Grundig GSTB1701USB Manuel utilisateur

e Gold Technical Support Line:1902 215 259

Personal Product Support

(Charges will apply at $2.95 per minute)

GSTB1701USB

DIGITAL

TERRESTRIAL

RECEIVER

Thank you for buying this Grundig product, which is designed to give you many years of

trouble-free service.

You may already be familiar with using a similar unit, but please take time to read these

instructions. They are designed to familiarize you with the unit's many features and to ensure

you get the very best from your purchase.

Your safety and the safety of others is important. Please therefore, ensure you read the "Safety

Instructions" you operate this unit.

In the unlikely event that your product fails to work normally, please call the below Grundig

warranty number for support.

Safety is important

before

Warranty

Australia

Grundig Warranty: 1800 509 394

New Zealand

Grundig Warranty: 0800 450 259

INTRODUCTION

SAFETY INSTRUCTIONS

·Always read the safety instructions carefully

Keep this User's Manual for future reference

Keep this equipment away from humidity

Lay this equipment on a reliable flat surface before setting it up.

Do not stand it on soft furnishings.

If any of the following situation arises, get the equipment checked by a service technician:

- The equipment has been exposed to moisture.

- The equipment has been dropped and damaged.

- The equipment has obvious sign of breakage.

- The equipment has not been working well or you cannot get it work according to User's

Manual.

To prevent the risk of electric shock, do not open the cover or the back of the receiver and

Do not block the ventilation holes of the device. Leave appropriate gap above and around

it to allow for adequate ventilation.

Do not place the device in an unventilated cabinet or on top of a unit which emits heat.

No part of this publication may be reproduced in any form by any means without the

prior written permission. Other trademarks or brand names mentioned herein are trademarks

or registered trademarks of their respective companies.

Information in this document is subject to change without notice. The manufacturer does not

make any representations or warranties (implied or otherwise) regarding the accuracy and

completeness of this document and shall in no event be liable for any loss of profit or any

commercial damage, including but not limited to special, incidental, consequential, or other

damage.

Warning

Disclaimer

expose this apparatus to rain or colds.

1. INTRODUCTION........................................................................1

2. SAFETY INSTRUCTION.............................................................2

3. ABOUT THE SET TOP BOX.........................................................4

4. FRONT & REAR PANEL ILLUSTRATION......................................5

5. REMOTE CONTROL.................................................................. 6

6. SYSTEM CONNECTION.............................................................8

7. GETTING STARTED...................................................................9

8. OPERATION.............................................................................10

9. CHANNEL LIST.........................................................................12

10. SYSTEM SET-UP......................................................................13

11. FAVOURITE LIST......................................................................15

12. TROUBLE SHOOTING..............................................................16

13. SPECIFICATIONS....................................................................17

14. WARRANTY.............................................................................18

CONTENTS

This DVB-T TV Receiver is a Free-To-Air digital terrestrial receiver, allowing you

to access free-to-air digital terrestrial TV channels and radio broadcasts on your

TV set. Its digital reception covers VHF & UHF band. Compared with the analog TV

programs, digital TV programs eliminate the noise and interference but offer high

quality video and audio. An on-screen initial installation guide is provided so that

you can easily start to enjoy watching the programs. In addition, a fully featured

remote control is included that offers you access to every feature with a simple

press of a button.

- Full comply with Australia DVB-T standard

- Full MPEG2 ISO/IEC 13818 transport stream compliant audio/video decoding

- Bandwidth of 7MHz supported

- COFDM demodulator

- Automatic/manual channel search

- Channel lock, moving and deletion

- Parental lock control

- EPG (Electronic Program Guide) and teletext function (where available)

- USB port for upgrade software and playback of MP3 and JPG files

- Tuner RF in/loop through

CVBS/

Before installation, please check the items of the package. The package should

contain the following items:

1. DVB-T receiver x 1 pcs

2. Remote control x 1 pcs

3. AAA size battery for the remote control x 1 pair

4. Instruction manual x 1 pcs

5. AV cable(red/yellow/white) x 1 pcs

Main Features

Package Contents

- Component/ S-Video/Digital Audio via coaxial

- Full function remote control

ABOUT THE SET TOP BOX

AC 220-240V

~50/60Hz

USB

Front panel

Remote sensor Standby button

Channel up

Channel down

Power indicator

FRONT & REAR PANEL ILLUSTRATION

Rear panel

USB slot

(For

playback of

MP3 and JPG files)

update the software

and

Coaxial Digital Audio

RFin

for an external TV aerial

Loop though

for an external device

AC Mains

S-Video

Composite Video

Down Mix Audio

2 Channel L/R

Component Video

(Y Cb Cr)

