F&F FW-R1D Manuel utilisateur

F&F Filipowski sp. j.

ul. Konstantynowska 79/81, 95-200 Pabianice

tel./fax (+48 42) 215 23 83 / (+48 42) 227 09 71

www.fif.com.pl; e-mail: fif@fif.com.pl

Do not dispose of this device to thrash with other unsorted waste! In accordan-

ce with the Waste Electrical and Electronic Equipment Act any household electro-wa-

ste can be turned in free of charge and in any quan ty to a collec on point established

for this purpose, as well as to the store in the event of purchasing new equipment (as

per the old for new rule, regardless of brand). Electro-waste thrown in the trash or aban-

doned in the bosom of nature pose a threat to the environment and human health.

Wireless system

- 1 -

Description of the system

F&Wave is a family of wireless devices controlled by radio with a range of up to 100

meters*. The receivers are available in either a DIN-rail mounting version (housing 1S)

or a Ø60 flush-mounted version. The transmitters are available as handheld remo-

te controllers or as a flush-mounted version. The receivers relay control signals. The

device that receives a control signal from the transmitter will automatically send it

forward, which allows to increase the range of the remote control.

* Range of up to 100 meters in open space without any interfering factors. In building conditions and in the presence of

interference sources (power lines, transmitters, etc.) the actual range may be smaller.

FW-R1D

Single bistable relay

- 2 -

Single bistable relay;

Cooperation with remote control transmitters of the F&Wave system;

The ability to control from up to 8 transmitters;

Local control - the ability to directly control the relay using any monostable button

(for example: bell button);

Separated output contact NO with load capacity of 16 A (AC-1);

Compact enclosure - takes only one field in the switchboard;

Retransmission of commands from the transmitter - the ability to increase the

range of the remote control;

Low power consumption - low operating cost;

Built-in electronic thermal protection to prevent damage in case of excessive load

of the relay.

Installation of this device should be carried out by a qualified installer

after reading this manual. Dismantling the casing of the device will au-

tomatically void the warranty. Before starting the assembly, make sure

that the connecting wires are not live. Conditions of storage, transport

and use affect the proper operation of the device.

Features of the module

- 3 -

Control input does not cooperate

with backlighted buttons.

1 - power supply L

3 - power supply N

4 - control input triggered with level L or N

10/12 - output - NO contact

Description of the device

Connection

- 4 -

③Correct pairing will be confirmed by temporary switching off of the output

circuit and the LED will turn on again.

To clear the list of transmitters cooperating with the receiver, press the PROG button and hold it

down for at least 10 seconds. Fast flashing of communication LED will indicate that the memory

of the controller has been cleared.

The receiver can be paired with eight different transmitters (remote but-

tons). Pairing with more buttons will remove the first entries made.

After proper connection, press and hold the PROG but-

ton until the relay will switch on and the communication

LED will go off.

Press the selected button on a remote control or in

a flush-mounted transmitter.

②

①

The actual maximum load depends on the na-

ture and design of the receiver.

For more information visit: www.fif.com.pl.

16 A/250 V (AC-1)

Pairing

Unpairing

Load capacity

- 5 -

Local buttons

Activation of the thermal protection is indicated by a steady pulsing of commu-

nication LED, switching off of the output circuit and the lack of its reactivation

possibility. After lowering the temperature to a safe value the output circuit will

remain switched off until restarted.

We do not recommend the use of remote bistable transmitters to control a

group of receivers due to the possibility of desynchronization of the activation

state (especially when operating on larger distances and/or simultaneous use

of local buttons on the receivers).

Due to the nature of transmission and retransmission do not use the

same button in transmitter more often than every 2 seconds. Switching

of the receiver may be carried out with a short delay.

Short press of a button switches the relay in to the opposite state.

Long press of a button (longer than 5 second) activates the relay regardless of the state, in which

the relay was previously in. This feature can be used for synchronizing a group of receivers con-

nected to the same local button. Releasing the button sets the relay in the off position.

Remote buttons

The FW-RC4, FW-RC10 transmitters operate on the principle of a bistable switch: one

press of a button activates the relay; the second press of button deactivates the relay.

The FW-RC5 transmitter also has separate inputs ON (always ON) and OFF (always

OFF).

- 6 -

Warranty

F&F products are covered by a 24 month warranty from the date of purchase.

The warranty is effective only with a proof of purchase.

Contact your dealer or directly with us.

