版权所有©飞天诚信科技股份有限公司
公司网址： www.FTsafe.com
• Do not immerse, use liquids, sprays or aerosol cleaners. Clean all spillages quickly.
• This device is intended for handheld use only or in an approved cradle/stand.
• Dispose any part in an environmentally sound manner and in accordance with local laws.
•M200 product will not be held liable for any damage resulting from user operation that does not comply
with the above-stated guidance.
Frequency bands and power
• Maximum radio frequency power transmitted in the frequency bands in which this equipment operates
is below the limit values specified in the corresponding Harmonized Standards.
• The frequency bands and power limits applicable to this equipment are: Bluetooth:BLE+BLE4.2 ; NFC:
13.56 MHz, Type A&B、Felica，Mifare card
1.6 FCC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause undesired
operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .This
equipment should be installed and operated with minimum distance 20cm between the radiator& your body.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates,uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