DTV/ VCR

EXIT

CH+

VOL

PAUSE FAVORITE

LANG INFO

RECALL

MUTE

TV/RADIO AUDIO

EPG

TTX SUBTITLE

EXIT

CH+

VOL

PAUSE FAVORITE

AUDIO INFO

RECALL

MUTE

TV/RADIO USB

EPG

TTX SUBTITLE

Power On/Standby

(Switch the STB ON/STANDBY mode)

Numeric entry

(Enter numeric values and to select the

channel directly by entering it's number)

(Open up menu)

Red Button

(To assist the operation of teletext function)

Cursor/ Enter

( to select sub-menu from the

main menu and channel +/-,

to select menu and sub-menu

from the menu and volume +/-,

Press to enter.)

Yellow Button

(To assist the operation of teletext function)

Mute

RECALL

(switch to previous channel)

EPG

(Open up Electronic Program Guide

menu)

TTX

(Open Teletext function)

EXIT

(Exit from menu)

Green Button

(To assist the operation of teletext function)

Blue Button

(To assist the operation of teletext function)

FAVOURITE

(Open up Favourite list)

PAUSE(To freeze the picture )

INFO

(To view the current channel information)

AUDIO

(Select audio mode: Left / Right /Stereo / Mono)

USB

(Select the USB device)

TV/RADIO

(Switch between TV and Radio)

SUBTITLE

(Switch On/Off Subtitle)

REMOTE CONTROL

Remove the battery cover from the remote control and put two AAA size batteries

inside the compartment.

The diagram inside the battery compartment shows the correct way to install the

batteries.

1. To use the remote control, point it towards the front of the digital set top box.

2. The remote control has a range of up to 7 metres from the set top box at an angle of

up to 60 degrees.

3. The remote control will not operate if its path is blocked.

Using the Remote Control

Caution:

1. Keep batteries out of children's reach.

2. Don't attempt to recharge, short-circuit, disassemble, heat or throw the batteries

into the fire.

3. Always replace both batteries at the same time. Never mix new and old batteries or

batteries of a different type.

4. If you don't intend to use the remote control for an extended period, remove the

batteries to prevent possible leakage and corrosion.

5. Do not drop, apply shock or step on the remote control.

6. Do not spill water on the remote control.

Installing the batteries

NOTE

If the receiver does not operate when operating the remote control from a

close range, you need to replace the batteries.

NOTE

Sunlight or very bright light will decrease the sensitivity of the remote

control.

AC220-240V

~50/60Hz

AC220-240V

~50/60Hz

AC220-240V

~50/60Hz

There are many different types of TV/VCR and other equipment that you can connect to the STB.In this

manual you will see some of the most ways to connect your equipment.common

General

SYSTEM CONNECTION

Connecting to the video recorder

Connecting to a Hi-Fi system

Coaxial cable

Hi-Fi amplifier

Connecting to the TV with AV/Y Cb Cr

/ S-Video cable

Antenna

RF cable

Red

Yellow

White

Red

Green

Blue

Red

White

Yellow Green

Blue

Red

Antenna

RF cable

Red

Yellow

White

Red

Green

Blue

Red

White

Yellow Green

Blue

Red

VideoCassette Recorder

VCR

S-Video cable

Y Cb Cr cable

AV cable

Y Cb Cr cable

AV cable

Switching on

Turn on your TV set and select the corresponding AV input,then set the video system of your TV to PAL.

Connect the Set Top Box to mains power supply AC 220-240V 50/60Hz, the power indicator on the

front of the unit will turn red(Standby mode).Press the POWER button on unit or remote control to turn

on the unit,then the indicator will turn to green.

GETTING STARTED

Press the "MENU" button and enter the pin code to access the

setup menu of the STB (the default pin code is 888888).

Press the "LEFT" or "RIGHT" cursor button to highlight .

Press the "OK" Button to enter the sub-menu.