For more information on the procedure for submitting a warranty claim visit our web-

page: www.fif.com.pl/reklamacje

Technical data

power supply 85÷265 V DC

control input 85÷265 V AC/DC; <1 mA

power consumption

operating mode 0.60 W

standby 0.25 W

output load capacity (AC-1) 16 A/250 V

radio frequency 868 MHz

working temperature -25÷65°C

terminal 2.5 mm² screw terminals

tightening torque (max) 0.4 Nm

mounting TH-35 mm rail

dimensions 1 module (18 mm)

ingress protection IP20

Devices of the F&Wave system

Transmitters Receivers Box Ø60 DIN rail

flush-mounted Single relay FW-R1P FW-R1D

FW-RC5 Double relay FW-R2P FW-R2D

remote controls Universal dimmer FW-D1P FW-D1D

FW-RC4 Roller blind controller FW-STR1P FW-STR1D

FW-RC10 Two-channel LED controller FW-LED2P FW-LED2D

- 7 -FW160415

Compliance with the standards

PN-EN 60669, PN-EN 60950, PN-EN 55024, PN-EN 61000,

PN-ETSI EN 300 220-1, PN-ETSI EN 300 220-2,

PN-ETSI EN 301 489-1, PN-ETSI EN 301 489-3.

CE declaration of conformity is available for download at: www.fif.com.pl.

X-ON Electronics

Largest Supplier of Electrical and Electronic Components

Click to view similar products for Power Management IC Development Tools category:

Click to view products by F&F manufacturer:

Other Similar products are found below :

EVAL6482H-DISC EVAL-AD5522EBUZ EVAL-ADM1060EBZ EVAL-ADM1073MEBZ EVAL-ADM1166TQEBZ EVAL-

ADM1168LQEBZ EVAL-ADM1171EBZ EVAL-ADM1276EBZ EVB-EN5319QI EVB-EN5365QI EVB-EN6347QI EVB-EP5348UI

MIC23158YML EV MIC23451-AAAYFL EV MIC5281YMME EV 124352-HMC860LP3E ADM00513 ADM8611-EVALZ ADM8612-

EVALZ ADM8613-EVALZ ADM8615-EVALZ ADP1046ADC1-EVALZ ADP1055-EVALZ ADP122-3.3-EVALZ ADP130-0.8-EVALZ

ADP130-1.2-EVALZ ADP130-1.5-EVALZ ADP130-1.8-EVALZ ADP160UJZ-REDYKIT ADP166UJ-EVALZ ADP1712-3.3-EVALZ

ADP1714-3.3-EVALZ ADP1715-3.3-EVALZ ADP1716-2.5-EVALZ ADP1740-1.5-EVALZ ADP1752-1.5-EVALZ ADP1754-1.5-EVALZ

ADP1828LC-EVALZ ADP1870-0.3-EVALZ ADP1871-0.6-EVALZ ADP1873-0.6-EVALZ ADP1874-0.3-EVALZ ADP1876-EVALZ

ADP1879-1.0-EVALZ ADP1882-1.0-EVALZ ADP1883-0.6-EVALZ ADP197CB-EVALZ ADP199CB-EVALZ ADP2102-1.25-EVALZ

ADP2102-1.2-EVALZ

Table des matières

Autres manuels F&F Relais

Manuels Relais populaires d'autres marques

Shelly

Shelly Pro Series Manuel utilisateur

GE MVAX 11 Manuel utilisateur

ABB

ABB RELION REF615R Manuel utilisateur

Pilz

Pilz PNOZ X10 Manuel du propriétaire

ABB

ABB SPAJ 142 C Manuel de la liste des pièces

Kemo Electronic

Kemo Electronic B197 Manuel utilisateur

Seg

Seg MRM3 Manuel utilisateur

Basler

Basler BE1-700C Manuel utilisateur

CD Automation

CD Automation REVEX 2PH 280A Manuel utilisateur

Ruelco

Ruelco 1S04 Manuel utilisateur

Basler

Basler V3E Z1P B2C1F Manuel utilisateur

Doepke

Doepke Dupline DSM 2 Manuel utilisateur

Siemens

Siemens SIRIUS 3RT1966-4D Manuel utilisateur

GE DGP Manuel utilisateur

Kyongbo Electronics

Kyongbo Electronics GDR-D01 Manuel utilisateur

Siemens

Siemens SIPROTEC 4 Manuel utilisateur

Siemens

Siemens BD2-AK03X/FS Series Manuel utilisateur

Leuze

Leuze MSI-SR5B Manuel utilisateur