General A3G Manuel utilisateur

INSTRUCTION MANUAL

A3G Green Rotary Laser

Please read this instruction manual before operating this product.

Please store this instruction manual in the carry case for future reference.

CAUTION: Class 3 Laser Product

Do not stare directly into the laser beam from apertures.

Do not disassemble the instrument or attempt to perform any internal servicing

as this will void your warranty. No user serviceable parts included.

Only approved and authorised service technicians can carry out warranty repairs.

SAFETY

Please ensure the following items are included with your laser.

If anything is missing please contact your retailer.

ITEM CHECKLIST

Laser glasses Carry case Rechargeable

battery pack

Charger

2x Laser targetsDetector and clampRemote control

General A3G

INCHES CM

90°

SLEEP

45°

10°

180°

Rotating laser port

Protective lighthouse

PRODUCT OVERVIEW

Control panel

90°

45°

10°

180°

CONTROL PANEL

Power

Tilt alarm indicator

Power indicator

Speed control

Counter clockwise rotation

Tilt alarm

Clockwise rotation

Scanning mode

Speed control indicator

DETECTOR CONTROL PANEL

Sound on / off

Coarse / fine mode

LCD display screen

Laser sensor

Speaker

Power

REMOTE CONTROL PANEL

Sleep mode

90°

SLEEP

45°

10°

180°

Counter clockwise rotation

Scanning mode

Clockwise rotation

Speed control

USING YOUR LASER

Power Supply

‣The General A3G is supplied with a rechargeable Ni-MH battery pack that is

located in the base of the unit.

‣It is recommended that the battery pack be completely charged before use.

‣Charging time is approximately 5 hours.

‣Use of the unit over time and changes in temperature may cause increases

or decreases in charging and operation time.

‣The power indicator light will flash when the battery is low. The unit should

be re-charged as soon as possible.

‣To charge the unit insert the charger into the port on the battery pack.

Progress will be shown by the power indicator display on the charger as below:

Red (flashing) = Charger and battery are not connected.

Red (constant) = Battery is charging.

Green (constant) = Battery is charged.

Horizontal Set Up

Vertical Set Up

‣Select a place as close as practical to the work site.

Ensure the location is clear of traffic.

‣Attach the laser to a tripod and place on a level surface.

Ensure the unit is secured correctly and tightened in position.

‣Select a place as close as practical to the work site.

Ensure the location is clear of traffic.

‣Place the laser onto a level surface with the control panel facing upwards.

Operation

‣To turn the unit on press the power button. Self

levelling will commence and the laser will begin to rotate.

‣If the unit is outside the self levelling range the unit will not

level causing the laser beam to flash continuously.

Speed Control

‣Press the speed control button to cycle through various rotational speeds.

‣The speed control indicator will flash slowly when speed is slow and fast

when speed is increased.

Rotation

‣Press the clockwise or counter clockwise button to change the

rotation of the laser head.

Scanning mode

‣To focus the laser beam between two points press the scanning mode

button. Pressing the button multiple times will adjust the angle of the beam.

‣To cancel scan mode press the scanning mode button several times

to cycle through to full rotation.

Table des matières

Autres manuels General Instrument de mesure

General

General LT2234C Manuel utilisateur

General

General MMD8P Manuel utilisateur

General

General MMD7NP Manuel utilisateur

General

General TS01 Manuel utilisateur

General

General XL1 Manuel utilisateur

General

General MM8 Manuel utilisateur

General

General DAMP60 Manuel utilisateur

General

General DSM8925 Manuel utilisateur

General

General MMD4E Manuel utilisateur

General

General GMK-05-MB Manuel utilisateur

General

General MMD900 Manuel utilisateur

General

General TA500 Manuel utilisateur

General

General EP8703 Manuel utilisateur

General

General DSM8930 Manuel utilisateur

General

General DCS1700 Manuel utilisateur

General

General SAF-T-LITE I.S. 300 Mode d’emploi

General

General VOC08 Instructions de montage

General

General DCFM8906 Manuel utilisateur

General

General EMHT40 Manuel utilisateur

General

General MMD4E Manuel utilisateur

General

General RHMG650 Manuel utilisateur

General

General DM8200 Manuel utilisateur

General

General MM1E Manuel utilisateur

General

General DCS1100 Manuel utilisateur

Manuels Instrument de mesure populaires d'autres marques

Suaoki

Suaoki D40 Manuel utilisateur

Elster

Elster BK-G1.6 Manuel utilisateur

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manuel

Duratool

Duratool D03128 Manuel utilisateur

Vega

Vega VEGAPULS 65 Manuel utilisateur

Tonghui

Tonghui TH2618B Manuel utilisateur

Tenmars

Tenmars TM-801 Manuel utilisateur

MSR

MSR 145 Manuel utilisateur

TPS

TPS WP-82 Manuel utilisateur

ELMETRON

ELMETRON CP-511 Manuel utilisateur

PCB Piezotronics

PCB Piezotronics 003C30 Manuel utilisateur

Tenma

Tenma 72-10465 Manuel utilisateur

Endress+Hauser

Endress+Hauser Proline Promag 50 Caractéristiques techniques

Siemens

Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces

KLINGER

KLINGER CMF V Series Manuel utilisateur

EXFO

EXFO FTB-2 Manuel d'exploitation et d'entretien

Keysight

Keysight M8290A Manuel utilisateur

ADTEK

ADTEK MW-5 Manuel utilisateur