Fusion3 EDGE Mode d’emploi
EDGE 3D Printer
MAINTENANCE:
GAINING ACCESS FOR MAINTENANCE &
REPAIR
Revision 5/28/2022
1
GAINING ACCESS FOR MAINTENANCE & REPAIR
How to gain access to all parts of EDGE for maintenance or repair
There are 4 panels that can be opened or removed for service:
1. Main door
2. Top window
3. Rear service panel
4. Electronics bay service panel
It is NOT necessary to remove any additional panels or sheet metal parts from the machine to access
EVERYTHING. All other sheet metal components are major structural components and removing them
may render your machine permanently inoperable unless you return it to Fusion3 for a factory rebuild.
MAIN DOOR
Simply open or close the main door as normal. There is no need to remove the door from the machine.
TOP WINDOW
The top window is held in with magnets so it's easy to remove for service.
1. Open the main door and push the window up from the inside to pop the magnets loose.
2
2. Grab the window with your other hand and remove it from the printer.
To reinstall, simply drop back into place and make sure it sits flush with the outside face of the chassis.
The magnets go out the outside (aka top) face of the window
3
REAR SERVICE PANEL
The rear service panel comprises most of the rear wall of the print chamber.
Position EDGE so that you can access the outside rear face of the unit.
1. Remove the 9 M3x6 SHCS screws and set them aside. Remove the center-top screw last so you can
get your hand under the bottom edge to support it as you remove the last screw.
4
ELECTRONICS BAY SERVICE PANEL
The electronics bay service panel gives access to the electronics of EDGE without removing the electronics
sled from the machine.
WARNING: High voltage components are present inside the electronics bay. You should unplug
the unit from the wall and wait 5-10 min
before opening the electronics bay for
service.
1. Position EDGE so you can access the
outside right face of the unit.
2. Remove the 9 M3x6 SHCS screws and set
them aside. Remove the center-top screw
last so you can get your hand under the
bottom edge to support it as you remove
the last screw.
Related Articles / Resources:
Tags: EDGE, maintenance, repair, access
5
Autres manuels pour EDGE
7
Table des matières
Autres manuels Fusion3 Imprimante 3D
Fusion3
Fusion3 F410 Manuel utilisateur
Fusion3
Fusion3 EDGE Manuel utilisateur
Fusion3
Fusion3 EDGE Guide de configuration
Fusion3
Fusion3 EDGE Mode d’emploi
Fusion3
Fusion3 F410 Manuel utilisateur
Fusion3
Fusion3 EDGE Manuel utilisateur
Fusion3
Fusion3 EDGE Manuel utilisateur
Fusion3
Fusion3 EDGE Mode d'emploi
Fusion3
Fusion3 F400 Manuel d'utilisation
Fusion3
Fusion3 F410 Manuel utilisateur
