Extron electronics SW HDMI Series Manuel utilisateur

Product Category

SW HDMI Series • Setup Guide

The Extron SW HDMI Series are two and four input, one output, High-deﬁnition Multimedia Interface (HDMI) switchers that

allow multiple HDMI signals, including digital video, 3D signals, and embedded multi-channel digital audio to be switched

to one compatible display. These switchers support all standard single link HDMI (up to 225 MHz) and DVI 1.0 signal formats

and are compatible, at 60 Hz, with all HDTV resolutions up to 1080p and PC resolutions up to 1920x1200, with 12-bit color.

They are fully HDCP compliant. This guide provides basic instructions for an experienced installer to set up and operate

these switchers.

NOTE: For full installation, conﬁguration, and operation details, see the SW HDMI Series User Guide, available at

www.extron.com.

Rear Panel Features and Connections

0.3A MAX

POWER

12V1

Tx Rx

RS-232 AUTO

234

INPUTS OUTPUT REMOTE

aPower connector for 12 VDC, 1 A power supply bHDMI input connectors

cHDMI output connector dRemote and auto-input switching connector

Installation Steps

1. Turn off all of the equipment and disconnect it from the power source.

2. (Optional) Mount the switcher on a rack shelf or furniture.

3. Connect HDMI input sources to one or more of the SW HDMI input connectors (bon the rear panel diagram above).

NOTE: LockIt®cable lacing brackets, one for each HDMI input and output connector, are provided with the

SW HDMI. These brackets can be used to secure the HDMI cables to the rear panel connectors to reduce

stress on the HDMI connectors and prevent signal loss due to loose cable connections. For information on

attaching the LockIt brackets, see the LockIt HDMI Lacing Bracket Installation Guide card, available on the

Extron website at www.extron.com.

HDMI

Type A Receptacle

18 2

HDMI

Type A Plug

182

Pin Signal Pin Signal Pin Signal

1 TMDS data 2+ 7 TMDS data 0+ 13 CEC*

2 TMDS data 2 8 TMDS data 0 14 Reserved (NC)

shield shield

3 TMDS data 2– 9 TMDS data 0– 15 SCL

4 TMDS data 1+ 10 TMDS clock+ 16 SDA

5 TMDS data 1 11 TMDS clock 17 DDC/CEC

shield shield ground

6 TMDS data 1– 12 TMDS clock– 18 +5 V power

19 Hot plug

detect

*Not supported

4. Connect an HDMI output device to the output connector (c).

68-1317-50 Rev. B

02 12

Extron Headquarters

+1.800.633.9876 (Inside USA/Canada Only)

Extron USA - West Extron USA - East

+1.714.491.1500 +1.919.863.1794

+1.714.491.1517 FAX +1.919.863.1797 FAX

Extron Europe

+800.3987.6673

(Inside Europe Only)

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

(Inside Asia Only)

+65.6383.4400

+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron China

+4000.398766

Inside China Only

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.2991800

+971.4.2991880 FAX

Extron Korea

+82.2.3444.1571

+82.2.3444.1575 FAX

Extron India

1800.3070.3777

Inside India Only

+91-80-3055.3777

+91 80 3055 3737

FAX

5. Connect control devices: Connect your computer to one of

the following SW HDMI communication ports to conﬁgure and

control the switcher via SIS commands or the Universal Switcher

Control Program:

zRS-232 port — Connect the unterminated transmit,

receive, and ground wires of the RS-232 cable to the ﬁrst

three pins on the provided 5-pole captive screw plug, as

shown in the illustration at right. Connect the plug to the

rear panel Remote shared connector (don the rear panel

diagram on the previous page), and the other end of the

cable to your computer serial port. Protocol for the RS-232

port is 9600 baud, 8 data bits, 1 stop bit, no parity.

zCong port — USB mini-B connector (fon the front

panel diagram, below) for USB control.

6. (Optional) Enable auto-input switching. Use a jumper wire to connect pins 4 and 5

of the shared 5-pole captive screw plug. Attach the plug to the Remote

connector (don the rear panel diagram) if this was not done in

step 5for the RS-232 connection (see the illustrations at right).

7. If necessary, wire a 2-pole captive screw connector (provided) to your Extron power

supply as shown below.

Captive Screw Connector

Tie Wrap

Heat

Shrink 1/8”

(3 mm)

7/8”

(22 mm)

3/16”

(5 mm) Max.

