detergent box
Lint filter
Top lid B
Cabinet handle
water valve
Top lidA Sop mat
(Installed by user)
The end connecting
to the washing machine
The end connection
to the water inlet
hose
Before Using
Before Using
Safety precautions
Please plug the plug on special 220V AC
receptacle.Please guarantee that the
earthing wire is ear-thed reliably.
The power cord plug should be convenient
to be pluged in or pluged out with hand
while the washing machine runs normally.
Be sure to pull the plug out and close the
water tap when the machine is idle,when
moving the machine,or when cleaning
the machine.Do not use wet hand to ins-
ert or pull out the power plug.
In case the washing machine is installed on ground with
carpet, do not block the ventilation hole with carpet.
Do not let the machine share one receptacle with other electric appliances. If the power plug is damaged, or the
plugging into the receptacle is loose, do not use the plug any more.
Do not wash water-proof laundries like the raincoat,
bike covers etc. to avoid abnormal vibrations in spinning.
Do not use water hotter above 50 C .
Do not put the machine at damp place like
the bathroom. Never wash it with water.
Do Not put wet laundries on the control panel.
soft items
The ventilation holes
at the bottom
Do not bend ,extend,twist,bind by force.Do not press or nip it with weight.
Keep the pin of the power plug clean,if the power plug is polluted with dust,
please wipe with dry cloth carefully.
earth
Do not decompose, repair or alter the
machine by yourself.
Do not put any hot or heavy items (such
as the kettle with hot water ) on the
washing machine.
Do not wash laundries with volatile
materials (such as thinner, petrol etc.)
The handicapped or children without
care shall not use the machine.
Keep the machine away from direct
sunlight and heat source like the heater.
Before Using
Before Using
Do not stretch hands into the working
machine. It is dangerous even if the
rotation is slow. Take special care of
the children.Do not let the children
climb the washing machine.
Petrol
Thinner
.
To prevent your laundries and washing
machine from damage,be sure to take
out all of the foreign materials from your
pocket,such as coins,buttons,sand or
hairpins etc.
Before washing,please check if the water
tap is open ,and if the water inlet pipe is
connected properly.
It is suggested to use low-foaming was-
hing powder
To prevent the lint in the tub from blocking
the cascade outlet and influencing the
cascade effect, please keep the lint filter
in good condition, and install it to proper
position during washing.
The largest allowed slope of the
shank base of the machine is 2 .
The slanting or rough ground will
result in unstable running or
stoppage of the machine. Please
adjust it with following methods:
Adjust the adjustable foot:
Adjust the installation position
Before Using
Before Using
Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is
very important to your security and correct operating the machine.
1.Press downward to assmble.
2.Pull upward to detach.
1.To twist the adjustable foot, please
first lift up the side of the foot slightly,
loosen the adjustable nut, and twist
the foot.
2.Fasten the nut after adjustment.
Loosen Fasten
High Low
adjustable nut
adjustable foot
Install the bottom plate
After you open the package,
please lean the washing
machine gently down on soft
items ( like the towel cloth,
blanket, etc. ). Install the
bottom plate to the bottom of
the machine with the eight
screws by a cross screwdriver,
then lift the machine up gently.
See to the figure:
Back
Front
Bottom plate
Screw
Soft items
Put down Put up
Put down Put up
Install the lint filter
1.The height of the drain hose shall be
less than 10cm, or the drainage will not
be smooth, and cost such long time that
the machine may stop at mid way.
2.Do not trample or press the drain hose.
If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
4.If extra drain hose is needed, please
make separate purchase. The inner
diameter of the extra hose shall not
less than 30mm, and the length shall
not exceed 1.5m.
1.Lean the machinedown gently withthe
front surface facingthe ground. Loosen
the eight screwsby a crossscrewdriver.
3.Extend the drain hose from the left side.
Push the drain hose into the groove with
hands.
4.Install the bottom plate (as per indicated
before), then lift the machine up gently.
2.Pull out the drain hose from the groove at the
right side.
Back
Front
Bottom plate
Soft item
Use groove at
this side after
direction changing
Page 4
Push the drain hose
into the groove with
hands at this point
How to change the direction of the drain hose
Usage of the drain hose
The drain hoseshall drain smoothly
5.If the extrahose is toolong,
cut it eitherat Aor at Bpoint.
Before Using
Before Using
Install the water inlet hose
1. Insert a new flat washer into each end of the inlet hoses. Firmly put the
washers in the coupling.