Highlight the "Scan Mode" and press the "LEFT" or "RIGHT" cursor

button to select "Auto scan".

Press the "UP" or "DOWN" cursor button to highlight the "Start Scan"

and then press the "OK" button to confirm.

Press the "EXIT"button to quit.

Automatic channel scan

Manual channel scan

Press the "MENU" button and enter the pin code to access

the setup menu of the STB.(The default pin code is 888888)

Press the "LEFT" or "RIGHT" cursor button to highlight .

Press the "OK" Button to enter the sub-menu.

Highlight the "Scan Mode" and press the "LEFT" or "RIGHT" cursor

button to select "Manual scan".

Press the "DOWN" cursor button to highlight "Channel Number."

option and input the desired channel number.

Press the "UP" or "DOWN" cursor button to highlight the "Start Scan" and then

press the "OK" button to confirm.

Press the EXIT"button to quit.

NOTE

Settings Scan

Favorites

Channels

Scan Mode

Channel Number

Start Scan

Auto Scan

Scan

Settings Scan

Favorites

Channels

Scan Mode

Channel Number

Start Scan

Manual Scan <>

EXIT

Scan

All the settings in the setup menu are fixed. To change anything the correct password will be

required.

When the search is finished, the first channel of the channel list and the information banner is

displayed. You can now watch digital terrestrial televison.

Table des matières

Autres manuels Grundig Récepteur

Grundig

Grundig STR 6122 Manuel utilisateur

Grundig

Grundig STR 7122 TWIN Manuel utilisateur

Grundig

Grundig 800 MILLENNIUM Manuel utilisateur

Grundig

Grundig YACHT BOY 400 Manuel utilisateur

Grundig

Grundig YACHT BOY 400 Manuel utilisateur

Grundig

Grundig DTR 1560 MICRO Manuel utilisateur

Grundig

Grundig STR 100 microSAT Manuel utilisateur

Grundig

Grundig DCR 1784 CO Manuel utilisateur

Grundig

Grundig STE 1000 Manuel utilisateur

Grundig

Grundig DSR 2410 Manuel utilisateur

Grundig

Grundig DTR 2420 Manuel utilisateur

Grundig

Grundig GUFSAT01SD Manuel utilisateur

Grundig

Grundig YB-P 2000 Manuel utilisateur

Grundig

Grundig XENARO AVR 4300 DD Manuel utilisateur

Grundig

Grundig DSR 3735 CI Manuel utilisateur

Grundig

Grundig STR 611 Manuel utilisateur

Grundig

Grundig STR 7100 Manuel utilisateur

Grundig

Grundig 100 PE Manuel utilisateur

Grundig

Grundig STR 6100 Manuel utilisateur

Grundig

Grundig DTR 1560-2 MICRO Manuel utilisateur

Grundig

Grundig Sinio DTR 6110 S Manuel utilisateur

Grundig

Grundig DTR 1520 Manuel utilisateur

Grundig

Grundig GSS.box DSI 400 Manuel utilisateur

Grundig

Grundig SAT STC 1200 Manuel utilisateur

Manuels Récepteur populaires d'autres marques

Garmin

Garmin GA 23 Manuel utilisateur

Aiphone

Aiphone PS-12F Manuel utilisateur

IMES

IMES TCS-01CA-PMI Manuel utilisateur

BWI Eagle

BWI Eagle AIR-EAGLE SR Manuel

AMIMON

AMIMON AMN12310 WHDI Manuel utilisateur

Dual

Dual DMCPA79BT Mode d'emploi

Sound Associates

Sound Associates SA652P Manuel utilisateur

Sherwood

Sherwood NewCastle R-772 Manuel utilisateur

Audio

Audio A10-RX Series Manuel utilisateur

AllSee

AllSee PushShare PSRV1.1 Manuel utilisateur

DEMAG

DEMAG DRC-DR D2 Manuel utilisateur

Teleco

Teleco TVRCL868A02 Manuel utilisateur

Bosch

Bosch RF3222E Manuel utilisateur

Kramer

Kramer 631R Manuel utilisateur

Xpress

Xpress xmc10 Manuel utilisateur

JVC

JVC KD-MR1BTS Manuel utilisateur

Omega Engineering

Omega Engineering UWTC-REC3 Manuel utilisateur

e-survey

e-survey E300 Pro Manuel utilisateur