CAUTIONS: • Thepowersupplymustnotbepermanentlyxedtothebuildingstructureorsimilarstructures.

•The power supply must not be located within environmental air handling spaces or the wall cavity.

8. Power on the output display.

9. Connect power to the switcher.

10. Power on the source devices.

Front Panel Features

SW4 HDMI

HDMI SWITCHER

CONFIG

SIGNAL

INPUTS

INPUTS OUTPUT

1 2 3 4

HDCP

2 3 4

AUTO

SWITCH

aAuto Switch LED cInput Selection buttons eHDCP Status LEDs

bIR receiver port dInput LEDs fUSB Conﬁg port

0.3A MAX

POWER

12V

Tx Rx

RS-232 AUTO

INPUTS

OUTPUT REMOTE

RS-232 Auto

Computer or

Contr

ol System

RS-232 Port

SW HDMI Series Switcher

Rear Panel

Remote Port

NOTE: If you use cable that has a drain

wire, tie the drain wire to ground

at both ends.

Tx Rx G

Ground (G)

Transmit (Tx)

Receive (Rx) Transmit (Tx)

Receive (Rx)

Autres manuels pour SW HDMI Series

Table des matières

Autres manuels Extron electronics Changer

Extron electronics

Extron electronics System 4LQ xi Manuel utilisateur

Extron electronics

Extron electronics SVS 100 Manuel utilisateur

Extron electronics

Extron electronics SW4 ARxi Manuel utilisateur

Extron electronics

Extron electronics SW4 ARxi Manuel utilisateur

Extron electronics

Extron electronics SW2 VGAxi Manuel utilisateur

Extron electronics

Extron electronics USB HUB4 AAP Manuel utilisateur

Extron electronics

Extron electronics A-3 Manuel utilisateur

Extron electronics

Extron electronics SW USB Pro Series Manuel utilisateur

Extron electronics

Extron electronics SW2 VGA Ars Manuel utilisateur

Extron electronics

Extron electronics in1608 series Manuel utilisateur

Extron electronics

Extron electronics RGB 580xi AAP Series Manuel utilisateur

Extron electronics

Extron electronics mediaport 200 Manuel utilisateur

Extron electronics

Extron electronics TeamWork 601 Manuel utilisateur

Extron electronics

Extron electronics System 8 Plus Manuel utilisateur

Extron electronics

Extron electronics Andora Manuel utilisateur

Extron electronics

Extron electronics PVS 405D Manuel utilisateur

Extron electronics

Extron electronics MPS 601 Manuel utilisateur

Extron electronics

Extron electronics DTP T USW 333 Manuel utilisateur

Extron electronics

Extron electronics XTP T USW 103 Manuel utilisateur

Extron electronics

Extron electronics VEGA AUDIO SW6 Manuel utilisateur

Extron electronics

Extron electronics Extron SW 2 VGAcc Manuel utilisateur

Extron electronics

Extron electronics ISS 408 Manuel utilisateur

Extron electronics

Extron electronics SW2 MTP T 15HD A Manuel utilisateur

Extron electronics

Extron electronics MSW 4SV rs Manuel utilisateur

Manuels Changer populaires d'autres marques

URC

URC Total Control MFS-8 Manuel utilisateur

Azbil

Azbil HPQ-D11 Manuel utilisateur

Sony

Sony DFS-900M Manuel utilisateur

SICK

SICK i17S Manuel utilisateur

F&F

F&F SZR-277 Manuel utilisateur

Shure

Shure UAMS/BK Manuel utilisateur

Dräger

Dräger X-zone Switch Off Manuel utilisateur

Asco

Asco Joucomatic 349 Series Manuel utilisateur

BT Mini Hub Manuel utilisateur

D-Link

D-Link DES-1226G Manuel utilisateur

Johnson Controls

Johnson Controls FS80-C Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuel utilisateur

MicroNet

MicroNet SP1200A Manuel utilisateur

Ruijie

Ruijie RG-PF2920 Series Manuel d'installation et d'exploitation

Altinex

Altinex DA1914SX Manuel utilisateur

MiLAN

MiLAN MIL-SM2401M Manuel utilisateur

RJM

RJM MASTERMIND PBC/6X Manuel utilisateur

Atlas

Atlas MMK-KVM8 Manuel utilisateur