2. Connect the water inlet hoses to the water faucet.
Use the new hose sets supplied with the washer.
Any other old hose sets should not be used.
You may have to use pliers to tighten the coupling.
Do not over tighten because you may cause
damage to the valve.
Note:
3. Connect the other ends to their respective cold and hot water inlet valve
located at the rear of the washer
Check the connection between the water inlet
hose and the water tap
1.Close the water tap.
2. Pull off the water inlet hose from the water tap
and washer
Take down the water inlet hose
Install the water inlet hose
4.Fasten the nut. Swing it gently to confirm if it's suitable.
Water absorption cushion
Nut of the water inlet hose
Jointer of the water inlet valve
1.Swaying the hose gently to confirm if it is
fastened stable.
2.After installation, open the tap to check if it leaks.
3.Do not bend the hose with overstrain.
4.Before each usage please check if the connection
between the water inlet hose and the water tap,
and the connection between the water inlet hose
and washer are firm, so as to prevent dropping
from improve Installation position.
Before Using
Before Using
Confirm if
there's special
requirment for
the laundries.
Clear the pocket.
Take out the
coins , sand,
hairpins etc.
Fasten the
buttons and
zippers.
When the pulsator
is running , the
buttons of the
laundries may
cause noise. For
the sake of
discretion,please
put the laundries
with buttons into
other laundries.
Preparation before washing
1.Connect the water inlet hose and open
the water tap .
2.Confirm that the washing machine is
earthed reliably . Then insert the power
plug into the receptacle. Do not connect
the earth terminal to the gas pipe and
tap water pipe.
3.Put down the drain hose.
The quantity of
the laundries
shall not exceed
the rated value.
The big laundries
like the jeans
shall be put in
loosely.
Using process
Using process
1 Preparation before washing
Pay attention to followings before washing the laundries
A. Check if the laundries are applicable for washing with machine.
b. Divide the laundries that are not colorfast from other laundries.
c. Put those laundries difficult to absorb water into water with hand.
d. For those laundries with heavy soil, please first remove the dirt like mud or dust.
For the parts with heavy soil, please apply detergent on them in advance, which
can make it easier to remove the soil.
e. For those laundries that may get lint ball and those with long fur, turn itover before
putting in.
f. Do not put those laundries polluted by chemicals into the washing machine directly.
Reference weight of the laundries:
working suit up,down
jeans about 800g
shirt jacket
single bed sheet
Socks
underpants
undershirt
pajamas
blanket
cotton,about 900g
cotton,about
300g
cotton,about
800g
cotton,about 600g
blending,about 50g
cotton,about 70g
cotton,about 180g
Using process
Using process
2 Put in the laundries
cotton,about 1120g
blending coat
(about 800g)
The capacity of washing and spinning of
the machine refer to the largest weight of
the standard laundries under dry condition
that can be washed or spinned in one time.
One time washing quantity shall be lower
than the rated capacity. The largest capacity
of this machine is 5.0kg.
The thickness, size, type of the cloth will
influence the actual washing capacity. It is
suitable for one time washing to put in
reasonable amount of laundries and the
laundries can be turned round in washing.
Do not select "High" water level for
laundries small than 0.5kg, so as to avoid
splashing of water.
Autres manuels pour HWM60-10
1
Table des matières
Autres manuels Haier Rondelle
Haier
Haier HW150-BP14986E Manuel utilisateur
Haier
Haier XQG56-B1086 Manuel utilisateur
Haier
Haier XQS60-78 Manuel utilisateur
Haier
Haier HW90-BP14636 Manuel utilisateur
Haier
Haier HBF600T Manuel utilisateur
Haier
Haier HWM70-9288 Manuel utilisateur
Haier
Haier HWM110-0713S Manuel utilisateur
Haier
Haier HWM85-0713S Manuel utilisateur
Haier
Haier HWM-13.0/S Manuel utilisateur
Haier
Haier HM600T Manuel utilisateur
Haier
Haier HWM65-828 Manuel utilisateur
Haier
Haier HW50-1010W Manuel utilisateur
Haier
Haier HWM65-1128NZP Manuel utilisateur
Haier
Haier HVS1000 Manuel utilisateur
Haier
Haier HLP24E Manuel utilisateur
Haier
Haier HW80-BP1439N Manuel utilisateur
Haier
Haier JW-PK60A Manuel utilisateur
Haier
Haier HWM100-113S Manuel utilisateur
Haier
Haier HWM130-0523S Manuel utilisateur
Haier
Haier JW-K60B Manuel utilisateur
