Extron electronics AAP 100 Manuel utilisateur

1-1AAP 100 and MAAP 100 • Installation Guide

Extron AAP 100 and MAAP 100 Installation Guide

Installing the AAP 100 and MAAP 100

The following procedure is for mounting the AAP 100 and MAAP 100 panels on

hard surfaces (plywood, hardwood, etc.). For soft surfaces (particle board, drywall,

etc.), additional hardware such as anchors may be required (not provided).

1. Photocopy the appropriate full size rough-in template from the other side of

this page. Cut out the center portion of the template up to the dashed

guidelines.

CAUTION

Be sure to photocopy the template at exactly 100%. Using a template that

has been altered will cause you to cut an opening of the wrong size and

may result in permanent damage to the surface.

2. Place the template copy in the desired location on the installation surface.

Use a soft pencil to mark the guidelines for the opening on the surface.

3. Use a jigsaw or small hand saw to carefully cut away the material within the

guidelines. Check the opening size by placing the panel against the opening.

If needed, use a saw, file, or sandpaper to enlarge the opening.

4. Cable the AAP(s)/MAAP(s) and install them on the panel.

5. Place the panel against the surface so that the AAP(s)/MAAP(s) fit into the

opening. Mark the locations of the two wall mounting holes on the surface.

6. If desired, remove the panel and drill ¼" deep pilot holes (half the width of

the shaft of the screw) at the marked locations. Replace the panel.

7. Use two ½" (1.3 cm) long, #6 flat headed wood screws (provided) to fasten

the panel directly onto the surface. Hand tighten the screws.

Product Dimensions

0.000

0.250

3.000

3.250

1.750

2 x 0.875

0.000

0.100

1.750

2 x 0.875

0.000

0.250

4.250

4.500

0.000

0.100

68-837-01 Rev. A

Printed in the USA

05 03

AAP 100

MAAP 100

im Vertrieb von

CAMBOARD Electronics

www.camboard.de

Tel. 07131 911201

Fax 07131 911203

[email protected]

Installation Guide, cont’d

AAP 100 and MAAP 100 • Installation Guide1-2

Installation Templates

Template for

the MAAP 100

Template for

the AAP 100

The dashed line indicates the

recommended cut-out area

for the installation surface.

1.5" H x 2.25" W

(3.8 cm H x 5.7 cm W)

The solid, outer line

represents the outside

edge of the panel.

1.75

H x 3.25

(4.45 cm H x 8.25 cm W)

Template for

the MAAP 100

The dashed line indicates the

recommended cut-out area

for the installation surface.

1.5" H x 3.5" W

(3.8 cm H x 8.9 cm W)

The solid, outer line

represents the outside

edge of the panel.

1.75" H x 4.5" W

(4.45 cm H x 11.4 cm W)

Template for

the AAP 100

Extron Electronics, USA

1230 South Lewis Street

Anaheim, CA 92805

USA

714.491.1500

Fax 714.491.1517

Extron Electronics, Europe

Beeldschermweg 6C

3821 AH Amersfoort

The Netherlands

+31.33.453.4040

Fax +31.33.453.4050

Extron Electronics, Asia

135 Joo Seng Road, #04-01

PM Industrial Building

Singapore 368363

+65.6383.4400

Fax +65.6383.4664

Extron Electronics, Japan

Daisan DMJ Building 6F

3-9-1 Kudan Minami

Chiyoda-ku,Tokyo 102-0074 Japan

+81.3.3511.7655

Fax +81.3.3511.7656

www.extron.com

im Vertrieb von

CAMBOARD Electronics

www.camboard.de

Tel. 07131 911201

Fax 07131 911203

[email protected]

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Extron electronics Panneau de contrôle

Extron electronics

Extron electronics ACP 106 D Manuel utilisateur

Extron electronics

Extron electronics ACP 100 Manuel utilisateur

Extron electronics

Extron electronics TLP Pro 320C Manuel utilisateur

Extron electronics

Extron electronics eBUS Button Panel EU Series Manuel utilisateur

Extron electronics

Extron electronics MKP 2000 Manuel utilisateur

Extron electronics

Extron electronics SCP 200 Manuel utilisateur

Extron electronics

Extron electronics RCP 2000 Manuel utilisateur

Extron electronics

Extron electronics SCP 104 Series Manuel utilisateur

Extron electronics

Extron electronics eBUS Button Panel Decorator-Style Series Manuel utilisateur

Extron electronics

Extron electronics TLP Pro x25M Series Manuel utilisateur

Extron electronics

Extron electronics SCP 150L Manuel utilisateur

Extron electronics

Extron electronics SCP 100P Manuel utilisateur

Extron electronics

Extron electronics MCP 1000 Manuel utilisateur

Extron electronics

Extron electronics RCP 2000 Manuel utilisateur

Extron electronics

Extron electronics TouchLink Pro Series Manuel utilisateur

Extron electronics

Extron electronics MKP 3000 Manuel utilisateur

Extron electronics

Extron electronics IPCP Pro Series Manuel utilisateur

Extron electronics

Extron electronics TLP Pro 320C Manuel utilisateur

Extron electronics

Extron electronics ACP 105 EU/MK Manuel utilisateur

Extron electronics

Extron electronics SCP 250 Manuel utilisateur

Extron electronics

Extron electronics CTP150CM Manuel utilisateur

Extron electronics

Extron electronics MCP 1000 Manuel utilisateur

Extron electronics

Extron electronics ACP VCI EU/MK Manuel utilisateur

Extron electronics

Extron electronics ACP 100 Manuel utilisateur

Manuels Panneau de contrôle populaires d'autres marques

RDZ

RDZ PC-HRX Manuel utilisateur

STG-BEIKIRCH

STG-BEIKIRCH MZ3 Manuel technique

Efka

Efka Variocontrol V810 Manuel utilisateur

Cebora

Cebora 208-10 Manuel utilisateur

AMX

AMX AutoPatch CP-15 Manuel utilisateur

Satel

Satel CA-6 KLED-S Manuel utilisateur

Evolution

Evolution IQ plus 800 Manuel utilisateur

Fagor

Fagor 8040 TCO CNC Manuel utilisateur

Trane

Trane ComfortLink II XL950 Control Manuel utilisateur

AKO

AKO PROCool AKO-17635-2 Manuel utilisateur

ABB

ABB 6136/30M-101 Manuel utilisateur

Telikou

Telikou BK-603 Belt Pack Manuel utilisateur

Mapei

Mapei Mapeheat Thermo Touch Manuel utilisateur

Bosch

Bosch D9412GV4 Manuel utilisateur

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries SC-SL4-AE2/1 Manuel utilisateur

Sminn

Sminn BOX L VF1L EI Manuel utilisateur

Balboa

Balboa TP600 Manuel utilisateur

Nice

Nice HSCU1 Caractéristiques techniques